SIG SAUER G-LAD User Manual
G-LAD TACTICAL GREEN LASER
OWNER’S MANUAL
G-LAD TACTICAL GREEN LASER
The rugged answer to accurate moving or stationery target acquisition, day or night, the G-LAD Tactical
Green Laser produces a visible green laser beam visible 60 yards during true daylight, and 1 mile at
night. 20 times brighter than red laser lights, this easily mounted laser produces a target dot smaller
than 2” at 100 yards. An anodized aircraft aluminum housing delivers unfailing performance under any
weather conditions.
FEATURES
• 532nm green laser beam at 1 mile nighttime range
• 20 times brighter than red laser sights. visible in broad daylight
• Constant on/off switch and remote momentary on/off pressure switch
• Durable aluminum housing with hard anodized nish
• Powered by one CR123A battery that provides 4 hours continuous use
CONTENTS
1. G-LAD Tactical Green Laser 2. Remote momentary on/off pressure switch
3. M1913 accessory rail mount 4. 3V CR123A Lithium Battery 5. Allen key
Elevation Adjustment
Turret
Green Laser
M1913 Accessory
Rail Mount
Remote Momentary
on/off Pressure
Switch
Allen key
Windage
Adjustment Turret
Constant
on/off
Pressure
Switch
Back cover
3V CR123A
Lithium Battery
INSTRUCTIONS
Install battery:
• Unscrew cover at rear of sight.
• Insert battery + facing upwards.
• Tightly screw on cover
Mounting on fi rearm:
• Mount attaches to standard M1913 accessory
rail with standard Philips screwdriver. Make
sure the mount is securely attached to rail
before inserting laser through ring for use.
Getting started:
For constant on/off use:
• Unscrew back cover (battery compartment),
and remove the remote momentary on/
off pressure switch by pushing through the
threaded cover.
• Install the constant switch/back through
threaded cover, then screw entire rear cover
assembly back on, with battery in place.
• Green laser stays on with one push of rear
button, and shuts off with second push.
For momentary on/off use:
• Replace the constant on/off switch piece with
the remote corded pressure switch, making
sure corded wire extends out of the threaded
rear cover piece. Screw entire assembly back
on, holding battery in place.
• Squeeze remote switch pad at end of cord and
hold for laser to switch on and hold for as long
as you would like laser on. Releasing the pad
turns off the laser.
Adjusting windage and elevation:
• Adjust windage and elevation by removing the
turret covers and using a coin to align the main
laser spot to overlap with the scattered points. 1
click = 1.3 inch (33m) @ 50 yds. Once adjusted,
replace covers and tighten by hand.
IMPORTANT
• If the laser light is to be stored for a long period
of time (2 months or more) please remove
batteries from the laser tube to prevent
corrosion.
SPECIFICATIONS: G-LAD TACTICAL GREEN LASER
Interface M1913 and compatible or handheld
Dimensions 4.7”L x 1.2” Diameter head & 1.0” Diameter tube
Material Aluminum 6061 T6, black anodize nish
Weight empty 5.2 oz /147 g
Weight w/batteries
& mount
Light source Hi Visibility Green Laser (day & night)
Power 5mW
Laser switching Pressure switch; cap & removable 10 inch cable
Range 1 mile (night)
Windage & elevation
adjustment
Range of adjustment 30 feet @ 100 yards
Laser dot size < 1.75 inches @ 100 yards
7.3 oz /207 g
1 click = 1.3 inch (33 m) @ 50 yds
Battery (1) CR123A Lithium
Battery life 4 hours constant “ON” (approx)
Temperature range 14 to 104 F (‘-10 to +40 C)
Laser Information
Laser Type:
Class IIIa
Peak Power: 5mW CW
Wavelength: 532nm
Beam Color: Green
This product conforms with 21 CFR 1040.10.
WARNING: Do not point the laser beam at eyes. Permanent eye damage can result.
See attached warning label -
5mW CW
532nm
WARNINGS
Before handling any rearm with the PRODUCT attached, read and understand the entire contents of your rearms manual
(especially the safety precautions and procedures for safe rearms handling) and the PRODUCT manual. Failure to follow
safety precautions when handling a rearm with the PRODUCT attached can result in damage to property, serious injury, or
death. Once the PRODUCT is attached to the rearm, the rearm will be pointed at anything the PRODUCT is directed at. Do
not point the PRODUCT at anything or anyone that you do not intend to shoot.
The PRODUCT is designed to produce a sufcient amount of light to illuminate and identify an object or person in a low light
environment without having to point the PRODUCT - and the attached rearms - directly at that object or person. The light
from the PRODUCT can be pointed in a safe direction at a oor, wall or ceiling and “bounced” onto the darkened silhouette for
identication purposes, avoiding the need to point the rearm directly at an individual.
The ON / OFF switch on the PRODUCT allows operation of the light without placing your nger inside the rearm trigger
guard. Always keep your ngers off the trigger and outside the trigger guard until you are ready to e the weapon. Always verify
the weapon is free of ammunition and the chamber clear per the weapon’s operators manual before attempting to mount
or dismount the PRODUCT on the weapon. Always dismount the PRODUCT from the weapon when performing maintenance,
cleaning the PRODUCT, and when replacing batteries. Never place your hand in front of the weapon muzzle when adjusting
the PRODUCT.
Do not operate the PRODUCT around cleaning solvents or ammable/combustible materials, in environments involving
gasses or a ammable atmosphere, or in areas where gasoline, paints, solvents, or other ammable liquids are stored.
Never place the PRODUCT on it’s face (bulb down) while on. The bulb generates intense heat and could cause damage to
the PRODUCT or the surface it is on.
Use only high quality 15.5 mA batteries. The light is equipped with circuitry that shuts off power when voltage drops below
a preset level. When the light dims or fails to illuminate, change batteries. Always replace batteries as a set – do not mix new
and used batteries. Follow battery manufacturers’ instructions for the proper handling, storage, and disposal of batteries. Do
not store the PRODUCT with batteries installed.
BATTERY HAZARD WARNING
Battery manufacturers warn against mixing new and used batteries or different brand batteries together as this may increase
the risk of leakage, re or explosion. Do not, puncture, short-circuit, disassemble or heat batteries above 212°F (100°C). Do
not recharge the batteries unless they are specically designed as rechargeable batteries and then only in accordance with
manufacturer’s directions.
Lithium Batteries: Industry wide there have been reported incidents of off-brand Lithium batteries exploding or catching re
creating serious consequences. Sig Sauer, Inc. includes batteries from Duracell® and other well-known battery manufacturers
with its products, and strongly urges you to only purchase replacement batteries from Duracell®, or other well-known battery
manufacturers like Panasonic® and Rayovac®. These batteries are designed for use in high performance, high-drain devices,
and their designs incorporate fault and heat protection for added safety. Use of inferior batteries may cause an explosion or
re, creating risk of damage to your device that will void the SIG Sauer Inc. warranty, cause damage to other property, and
potentially serious injury or death.
STATEMENT OF LIABILITY
This device is classied as a FIREARMS ACCESSORY and is sold by us with the specic understanding that we are not
responsible in any manner whatsoever for its safe handling or resale under local laws and regulations. SIG SAUER lnc. shall
not be responsible in any manner whatsoever for malfunctioning of the rearm, for physical injury or for property damage
resulting in whole or in part from (I) criminal or negligent discharge, (2) improper or careless handling, (3) unauthorized
modications, (4) defective, improper, hand-loaded, or reloaded ammunition, (5) corrosion, (6) neglect, or (7) other inuences
beyond our direct and immediate control. This limitation applies regardless of whether liability is asserted on the basis of
contract, negligence or strict liability (including any failure to warn). Under no circumstances shall SIG SAUER Inc. be liable for
incidental or consequential damages, such as loss of use of property, commercial loss and loss of earnings or prots.
SIG SAUER® LIMITED ONE YEAR WARRANTY
SIG SAUER® warrants that the enclosed accessory was originally manufactured free of defects in material, workmanship and
mechanical function, and agrees to correct these defects by repair, adjustment or replacement, at the option of SIG SAUER,
with items of the same or comparable quality; provided, however, that the accessory is returned freight prepaid to SIG SAUER
at 18 Industrial Drive, Exeter, NH 03833 by the original purchaser within one year of the date of purchase.
This limited warranty is null and void if the accessory has been misused, damaged (by accident or otherwise), or if unauthorized
repair or any alteration, including of a cosmetic nature, has been performed on the accessory. This limited warranty does not
apply to normal wear and tear of any parts.
Subject to the foregoing, this limited warranty confers the right to have the covered accessory or its parts repaired,
adjusted or replaced exclusively by the original purchaser, which right is not transferable to any other person.
NO IMPLIED WARRANTIES OF ANY KIND, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE ARE MADE HEREIN, and this warranty does not apply to any accessory items attached
or appurtenant to this accessory. In no event shall SIG SAUER be liable for incidental or consequential damages
arising from or in connection with this limited warranty.
CONTACT
18 Industrial Drive, Exeter, NH 03833
(603) 772-2302 • www.sigsauer.com
04/11
Loading...