Shure N44-3, N44-7, N44C, N44E, N44G User Guide
1
I
222
HARTREY AVE.. EVANSTON. IL. 60204 U.S.A.
@
AREA
CODE
3121328-9000
.
CABLE:
SHUREMICRO
THE PREMIER
MODELS
N44-7, N44C, N44E,
FAMILY
N44-1, N44-3,
AND N44G
OF STEREO SOUND REPRODUCERS
DATA SHEET
STEREO DYNETIC@
PHONOGRAPH STYLI
STYLI SPECIFICATIONS
I
within
2 dB
within
2 dB
-
-
20 dB
at
1
kHz
20 dB
at
1
kHz
-
-
M55E, original V-15, and M44
N44E
10
X
18 microns
(.0004
.0007 in.)
Elliptical
N44C
18 microns
(.000! in.)
Spherlcal
N44-lt
26 microns
LO001 in.)
Spherlcal
NU-3tt
64
(.0025 in.)
Spher~cal
?Optional
??Optional
'Output voltages given for stereo cut record. .For MONO cut record,
"Tracking forces
NET WEIGHT: 0.3 grams
MONOPHONIC OPERATION: Set function switch on amplifier to "MONO"
or "AtB." If amplifier is not equipped with this switch, connect left and
right channels in parallel.
Brown
X
Light
Blue
Dark
Blue
Dark
microns
Series Cartridges: Set amplifier to "MONO" or
tridges: Set amplifier
output voltage at both left channel and right channel cartridge terminals
will be 71% of figures above.
Green
33-1/3
78
rpm Stylus for M55E, original V-15, and M44 Series Car-
20 to
9.5
mV
20,000
Hz
20
9.5
9.5
9.5
rpm
greatel than maximum indicated should not be used.
to
mV
20,000
Hz
20 to
mV
20,000
Hz
20 to
mV
20,000
Hz
MONO-LP Stylus for
to "MONO" or "A+B."
1%
to 4
grams
to
urams
1v2
to 3
grams
1%
to
grams
A
3
5
3
"Ad-5."
14.3 cm/sec - 400
at
1%
14.3
cm/sec - 400
at 3 grams
14.3
C~/SIC
at
1%
grams
grams
HZ
Hz
-
400
HZ
STYLUS
REPLACEMENT
STYLUS REPLACEMENT: Grasp molded housing of stylus and gently pull
forward out of cartridge. Insert replacement stylus into socket and press
until housing mates with cartridge case.
RECOMMENDED STYLUS CLEANING: Use a camel's hair brush (No. 2 size
or smaller), trimmed to approximately 6 mm
an alcohol-distilled water solution. Commercial cleaning solutions may cause
stylus damage or corrosion. The alcohol will remove any sludge deposit
coating the stylus tip. Always brush stylus from back to front, never brush
or wipe stylus from front to back or side to side.
TO PRESERVE STYLUS LIFE:
1. Follow turntable or tone arm instructions when adjusting antiskating
force.
2. Do not handle the tone arm while it is in operation since this may
cause the arm to sweep across the record.
If it is necessary to manually place the tone arm in the record groove
3.
while turntable is rotating, release it as soon as the stylus engages the
record groove.
4.
Correct improper set-down adjustment or malfunction of the turntable
changing mechanism to prevent the stylus from striking the edge of the
turntable
turer recommends.
5.
Take care to properly insert the stylus into the cartridge assembly and
the cartridge and shell assembly into the tone arm receptacle.
6.
Use proper vertical tracking force setting for each cartridge.
7. Do not use badly warped, cracked or imperfect records.
8. When dusting the turntable protect the stylus with the stylus guard.
SPECIAL NOTE: The
the most
of your cartridge, be certain that any replacement stylus you buy bears the
followins
cision minufactured by Shure BrothGs Inc." AVOID
THEY
TRIDGE. ALL GENUINE
SHURE BROTHERS INC. For more information on your Shure stylus, write
for booklet:
GUARANTEE: This Shure product is guaranteed in normal use to be free
from electrical and mechanical defects for a period of one year from the
date of purchase. Please retain proof of purchase date. This guarantee inÂcludes all parts and labor. This guarantee does not include stylus wear.
SHIPPING INSTRUCTIONS: Carefully repack the unit and return it prepaid
to the factory.
Authorized Shure Service Center for repair. The unit will be returned to
you prepaid.
PATENT NOTICE: Cartridge and stylus manufactured under one or more ot
the iollowing U.S. patents: 3,055,988, 3,077,521, 3,077,522, and 3,463,889.
Copyright
27A409
or record. Do not stack more records than turntable manufac-
crltlcal component. To maintain the original performance standards
certification
WILL SERIOUSLY DEGRADE THE PERFORMANCE OF YOUR CAR-
"A
1966,
(OC)
Dynetic stylus assembly used in these cartridges is
on the ~ackaae: "This Stereo Dvneticm stvlus is Dre-
"DYNETIC@" STYLI ARE MANUFACTURED BY
Visit to the Small World of a Stylus."
If outside the United States, return the unit to your dealer or
Shure Brothers Inc
(1/4
in.), dipped in alcohol or
IN~ERIOR
IMITATIONS.
Printed in U.S.A.
Loading...