MVL
Omnidirectional Condenser Lavalier Microphone
TheShureMOTIV MVLisanomnidirectionalcondenserlavaliermicrophone, featuring a 3.5 mm (1/8") Tip Ring Ring Sleeve (TRRS) plug for use with a portable recording-capable device. By plugging the MVL microphone into
the headphone jack of a smartphone or tablet and opening recording apps
such as the ShurePlus® MOTIV recording app, the user can easily and discretely capture high-quality audio. It is ideal for use in speech and other applications requiring minimal visibility.
•Superior audio clarity
•Effective immunity to audible interference
•Low self-noise
•More even, natural response across frequency range
•Less susceptible to distortion
•Matte black, sleek, low-profile design for inconspicuous placement
•Snug-fit foam windscreen provides additional protection from plosives and wind noise
•Includes protective storage pouch, tie clip, and windscreen
•TheoptionalRycote™ MiniWindjammerfitsovertheincludedwindscreen
•Legendary Shure quality and reliability
15-25 cm (6-10 in.)
1.Install the supplied snug-fit windscreen by sliding it over the microphone capsule.
Note: Do not pull the windscreen too tightly over the microphone. Leave a small space inside the windscreen to allow for air movement.
2.Attach the microphone to a shirt or other garment using the supplied tie clip. For best results, the microphone should be 15-25 cm (6-10 in.) away from the mouth.
3.Plug the 3.5 mm (1/8") plug into your recording device.
To further reduce plosives and wind noise, use the optional Rycote™ Mini Windjammer, which fits over the included foam windscreen.
Microphone Capsule
MEMS
Polar Pattern
Omnidirectional
Frequency Response
40 Hz to 20,000 Hz (see frequency response graph)
Output Impedance
350 Ω
©2018 Shure Incorporated |
1/3 |
MVL Omnidirectional Condenser Lavalier Microphone |
Shure Incorporated |
Signal-To-Noise Ratio
65 dB
Maximum SPL
124 dB SPL
Dynamic Range
95 dB typical
Sensitivity
-44.0 dBV at 1 kHz (Pa=94 dB SPL)
Equivalent Output Noise
29 dB A-weighted
Microphone Connector
3.5 mm (1/8") TRRS (Tip=No Connection, Ring1=No Connection, Ring2=Ground, Sleeve=Audio Output and Bias Voltage)
Microphone Bias
2.7 V DC through 2.2 K Ω resistor
Current Drain
245 µA, typical
Housing
Cast Zinc
Dimensions
15.2 mm x 5.5 mm x 132cm H x W x D
Cable Diameter
1.6 mm
Net Weight
with cable
8.0 g (0.282 oz.)
|
|
2.7 VDC |
|
|
|
BIAS VOLTAGE |
|
SLEEVE (Audio Output and Bias Voltage) |
|
2.2K |
|
TIP (No Connection) |
SLEEVE |
1uF |
|
AUDIO INPUT |
|||
|
|
||
MVL |
|
2K |
|
RING1 (No Connection) |
RING2 |
GND |
|
RING2 (Ground) |
|
|
Microphone and Audio Input Connections for a Typical Device
2/3 |
2018/01/03 |