Page 1
SBC-AX
Axient Charging Module
The Shure Axient charging module for rechargeable batteries, SBC-AX, user guide.
Version: 2 (2020-G)
Page 2
Table of Contents
SBC-AXAxient Charging Module 3
SBC-AX Charging Modules 3
WARNING 3
Shure Incorporated
Installation 3
Included Components 3
Specifications 3
Certifications 4
2/4
Page 3
Shure Incorporated
SBC-AX Axient Charging Module
SBC-AX Charging Modules
These charging modules allow SB900 batteries to be used with AXT900, AXT903, and AXT904 battery chargers.
WARNING
•
Battery packs may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat
above 140°F (60°C), or incinerate.
•
Follow instructions from manufacturer
•
Only use Shure charger to recharge Shure rechargeable batteries
•
WARNING: Danger of explosion if battery incorrectly replaced. Replace only with same or equivalent type.
•
Never put batteries in mouth. If swallowed, contact your physician or local poison control center
•
Do not short circuit; may cause burns or catch fire
•
Do not charge or use battery packs other than Shure rechargeable batteries
•
Dispose of battery packs properly. Check with local vendor for proper disposal of used battery packs.
•
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like
•
Do not immerse the battery in liquid such as water, beverages, or other fluids.
•
Do not attach or insert battery with polarity reversed.
•
Keep away from small children.
•
Do not use abnormal batteries.
•
Pack the battery securely for transport.
Installation
Charging modules may be installed interchangeably into the charger.
Caution! Remove power and batteries when installing charging modules.
•
To remove a module, remove the four (4) mounting screws and pull.
•
To install, slide the module into the housing (noting the orientation of the guide rails) until it is flush with the housing.
•
Replace the screws.
Included Components
Mounting Screws (8) for Charger Modules (30B13476)
3/4
Page 4
Specifications
Charge Current
750mA
Dimensions
44 x 86 x 100mm (1.8 x 3.4 x 4.0 in.), H x W x D
Weight
119g (4.2 oz.)
Housing
Molded ABS, Cast aluminum
Certifications
Shure Incorporated
Meets essential requirements of the following European Directives:
•
WEEE Directive 2012/19/EU, as amended by 2008/34/EC
•
RoHS Directive EU 2015/863
Note: Please follow your regional recycling scheme for batteries and electronic waste
4/4
Loading...