SIG SAUER E2 User Manual

Modular One Piece Grip

–

Removal and Installation

Page: 1/2

Modular One Piece Grip – Removal & Installation

Grip removal: Before performing these steps, field strip the

pistol by following the instructions in Section 8.1 of the
Owners Manual

Action Picture

1. Insert the disassembly
tool in the magazine
well.

2. Rotate the disassembly
tool a quarter turn.

3. At the same time
remove the grip plate
from the rear of the
frame.

SIG SAUER Inc. 18 Industrial Drive, Exeter, NH 03833 - [phone] – www.sigsauer.com

Modular One Piece Grip

–

Removal and Installation

Grip installation:

Action Picture

1. Install the grip plate
from the rear by sliding
it forward until it snaps
securely in place.

2. Use caution to ensure
the trigger bar and
decocking lever springs
are not dislodged during
grip plate installation.

Page: 2/2

After installation: Reassemble the pistol by following the

instructions in Section 8.4 of the Owners Manual.
Perform a Function Verification by following the steps in

Section 8.6 of the Owners Manual Section
If you have any questions regarding the correct removal or

installation of the Modular One Piece Grip, please contact
Customer Service at [phone]

SIG SAUER Inc. 18 Industrial Drive, Exeter, NH 03833 - [phone] – www.sigsauer.com