Siemens SIMATIC ET 200eco PN Operating Instructions Manual
SIMATIC Distributed I/O ET 200eco PN
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
SIMATIC
Distributed I/O ET 200eco PN
Operating Instructions
06/2009
A5E01250250-04
Preface
Product overview
_____________
Installing
_____________
Wiring
_____________
Configuring
_____________
Commissioning
_____________
Maintenance
_____________
Interrupt, error, and system
messages
_____________
General technical data
_____________
I/O device digital
inputs/outputs
_____________
IO-Link Master
_____________
I/O device analog
input/output
_____________
Terminal block and voltage
distributor
_____________
Order numbers
_____________
Dimensional drawings
_____________
I/O address space
_____________
Response times for analog
input device and output
_____________
device
1
2
3
4
5
6
7
8
9
10
11
12
A
B
C
D
Legal information
Legal information
Warning notice system
This manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent
damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to property damage have no safety alert symbol. These notices shown below are
graded according to the degree of danger.
DANGER
indicates that death or severe personal injury will result if proper precautions are not taken.
WARNING
indicates that death or severe personal injury may result if proper precautions are not taken.
CAUTION
with a safety alert symbol, indicates that minor personal injury can result if proper precautions are not taken.
CAUTION
without a safety alert symbol, indicates that property damage can result if proper precautions are not taken.
NOTICE
indicates that an unintended result or situation can occur if the corresponding information is not taken into
account.
If more than one degree of danger is present, the warning notice representing the highest degree of danger will
be used. A notice warning of injury to persons with a safety alert symbol may also include a warning relating to
property damage.
Qualified Personnel
The device/system may only be set up and used in conjunction with this documentation. Commissioning and
operation of a device/system may only be performed by qualified personnel. Within the context of the safety notes
in this documentation qualified persons are defined as persons who are authorized to commission, ground and
label devices, systems and circuits in accordance with established safety practices and standards.
Proper use of Siemens products
Note the following:
WARNING
Siemens products may only be used for the applications described in the catalog and in the relevant technical
documentation. If products and components from other manufacturers are used, these must be recommended
or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and
maintenance are required to ensure that the products operate safely and without any problems. The permissible
ambient conditions must be adhered to. The information in the relevant documentation must be observed.
Trademarks
All names identified by ® are registered trademarks of the Siemens AG. The remaining trademarks in this
publication may be trademarks whose use by third parties for their own purposes could violate the rights of the
owner.
Disclaimer of Liability
We have reviewed the contents of this publication to ensure consistency with the hardware and software
described. Since variance cannot be precluded entirely, we cannot guarantee full consistency. However, the
information in this publication is reviewed regularly and any necessary corrections are included in subsequent
editions.
Siemens AG
Industry Sector
Postfach 48 48
90026 NÜRNBERG
GERMANY
A5E01250250-04
Ⓟ 06/2009
Copyright © Siemens AG 2009.
Technical data subject to change
Loading...