SIG SAUER STL-900L User Manual

STL-900 TacTicaL LighT & LaSer
Tactical Gear Redefined
STL-900 TACTICAL LIGHT & LASER
The Tactical Light & Laser is a compact, lightweight solution for providing pistols and rifles with a high powered beam (steady or disorienting strobe light), incorporating a pinpoint red laser adjustable for windage and elevation. This tiny powerhouse packs a genuine 130 lumen* CREE LED in a quick mount design.
FEATURES
n
Momentary, constant on, and strobe (laser is independent)
n
Convenient side access battery compartment
n
Self-storing Allen key for windage & elevation adjustment
n
Easy rail attachment
n
(1) 3V CR123A lithium battery
TM
OWNER’S MANUAL
CONTENTS
n
STL-900 Tactical Light & Laser n Owner’s Manual n (1) 3V CR123A Lithium Battery
n
Allen Key
Strobe mode Button
Red Laser on/off Button
White Cree LED
Red Laser
Elevation and Windage Adjustment
INSTRUCTIONS
Install battery:
n
Unscrew battery hatch
n
Position battery + facing forward
n
Close hatch, tighten screw
Note: This product features digital power management. When battery power drops below a preset level, the unit shuts down to protect the internal circuitry and prevent a battery overheating condition. If this occurs, the battery needs replacement.
Mounting on firearm:
n
Loosen locking shaft.
n
Position right rail of light on gun rail, and roll light into place, with locking shaft resting in notch of gun rail.
n
Tighten locking shaft securely.
Getting Started:
n
Select steady or strobe modes using side button.
n
Steady/Strobe light mode button
IMPORTANT
n
Light must be ON to select or change
modes.
n
Last selected mode is retained until
changed.
n
Laser functions independently of either light mode. Press red side button to turn on/off.
n
Laser mode
n
For momentary operation of selected light mode, partially depress and hold left or right button on rear. For steady operation, fully press and release left or right button on rear.
n
To adjust laser windage or elevation, adjust screws with coin or screwdriver. Clockwise moves dot left/down; counter­ clockwise moves dot right/up.
Note: Align the laser to point parallel with the bore of the gun, providing consistent offset targeting, regardless of range.
SPECIFICATIONS: STL-900 TACTICAL LIGHT & LASER
Interface
Dimensions
Weight empty
Weight w/batteries
Light type
Power
Light switching
Light modes
Strobe frequency
Visible Laser
Laser switching
M1913 and compatible
3.2”L x 1.7”W x 1.6”H
3.4 oz / 97 g
4 oz / 113 g
Hi Output LED
130 Lumens peak*
Steady on/off; momentary on/off
Constant; Strobe
18-20 cycles per second
Hi Visibility (650nm), Class IIIa, Red
Independent on/off
Laser modes
Battery
Power management
Run time
*Lumens based on LED manufacturers specifications
Laser Information
Laser Type: Class IIIa visible laser diode Peak Power: <5mW Wavelength: 650nm Beam Color: Red
This product conforms with 21 CFR 1040.10.
WARNING: Do not point the laser beam at eyes. Permanent eye damage can result. See attached warning label -
WARNINGS
Before handling any firearm with the PRODUCT attached, read and understand the entire contents of your firearms manual (especially the safety precautions and procedures for safe firearms handling) and the PRODUCT manual. Failure to follow safety precautions when handling a firearm with the PRODUCT attached can result in damage to property, serious injury, or death. Once the PRODUCT is attached to the firearm, the firearm will be pointed at anything the PRODUCT is directed at. Do not point the PRODUCT at anything or anyone that you do not intend to shoot. The ON / OFF switch on the PRODUCT allows operation of the laser without placing your finger inside the firearm trigger guard. Always keep your fingers off the trigger and outside the trigger guard until you are ready to fire the weapon. Always verify the weapon is free of ammunition and the chamber clear per the weapon’s operators manual before attempting to mount or dismount the PRODUCT on the weapon. Always dismount the PRODUCT from the weapon when performing maintenance, cleaning the PRODUCT, and when replacing batteries. Never place your hand in front of the weapon muzzle when adjusting the PRODUCT. Do not operate the PRODUCT around cleaning solvents or flammable/combustible materials, in environments involving gasses or a flammable atmosphere, or in areas where gasoline, paints, solvents, or other flammable liquids are stored. When the laser dims or fails to illuminate, change batteries. Follow battery manufacturers’ instructions for the proper handling, storage, and disposal of batteries. Do not store the PRODUCT with batteries installed.
Stand-alone; with white light (constant & strobe)
(1) CR123A Lithium
Digital integrated circuit
80 Minutes peak (continuous operation)
BATTERY HAZARD WARNING
Battery manufacturers warn against mixing new and used batteries or different brand batteries together as this may increase the risk of leakage, fire or explosion. Do not, puncture, short-circuit, disassemble or heat batteries above 212°F (100°C). Do not recharge the batteries unless they are specifically designed as rechargeable batteries and then only in accordance with manufacturer’s directions. Lithium Batteries: Industry wide there have been reported incidents of off-brand Lithium batteries exploding or catching fire creating serious consequences. SIGTac includes batteries from Duracell® and other well-known battery manufacturers with its products, and strongly urges you to only purchase replacement batteries from Duracell®, or other well-known battery manufacturers like Panasonic® and Rayovac®. These batteries are designed for use in high performance, high-drain devices, and their designs incorporate fault and heat protection for added safety. Use of inferior batteries may cause an explosion or fire, creating risk of damage to your device that will void the SIGTac warranty, cause damage to other property, and potentially serious injury or death.
STATEMENT OF LIABILITY
This device is classified as a FIREARMS ACCESSORY and is sold by us with the specific understanding that we are not responsible in any manner whatsoever for its safe handling or resale under local laws and regulations. SIGTAC shall not be responsible in any manner whatsoever for malfunctioning of the firearm, for physical injury or for property damage resulting in whole or in part from (1) criminal or negligent discharge, (2) improper or careless handling, (3) unauthorized modifications, (4) defective, improper, hand-loaded, or reloaded ammunition, (5) corrosion, (6) neglect, or (7) other influences beyond our direct and immediate control. This limitation applies regardless of whether liability is asserted on the basis of contract, negligence or strict liability (including any failure to warn). Under no circumstances shall SIGTac be liable for incidental or consequential damages, such as loss of use of property, commercial loss and loss of earnings or profits.
WARRANTY STATEMENT
SIGTac warrants that our sight and illumination tool products are free from defect in parts and workmanship for a period of ninety (90) days from original date of purchase. At our discretion, we will repair, replace, or refund your original purchase price of this product if it is determined to be defective. Normal wear and tear, including lamps burning out, batteries draining, and switches wearing out, is not covered, nor is damage resulting from abuse, neglect, battery leakage, or altering this product from its original state.
CONTACT
18 Industrial Drive, Exeter, NH 03833 (603) 772-2302 ext. 3 www.sigtac.com
P/N 8500914 REV 01
Loading...