Siemens signia easyTek How-to Manual
easyTek® how-to guide
For primax hearing instruments
signiausa.com/easytek
1
Bluetooth® Power Battery
➊
Multi-function button
➌
Neckloop (antenna)
➍
Built-in mic
➎
Micro-USB
➏
Reset
➐
FM input
➑
Port for audio
devices
➒
Volume
up/down
easyTek
➊ Multi‑function button
➋ LED status indicator (orange, green, blue)
➌ Neckloop (acts as the antenna)
➍ Microphone openings
➎ USB port for charging
➏ Reset button
➐ Port for FMreceiver
➑ Port for audio devices (standard 3.5mm audio jack)
➒ Volume buttons
➋
LED status indicators:
2
Wearing easyTek properly
In order to function correctly, the easyTek must be worn with the
neckloop around the neck. The neckloop is also the antenna.
u Unplug one neckloop plug and place the neckloop loosely around
your neck ➊.
u Insert both neckloop plugs all the way ➋.
Turning easyTek on/o
u To power on: press
until the green LED turns on.
This takes approximately 2 seconds
u To power o: press
until the green LED fades o.
This takes approximately 2 seconds.
easyTek out of the box pairing
The hearing instruments must be paired with the easyTek. After
the pairing process is completed, the connection is automatically
established when the hearing instruments and easyTek are turned on.
Pairing
u Open battery doors of hearing instruments. Place easyTek around
neck with neckloop. easyTek should be “o”.
u Press Multi-Function Button (MFB) on easyTek until green LED
is flashing
3
u While green LED is flashing , close battery door of hearing
instruments
u Pairing is complete when green LED stops flashing (audible alert) –
easyTek is ready to use
Note with initial activation only: Blue light will now flash to
allow for pairing of Bluetooth phone. If phone is not present, press
MFB to stop blue light flashing and end pairing search.
Pairing Siemens transmitters
Before first use
• Charge transmitter before first use by connecting the transmitter
with the power plug to a power supply.
• The LED shines red while charging.
• Charging time is about 5 hours.
• Make sure that a hearing aid that has been paired is turned on.
• Every Siemens transmitter must be paired once with easyTek.
You can use up to two Siemens transmitters.
u Turn on easyTek and Siemens transmitters.
u Press MFB , and simultaneously for about 5 seconds;
and LED’s flash
u easyTek LED flashing, then “on” – transmitter LED flashing, then
solid blue . Your easyTek has been paired to the transmitter.
Remote control functions
u Volume changes: Press or <1 second to adjust step
by step or press and hold until desired volume is reached.
u Hearing program changes: Press and release
1-2 seconds until
desired program is reached. (This function is not available during
audio streaming, for example when you are using easyTek to listen
to the TV or to music through your MP3 player.)
u Turn on/o (standby): Press and simultaneously
for >3 seconds. easyTek will then turn o.
Loading...