SIG SAUER CP1 User Manual

CP1 PRISMATIC SCOPE

OWNER’S MANUAL

CP1 PRISMATIC SCOPE

The CP1 Prismatic Scope is a lightweight solution for fast target acquisition.
This rugged and reliable scope provides assured accuracy from a 3X fixed
magnification reticle, graduated to 600 meters. It features three reticle
modes – non-illuminated black, illuminated green and illuminated red, with
each illuminated mode offering 5 brightness settings. Anodized aluminum
construction ensures optimal performance in the most extreme conditions.

CONTENTS

1. CP1 Prismatic Scope 2. Owner’s Manual 3. 3V CR2032 Lithium Battery

FEATURES

• 3 reticle modes – non-illuminated black, illuminated green and red.

• 5 brightness settings for each illuminated mode (green and red)

• 3X fixed magnification ranging reticle

• Windage & elevation adjustments

• Anti-reflect & multilayer band pass optical coating

• M1913/Weaver rail mount

CP1 PRISMATIC SCOPE

3V CR2032 LITHIUM
BATTERY 8000 HOURS
TYPICAL LIFE

ROTARY ON/OFF OF
ILLUMINATED GREEN
AND RED RETICLE
MODES.

WINDAGE
ADJUSTMENT
TURRET

M1913/WEAVER
MOUNT

ELEVATION ADJUSTMENT
TURRET

ANODIZED
ALUMINUM CASE

3X FIXED MAGNIFICATION
RANGING RETICLE

ANTI-REFLECT &
MULTI-LAYER BAND
PASS COATING

INSTRUCTIONS

• Unscrew battery cover, using coin, then thumb/forefinger

• Position battery + facing out

• Reattach battery cover, tighten completely to o-ring

To mount on M1913/Weaver accessory rail:

• Loosen locking bolt using coin or screwdriver

• Mount on rail, and secure by tightening locking bolt

• CP1 is in non-illuminated mode, with the rotary switch set to 0. Switch to

illuminated green or red brightness settings 1 – 5 by rotating switch left or
right. Settings are colored green or red to correspond with reticle pattern
color.

• Adjust windage and elevation by removing turret covers and using coin or
screwdriver – counterclockwise: move impact left/up – clockwise: move
impact right/down.
1 click = 1/4”@100 yds. Secure covers once set.

CP1 PRISMATIC SCOPE

Reticle type

Reticle color

Magnification

Eye Relief

Exit Pupil

Parallax setting

Optical coating

Power/Obj. lens

Field of view

Adjustment range

Windage/elevation

Mounting

Temp range

Water resistance

Length/diameter

Weight

Reflective prism ranging reticle

Illuminated red, green or non-illuminated black

3X

5.9” / 82mm

.4” / 10.6mm

100 yds

Anti-reflect & multilayer band pass

1.3” / 32mm

6 degrees, 10.5m@100m

2 degrees

1/4”@100 yds

M1913 / Weaver

-5 degrees F to +130 degrees F

0.5m for 20 minutes

5.8” x 1.2” (146mm x 30mm)

13.9 oz / 390g

BATTERY HAZARD WARNING

Battery manufacturers warn against mixing new and used batteries or different brand batteries
together as this may increase the risk of leakage, fire or explosion. Do not, puncture, short-circuit,
disassemble or heat batteries above 212°F (100°C). Do not recharge the batteries unless they are
specifically designed as rechargeable batteries and then only in accordance with manufacturer’s
directions.
Lithium Batteries: Industry wide there have been reported incidents of off-brand Lithium batteries
exploding or catching fire creating serious consequences. Sig Sauer, Inc. includes batteries from
Duracell® and other well-known battery manufacturers with its products, and strongly urges you to
only purchase replacement batteries from Duracell®, or other well-known battery manufacturers like
Panasonic® and Rayovac®. These batteries are designed for use in high performance, high-drain
devices, and their designs incorporate fault and heat protection for added safety. Use of inferior
batteries may cause an explosion or fire, creating risk of damage to your device that will void the SIG
Sauer Inc. warranty, cause damage to other property, and potentially serious injury or death.

STATEMENT OF LIABILITY

This device is classified as a FIREARMS ACCESSORY and is sold by us with the specific understanding
that we are not responsible in any manner whatsoever for its safe handling or resale under local laws
and regulations. SIG SAUER lnc. shall not be responsible in any manner whatsoever for malfunctioning
of the firearm, for physical injury or for property damage resulting in whole or in part from (I) criminal
or negligent discharge, (2) improper or careless handling, (3) unauthorized modifications, (4) defective,
improper, hand-loaded, or reloaded ammunition, (5) corrosion, (6) neglect, or (7) other influences
beyond our direct and immediate control. This limitation applies regardless of whether liability is
asserted on the basis of contract, negligence or strict liability (including any failure to warn). Under no
circumstances shall SIG SAUER Inc. be liable for incidental or consequential damages, such as loss of
use of property, commercial loss and loss of earnings or profits.

SIG SAUER® LIMITED ONE YEAR WARRANTY

SIG SAUER® warrants that the enclosed accessory was originally manufactured free of defects
in material, workmanship and mechanical function, and agrees to correct these defects by repair,
adjustment or replacement, at the option of SIG SAUER, with items of the same or comparable quality;
provided, however, that the accessory is returned freight prepaid to SIG SAUER at 18 Industrial Drive,
Exeter, NH 03833 by the original purchaser within one year of the date of purchase.
This limited warranty is null and void if the accessory has been misused, damaged (by accident
or otherwise), or if unauthorized repair or any alteration, including of a cosmetic nature, has been
performed on the accessory. This limited warranty does not apply to normal wear and tear of any parts.
Subject to the foregoing, this limited warranty confers the right to have the covered accessory
or its parts repaired, adjusted or replaced exclusively by the original purchaser, which right is
not transferable to any other person. NO IMPLIED WARRANTIES OF ANY KIND, INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE MADE
HEREIN, and this warranty does not apply to any accessory items attached or appurtenant to
this accessory. In no event shall SIG SAUER be liable for incidental or consequential damages
arising from or in connection with this limited warranty.

18 Industrial Drive, Exeter, NH 03833
[phone] • www.sigsauer.com

P/N 8500857