Shure N75-6, N75E User Guide
-
-
MODELS
N75-3, N75-6,
AND N75E
222 HARTREY AVE * EVANSTON. ILL
AREA
CODE
312/328.9000 CABLE SHUREMICRO
150
DATA
STEREO
SI4EET
PHONOGRAPH
160204)
DYNETIC
STY
o
LI
SPECIFICATIONS
M75
CARTRIDGE AND N75 STYLUS SERIES
*
The N75-3 stylus may
l'prrl rrcords. In this cast,. thts arllpilfie~~ slluulti ht* 3c.t to "Alon:tur;rlM or "A-+R."
bc
used to ri~p~.oduct~ tlic st;rndarti 78
U
5
R
FREQUENCY RESPONSE:
CHANNEL SEPARATION:
RECOMMENDED LOAD IMPEDANCE:
INDUCTANCE:
D.C. RESISTANCE:
MOUNTING:
WEIGHT:
TERM I NALS:
GENERAL:
graph cal'tl'idgc',q has betw tlevi.lop?ed for ~1st. wit11 all Iiigli fiilclity
arng1ifit.r~ l~:rv~ng magnetic and constant vt.locity Inputs.
M:ijor recording ci)nip:inic~ now ust. tht,
:rnglr :mri it is tile. pl'011osc~I
:~nd
DIN
Tl~c &I75 Scrit\s 11:is hen spi.c~ific;llly ticsigncd to i.or~iplenic-nt
1111.
15"
c,fft,ctirc clitting angle now bi~irrg 1ist~I 111 niswt>st l,i,(.i,r.cl-
ings.
Tt
fl.on~ o1tit.1. discs.
SHURE-SME MOUNT1 NG INSTRUCTIONS:
In tl~c Sliii~~t~-SME Prc>(.ision Pic,kup Arm. XTodf~l 3009 anti
r.c,fiar
to
in the instruction 1Rianual supglicd with the pickiip :il'nis.
OPERATION:
;ir~ 1istt.d undixr "Spt'c~ifi~~atit)nsS" Forces grt~iti.r th:m tir~. indicatcd "~~i:rsir~lurn" shi111lt1 not bt, i1st.d
720 rnilliht~nrit~s
Stantlard
6 granis
4
ti11 11iin:rls
Tlrt, I1175 Si'rif7s
and CCIR in Erlsopc.
:tlso sor.vcls to significantly iniprovtx the soiind ol~l;iine(i
tl~n paragraptis on Cnrtl'idgc, 111stnll:rtion
ricc~~~r~tiit~nclt~d 11t.edlt> fijr.c.i,s fol. oj~tiniiin~ ~vsillts
Fro111 20 to
nlole tt1:tn
630 ollnis
'L"
(12 7 nrln) ~l~i~~inting ct1ntt.r
of
EIA
20
25
FIig11 Trackability Dyntxtic. pliono-
anti RIA.?. st:intiarci in i\lne1.1c:t
000 FI/ (cps)
dh
:It 1000
IT/
lrpsi
47000 ohrlis ])el ciiannrl
15"
t~ff~~c,tirt (.utting
To nrount tiits 117;
:inti
:ii?l2.
I::tl:~ncing
;\A<\
i
4-LEAD STEREO CONNECTION:
channel to trrminal R" and shleld or ground lead of right channel to terminal "RG
minal
"L"
To prc~cnt "g~ound loops" and hum no corrrlnon connrctlon
should be used at cartridge tcrmmnals
MONAURAL CONNECTION:
Mona,ura? or Sterco recordings, connect "hot" lead to both
and I, tcnninals and connivt ground or shield lead to both
ground terminals
CAUTION:
Maki? all solder connections to tt,rniinal jacks provided bt.forc slip-
ping
If
head, remove thc ground tab from the right ground terminal.
(See Figure 1)
and shield or ground lead of left channel to
Do not innkc solder csonnections to cartridge terlliin:tls.
them over the
hum is experienced when cartridgr is inst:lllcd in a tliiltal
TERMINAL DIAGRAM REMPLAZO DE LA AGUJA
markcd
FIGURE
"
Connect ' hot" lead of left channrl
"RG"
terminals.
GROUNDED
TO CASE
I
Connect "hot" lead of rlght
to
ter;
1.G
For single channel reproduction of
and
"LC,."
STYLUS REPLACEMENT
REMPLACER L'AIGUILLE
ERSATZ-ABTASTSTIFT-El NSCHU
FIGURE
"R"
2
EASY STYLUS REPLACEMENT
CONNECTIONS
Grasp moldrd housing of stylus between thunth and forf,fingi,r.
Gently withdraw stylus by pulling forward out of cartridge. Grasp
replacement stylus between
stylus socket.
of the stylus mates with the cartridge case. Care must be taken
not to allow the finger to slip
stylus, resulting in damage to the stylus tip or shank.
SPECIAL NOTE:
tridges is the
pt!rformance standards of your cartridge, be certain th?t any rrplacen~rnt styl~ls you buy brars the following certificat~on on thi.
package: "This Dynetic stylus is
Shnrc Brotlrers. Inc."
Avoid inferior imitations. They will seriously
formance of your cartridgr. All genuine "Dynetic" styli art'
manufactured by
Prcss stylus into socket until the molded houslng
The Dynetic stylus asscmbiy uscd in thcsc car-
niost critical component. To rnaintain tirc original
Shurr! Brothcrs. Inc.
thurnh and forefinger and insert into
off
the molded housing
precision
mannfaeturc,d by
drgradc tht, per-
of
tho
Guarantee
The Stixrco Dynrtic Cat'tritfgcs and Stci.eo Dyni.ti(, Styli arc.
gua~.antred to bi, fri,r from t.lcctrica1 :rnd ~l~c('li:rnic:rl d<~f'ccts for.
i,nt3 yc:rr f~.otri the datix
iill instructions at,<. co~tipliect with fnlly. Thr. Gi~:rlantc~r tio(,s not
c~v(~r stylus wear. nor dot,; it cortXl. datllage to tht. stylns asst,rlibly fro111 abusi, or nrisl~andling.
of
shiprrtc~~t fro111 the facto~'y. proritle(l
B
Stlure Dynrtic Styli will withstand long,
Service Protection-Accidental
elsrr, if stylus asstmbly should br damagi-(1 dut. to accidental
mistlandling, and dialliond tip is still intact. return the styllis
asselr~bly to the factory for serricirig and testing to ol'igin:rl
pt>rfor.rn;tnce stanii:rr'ds
(N75,-3. N75-6) or $6.00 iN75Ei. Plc:xsc i~nclosts
~(~rv~i.e i.h:rrgf: with the ~.etiirnt>d :rssi~n~t)ly.)
Return Styl11s
PATENT NOTICE:
3,077,521, and 3,077,522. Othcr patents prntiing.
Copyright 1966, Shurc Brothers,
27A329 (7-66)
:I!
a
nonlinal se~'~icix (~11:~t.g~~
to
ScrlILC Ui'p'll tlll~llt
StIURE RROTIIERS
222
HL211TTIEY
EVANSTON II,T,INOIS 60201
Iv~:tnlifnctilrcd under
AVE:NUE
lnc.
q<-%,\
i,
"i
Damage
continued
iis:tgi>. IIow-
:I
ctii~li fo~, tilt.
INC
I!.
S. Patrnts 3.055.988.
I'rinted in U.S.A.
01'
$5.50
Loading...