Sierra Wireless MC7750, MC7700 User Manual

Appendix A

Supplementary Instructions for Display Rotation

Please replace the procedure for “Display Rotation” in the Reference Manual with the following procedure.

Display Rotation

After Windows is started up, you can rotate the display and perform the Touch Pad and screen operations in the rotated mode.

Rotating the Display

1 Press (Rotation) button.

 To select the angle and rotate the display

When using the computer in the tablet mode

・Press

When the computer is held in tilt position, the display will rotate to the most suitable orientation when press

will not rotate. When the computer is held in level position, the display will rotate 90 degrees clockwise at each press.

・(Windows7) Press and hold

The display will continue rotating 90 degrees clockwise.

When using the computer in the laptop mode

Screen rotation function can not be used in the laptop mode. Note:

 Be sure to use the above procedures to rotate the display.  In the “Never” (default setting:

condition, the antenna remains active and can be transmitting; in this condition, when positioning the edge with the antenna near persons (with the screen in orientation other than Secondary Portrait), to ensure compliance with FCC RF exposure requirements the right side edge of the display with the antenna (see diagram below) must be maintained at 2.5 cm from all persons’ bodies.

(Rotation) button.

(Rotation) button. If the display has already been at the most suitable orientation, the display

(Rotation) button.

Transmitter always on, but screen rotation off for secondary portrait)

WWAN Antenna is located in the right side edge of the display.

 When WWAN has been enabled, the message appears in the bottom of screen as follows.

Appendix A

Changing the Settings

By using the Display Rotation Tool, you can change the settings of the display rotation.

1 (Windows 7)Click on the notification area and right-click .

(Windows XP)Click

on the notification area.

2 Click [Setting...]. 3 Change the settings.

A. Changing the angle in the laptop mode

(Default: Primary Landscape)

This setting can not be selected.

B. Changing the angle in the tablet mode

(Default: Keep Angle) When [Latest Angle] is selected, the screen will be displayed at the angle used during the last time tablet mode was used.

Note: If Secondary Portrait is selected as default, screen will rotate to Primary Landscape.

C. Activating/deactivating the WWAN auto OFF

When you orient the computer so that the wireless WAN antenna is placed close to you in Tablet mode operation, WWAN is

In the “Never” condition, the antenna remains active and can be transmitting; in this condition, when positioning the edge with the antenna near persons (with the screen in orientation other than Secondary Portrait), to ensure compliance with FCC RF exposure requirements the right side edge of the display with the antenna must be maintained at 2.5 cm from all persons’ bodies.

deactivated or Screen Rotation is cancelled.

Check on each time :

This setting can not be selected.

Always (Transmitter off for secondary portrait):

This setting is for users who accept WWAN disabled in secondary Portrait position. The rotation angle keeps Secondary portrait. Then WWAN will be disabled by force immediately.

+ 1 hidden pages