Shure DC 6120 P,DC 6120 P Datasheet
DC 6120 P Conference Unit
• Chairman and delegate functionality in one unit
• Lockable XLR microphone connector
• Loudspeaker
• Headphone jack with volume control for the floor channel
• Exchangeable buttons
DIS Digital Conference Systems
DC 6120 P Conference Unit
Description
The DC 6120 P is a fully digital portable conference unit in the DIS DCS 6000
Digital Conference System.
The unit can be configured either as a chairman or a delegate unit. The unit's default configuration is the delegate configuration.
To configure the unit, the mute and the microphone button must be kept down
while pressing the volume up button for 10 seconds for chairman functionality or
the volume down button for delegate functionality. The button light guides flash
when the unit is configured and the unit reboots. The configuration is stored in the
unit so it recalls its configuration if it is used in another system setup.
The left button is a function button that changes functionality depending on the
configuration. The chairman configuration enables 'all delegates off' functionality
in the left button while the delegate configuration enables 'mute' functionality in the
left button.
The function button can be changed to match the current functionality by pushing
the button out of the unit from below. The new button is then simply pressed into
the unit.
The all delegates off button enables the user to turn off all active delegate
microphones.
The mute button enables the user to temporarily mute the active microphone, while
the mute button is held down.
The microphone button enables the user to activate/deactivate the microphone.
The floor channel is distributed through the built-in loudspeaker except when the
microphone is turned on. The user can also listen to the floor channel by inserting headphones in the headphone jack and adjusting the volume with the volume
buttons.
The gooseneck microphones GM 652x or GM 6622 can be locked to the unit with
a 1.5 mm hex key. The lock is accessible from the small hole below the DIS logo
on the side of the XLR socket. Turn the hex key counter clockwise to lock the
gooseneck microphone to the unit and turn the hex key clockwise to unlock the
gooseneck microphone from the unit.
The DC 6120 P can be combined with any conference units from the DCS 6000
Digital Conference System.
Features
The DC 6120 P has the following standard features:
• Standard conference unit for chairmen and delegates
• Fully digital audio transmission
• Daisy chain topology with loop-through connections or star
topology using junction boxes
• CAT 5e (or higher) F/UTP or U/FTP cabling
• Maximum 3800 conference units per system
• Support for four microphone operation modes; Automatic,
FIFO, Manual and VOX (voice activation)
• Support for three microphone interrupt ability modes enabling
'ping pong' mode
• Auto off of microphones
• Lockable XLR gooseneck microphone connector
• One high-quality loudspeaker
• One headphone connector with volume control supporting the
floor channel
• One headphone jack
• Microphone and function (all delegates off/mute) buttons
• Exchangeable buttons for changing the button labels to other
languages and other functionality
Data sheet DS-DC6120 P-e
Specifications
How To Order
Electrical
Frequency response (chan-
nel selector)
Frequency range
(loudspeaker)
Power consumption 2.5 W
Power maximum
(loudspeaker)
Signal-to-noise ratio > 90 dBA
Headphone connection
65 Hz-16 kHz
150 Hz-15 kHz
3.0 W RMS
THD < 0.1 %
3.5 mm jack, female stereo
socket
Interconnections
DCS-LAN
Two RJ45 female sockets with
auto-termination
Mechanical
Mounting Tabletop
Dimensions (H x W x D) 61 x 150 x 168 mm
Weight 650 g
Color Black
Temperature range 5° to 40° C
Conference unit
DC 6120 P (incl. CM button) 15 12 59030
Please notice that gooseneck microphones GM 652x/6622 and headphones DH 6021 must be ordered separately.
DRAWING
Certifications
The DCS 6000 system conforms to standard IEC 60914.
Data subject to change without notice.
Loading...