SIG SAUER P290 User Manual

290-ILM INTEGRATED LASER MODULE

OWNER’S MANUAL

290-ILM INTEGRATED LASER MODULE

The 290-ILM Integrated Laser Module is a compact, lightweight pistol mounted red laser used for targeting. The 290-ILM Integrated Laser Module provides pinpoint accuracy and rapid target acquisition with intuitive operation in a form ﬁ tting package that weighs only 0.8 oz with battery.

FEATURES

• Ambidextrous on / off switches

• Compact form factor

• Windage & elevation adjustments

• Form-ﬁ tting quick detach mount

Elevation adjustment

Laser

FRONT BACK

Windage adjustment

Battery cover screw

BOTTOM TOP

On / Off switch

INSTRUCTIONS

Install Battery

1. Remove battery cover

2. Install battery as shown, + facing up

3. Install battery cover

Integrated Laser Module Installation

1. Remove the slide assembly

2. Remove the laser plug from the frame.

CONTENTS

1 290-ILM Integrated Laser Module

2. Instructions

3. 3V CR1/3N Lithium Battery

4. 1.5 mm allen key

(windage & elevation adjustment)

Laser key

Windage adjustment

On / Off switch

Battery cover

Operation

• momentarily depress on/off switch to activate laser

• momentarily depress on/off switch to turn off laser

• Switching operates from either side

Laser Adjustment

• Use allen key to adjust windage or elevation

• Clockwise moves dot left / down

3. Seat the integrated laser module against the frame and trigger guard. Ensure the laser key protrudes through the laser key hole in the frame.

4. Using a small screwdriver, turn the laser key ¼ turn to the left until secure.

5. Reassemble the pistol

• Counterclockwise moves dot right / up

Integrated Laser Module Removal

1. Remove the slide assembly

2. Using a small screwdriver, turn the laser

key ¼ turn to the right until aligned with the frame laser key hole.

3. Remove the integrated laser module from

the pistol.

4. Install the laser plug into the frame (not

required for pistol function)

5. Reassemble the pistol

SPECIFICATIONS: 290-ILM INTEGRATED LASER MODULE

Dimensions

Weight w/batteries

Visible Laser

Laser switching

Battery

Battery Life

Power management

1.8” L x 0.8” W x 0.9” H

0.8 oz / 23 g

Hi Visibility (635nm), Class IIIa, Red

Steady on/off

CR1/3N Lithium or equivalent

2 hours steady operation (approx.)

Digital integrated circuit

*Lumens based on LED manufacturers speciﬁcations

Laser Information

Laser Type: Class IIIa visible laser diode Peak Power: 3mW Wavelength: 635nm Beam Color: Red

This product conforms with 21 CFR 1040.10.

WARNING: Do not point the laser beam at eyes. Permanent eye damage can result. See attached warning label -

WARNINGS

Before handling any ﬁrearm with the PRODUCT attached, read and understand the entire contents of your ﬁrearms manual (especially the safety precautions and procedures for safe ﬁrearms handling) and the PRODUCT manual. Failure to follow safety precautions when handling a ﬁrearm with the PRODUCT attached can result in damage to property, serious injury, or death. Once the PRODUCT is attached to the ﬁrearm, the ﬁrearm will be pointed at anything the PRODUCT is directed at. Do not point the PRODUCT at anything or anyone that you do not intend to shoot.

The ON / OFF switch on the PRODUCT allows operation of the laser without placing your ﬁnger inside the ﬁrearm trigger guard. Always keep your ﬁngers off the trigger and outside the trigger guard until you are ready to ﬁre the weapon. Always verify the weapon is free of ammunition and the chamber clear per the weapon’s operators manual before attempting to mount or dismount the PRODUCT on the weapon. Always dismount the PRODUCT from the weapon when performing maintenance, cleaning the PRODUCT, and when replacing batteries. Never place your hand in front of the weapon muzzle when adjusting the PRODUCT.

Do not operate the PRODUCT around cleaning solvents or ﬂammable/combustible materials, in environments involving gasses or a ﬂammable atmosphere, or in areas where gasoline, paints, solvents, or other ﬂammable liquids are stored.

When the laser dims or fails to illuminate, change batteries. Follow battery manufacturers’ instructions for the proper handling, storage, and disposal of batteries. Do not store the PRODUCT with batteries installed.

BATTERY HAZARD WARNING

Battery manufacturers warn against mixing new and used batteries or different brand batteries together as this may increase the risk of leakage, ﬁre or explosion. Do not, puncture, short-circuit, disassemble or heat batteries above 212°F (100°C). Do not recharge the batteries unless they are speciﬁcally designed as rechargeable batteries and then only in accordance with manufacturer’s directions.

Lithium Batteries: Industry wide there have been reported incidents of off-brand Lithium batteries exploding or catching ﬁre creating serious consequences. Sig Sauer, Inc. includes batteries from Duracell® and other well-known battery manufacturers with its products, and strongly urges you to only purchase replacement batteries from Duracell®, or other well-known battery manufacturers like Panasonic® and Rayovac®. These batteries are designed for use in high performance, high-drain devices, and their designs incorporate fault and heat protection for added safety. Use of inferior batteries may cause an explosion or ﬁre, creating risk of damage to your device that will void the SIG Sauer Inc. warranty, cause damage to other property, and potentially serious injury or death.

STATEMENT OF LIABILITY

This device is classiﬁed as a FIREARMS ACCESSORY and is sold by us with the speciﬁc understanding that we are not responsible in any manner whatsoever for its safe handling or resale under local laws and regulations. SIG SAUER lnc. shall not be responsible in any manner whatsoever for malfunctioning of the ﬁrearm, for physical injury or for property damage resulting in whole or in part from (I) criminal or negligent discharge, (2) improper or careless handling, (3) unauthorized modiﬁcations, (4) defective, improper, hand-loaded, or reloaded ammunition, (5) corrosion, (6) neglect, or (7) other inﬂuences beyond our direct and immediate control. This limitation applies regardless of whether liability is asserted on the basis of contract, negligence or strict liability (including any failure to warn). Under no circumstances shall SIG SAUER Inc. be liable for incidental or consequential damages, such as loss of use of property, commercial loss and loss of earnings or proﬁts.

SIG SAUER® LIMITED ONE YEAR WARRANTY

SIG SAUER® warrants that the enclosed accessory was originally manufactured free of defects in material, workmanship and mechanical function, and agrees to correct these defects by repair, adjustment or replacement, at the option of SIG SAUER, with items of the same or comparable quality; provided, however, that the accessory is returned freight prepaid to SIG SAUER at 18 Industrial Drive, Exeter, NH 03833 by the original purchaser within one year of the date of purchase.

This limited warranty is null and void if the accessory has been misused, damaged (by accident or otherwise), or if unauthorized repair or any alteration, including of a cosmetic nature, has been performed on the accessory. This limited warranty does not apply to normal wear and tear of any parts.

Subject to the foregoing, this limited warranty confers the right to have the covered accessory or its parts repaired, adjusted or replaced exclusively by the original purchaser, which right is not transferable to any other person. NO IMPLIED WARRANTIES OF ANY KIND, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE MADE HEREIN, and this warranty does not apply to any accessory items attached or appurtenant to this accessory. In no event shall SIG SAUER be liable for incidental or consequential damages arising from or in connection with this limited warranty.

CONTACT

18 Industrial Drive, Exeter, NH 03833 (603) 772-2302 • www.sigsauer.com

P/N: 1100094 REV B