222
HARTREY AVE., EVANSTON,
@
AREA
C03E
312,328.9-
.
C&BLE
IL.
60204
Sr<lRL\I'CHO
STEREO MODELS VN35E, VN3-6
AND MONOPHONIC MODEL VN78E
SUPER-TRACK "PLUS" STEREO DYNETICJ3 STYLI
U.5.A.
THE MODELS VN35E, VN3-G, AND VN78E ARE DIAMOND
STYLI FOR THE MODEL
The Model ,VN35E Stylus (grip color-black) has a Biradial
(Elliptical)
radius of 18
5 microns
points is 25 microns
The BIodel VN3-G Stylus (grip color-gray) is constructed
like the
with a radius of
The, ;IIodcl VN78E Stylus (grip color-light g!,een) has a Bi-
radial (Ellipticali Dianiond Tip designed for playba(:k
nionopl~onic 78 rpni records. Tl~e broad frontal plane radlus 1s
63 mici.rins t.00251, while tlie side contact radii are 13 microns
(.0005 in.). The spacing betwci'n tlie rccoi,d contact points is 89
niicrons 1.0035 in.) When using the VN78E, the aniplifier should
be set to
a significant
rccords ore1 conventional 63 micron i.0025 in.) to
i.003
NOTE-A
The
ABILITY. BiLcause of it. all records wiil sound better. and in
fact you will hear
witl~out distortipn. Thc Vl5 Type I11 Cartridge has the following
speclfieations
TRACKING FORCE RANGE:
VN3jE and VN3-G to
VN78E
NOTE-Do
TRACKABILITY:
YK3-G at I gram (Reference: Shiire TTRlO3 Laboratory Test
Record
Dlanrond Tly constructed wlth a broad frontal plane
niicrons (.0007 in.) while the side contact radii are
(.0002 in.) and the spacing between the record contact
VN35E, except the diamond tip has a spherical shape
"AtE"
in.) spherical tips.
small .8 gram weight lias been added to the molded
grip of the
substituted for a
the tracking force setting on the tone arm. the proper
tracking force for 78 rpm records will be achieved.
For
and using a VN35E or VN3-G Stylus worild auton~atically track at 1.55 grarns wllen a VN78E Stylus was
substituit.d. If the V15 Type
grams.
tracking force to 2.05 grams. If tracking forces greati.1'
than 2.05 granis ai'e 1,eqnircd for playing 78 rp~n records.
a
maniial tracking forcc adjustment must be made on
tlle tone a1.m: however, allowance should be made for
atlditional
the
Stylus.
rriajor feature of these styli is their siiperior TRACK-
(.001 in.).
16
microns (.0006 in.)
or
Iniprovement in the reproduct~on
exa~l~ple, a
the substitution of a VK78E would change the
so~~~e recordings tracked for the first time
with
the sty11 noted.
not exceed maximum rated tracking force.
In S~LII,~-SJIE Tonc AI,!I! \vitli VS35E allrt
1
V-15
TYPE
Ill
CARTRIDGES.
"I\IONQ."
VN78E Stylus Asse~nbly. allowing it to bc
.8
11-
The use of a, VN78E wiil provide
of
older
75
78
rpnl
micron
VK35E or VIT3-G. Without altering
V15
Type I11 tracking at .75 grams
111
rne1.e tracklng at 1.25
gram weight contained in the VN78E
li:
giall!s
to 3 glams
g£
FREQUENCY RESPONSE
OUTPUT VOLTAGE
i,=l~(lt\
I
~ ~
3.5
i;iT'
per cliannel - VX35E.
tOiiCp\it voltagc~s given foi- slei.i,o nit 1.ccc11.6. For
record, oiitput 1-oltage at both left channel and right cllam~el
(.ai,tl.idgii tt~rrninals will be,
CHANNEL BALANCE:
CHANNEL SEPARATION
NOTE-Tlle
1.
advantages
It drastically reduces tracing distortion because the eliiptical sliape more closely follows the groove ~nade by the
wedge-shaped cutting stylus.
ing
through the contact points coincides with the linr of
contact of
spherical
2.
ft suilplies the uii>st act.1irate i,eprodiictiv~i
infvi.niativn stori'd in thc rcco1.d gi.oovc. Tlir.
pr(lvid(3i:
~riono~ihonic.
hacli. wit11 iilininl~in? sn!.face noise ant1 clii.tortion. of oldei
75-irlc-gr'oovt. ~~>col,ds siich as 78s.
Stylus i~eplacement is very siniple and fast. To replace ~itli
stylus gi~ard down-pmsp stylus grip between thunib and foi.e>finger. Gently withdraw stylus by pulling forward out of
cartridge. Gl'asp grip
forefi11gf.r and insert into stylus socket. Press styl~is into sockct
rintil the nloldcd housing of the stylus touches the cartridge
case. Care l~lust be taken not to allow the finger to sllp
stylus grip, as this could result in danlage to the stylus tip or
shank.
The stylus assembly, when installed in the cartridge. is
practically
because of the delicate low
be taken to avoid bending or distorting the stylus
when it is installed, removed, or cleaned.
NOTE:
guard should be in "down" position when removing or replacing
stylus.
RECOMMENDED
(No. 2 size or smaller), trimmed to approximately 6 mm
dipped in alcohol or an alcohol-distilled water solution. Com1nc.i.cia1 cleaning solutions Tilay cause stylus daniage or corrosion.
Always
stylus
TO
1.
2.
3.
j.
6.
7. Do not use badly warped,
8.
Copyright 1973. Shure Brothers Inc.
27-4581
brush stylus from back to front, never brush or wiue
froni front to back or. side to side.
PRESERVE STYLUS LIFE:
Follow turntable or tone arm instructions when adjusting
antiskating force.
Do
not handle the tone arni while it is in operation. since this
n?ay cause tile ari11 to sweep across the record.
If it is necessary to
groore while turntable is rotating. release it as soon as the
stylus engages the record groore.
1.
Correct inlp~oper set-down acijiistn~ent or nialfuni~tion of
turntable changing niecllanisni to prevent the stylus frol?~
sti.iking tlle edge of the turntable 01. record,
inore records than the turntaljle manufacturer reeon~n~cnds.
Take care to properly insert the stylus into the
assen~bly and the cartridge and shell assenihly into the tone
arm receptacle.
Use proper rcrtical tracking force setting for each cartridge.
When dusting the turntable protect tlle stylus with
stylus guard.
(OLi
dB at 1,000
3,:
15
dB
Shm,e Biradial (Elliptical) Stylus has certain
the cutting stylus Inore closely than that of a
stvlus.
opt in it in^
LP
imniune to damage during normal usage. However.
Stylus guard is shown in "up" position for. clarity:
fus~ng optimuin load): 10 to 25 000
at
:
(at 1000
10.000
Within 2 d6
Hz,
YSYG.
il',;
iii?inii!?unl)
Hz
Hz
~~
~
5
cm/sec pcak lecoidcd
S'N78E
of figme above.)
:
Hz
;iIOKC)
Tliis nieans that thc line pass-
iaf
the ii~usicai
\'N35E,
i>l:iyback of stri.eo. 4-clianni~i niarris, ant1
~,e(,orcis; the VS7XE ~)r.ovidcs optlmiini play-
STYLUS REPLACEMENT
of
t'eplacement stylus between thunib anci
Styliis
off
nlass components, extra care should
STYLUS CLEAN I NG:
I'se a caniel's hail bl,usEi
asselnbiy
i
I.?
in.
n?aniiaily place the tone arm in the 1.eeor.d
Do
not stack
cartridge
cl.aclied. or inipei.fr2ct i,ecords.
Printed in
U.S.A.
ciii
the,
i.
th~
the