Shure DC 6190 P Specification Sheet

DC 6190 P Conference Unit
• Conference unit for tabletop placement
• Configurable for chairman or delegate functionality
• Lockable XLR microphone connector
• Reply function to allow brief comments or questions during a conference
• Two headphone jacks for listening to language interpretation
• Exchangeable buttons
• Loudspeaker
DIS Digital Conference Systems
DC 6190 P Conference Unit
The DC 6190 P is a fully digital portable conference unit in the DIS DCS 6000 Digital Conference System.
The DC 6190 P can be configured for a chairman or a delegate (default). The unit is easily configured by holding down the mute and the microphone button while press­ing the left volume button for 10 seconds (up for chairman, down for delegate). The configuration is stored in the unit so it recalls its configuration if it is used in another system setup.
The microphone button enables the user to activate/deactivate the microphone, indicated by the LED ring on the microphone. The floor channel is distributed through the built-in loudspeaker except when the microphone is turned on. There are two headphone jacks to listen to the floor channel or one of the 31 interpretation channels.
To support both configurations, the left button changes functionality to a mute or all-delegate off button. The chairman configuration enables 'all delegates off' func­tionality to immediately silence all microphones, leaving the chairman with exclusive speaking rights. The delegate configuration uses this button as a mute button to temporarily mute the audio while retaining speaking privileges.
The function button can be exchanged to match the current functionality of the unit, including the Reply feature. Improving the flow of the conference, Reply mode en­ables the user to briefly comment or ask a question to the present speaker without affecting the current speakers or request queue. Reply mode is available in VOX, Manual, and Automatic microphone operating modes.
The gooseneck microphones GM 652x or GM 6622 can be locked to the unit with a
1.5 mm hex key. The lock is accessible from the small hole below the DIS logo on the side of the XLR socket. Turn the hex key counter clockwise to lock the goose­neck microphone to the unit and turn the hex key clockwise to unlock the gooseneck microphone from the unit.
The DC 6190 P can be combined with any conference units from the DCS 6000 Digital Conference System.
Features
The DC 6190 P has the following standard features:
• Conference unit delegate or chairman operation
• Supports Reply functionality to briefly comment or ask a question to the present speaker
• Functions in all DIS microphone operation modes: Automatic, FIFO, Manual and VOX (voice activation)
• Support for three microphone interrupt modes enabling 'ping pong' mode
• Voice activation and automatic-off microphone features
• Two headphone connectors for listening to interpretation channels
• Fully digital audio transmission
• Two RJ-45 ports provide power, audio, and control transport across a single chain of chairman, delegate, and interpretation units
• DCS-LAN connection uses CAT 5e (or higher) shielded F/UTP or U/FTP cabling
• Exchangeable buttons for alternate functions and different languages
• Lockable XLR gooseneck microphone connector
• High-quality loudspeaker for listening to the conference
Specifications
How To Order
Electrical
Frequency response
(headphones)
Frequency range
(loudspeaker)
Power consumption 2.5 W
Power maximum
(loudspeaker)
Signal-to-noise ratio > 90 dBA
Headphone connection
65 Hz-16 kHz
150 Hz-15 kHz
3.0 W RMS
THD < 0.1 %
Two 3.5 mm jack, female ste­reo sockets
Interconnections
DCS-LAN
Two RJ45 female sockets with auto-termination
Mechanical
Mounting Tabletop
Dimensions (H x W x D) 61 x 150 x 168 mm
Weight 650 g
Color Black
Temperature range 5° to 40° C
Portable conference unit. Features integrated
channel selectors, headphone outputs, loudspeak-
er and CM buttons. Configurable as chairman or
delegate.
English Reply button DC 61xx -10PK
Spare Part Set DCS 6000 P SPS DCS 6000 P
Drawing
DC 6190 P
ACC-DC 61xx 10PK
Certifications
The DCS 6000 system conforms to standard IEC 60914.
Loading...