Page 1
(Shown with optional CVD desktop base)
15 – 30 cm
(6 – 12 in.)
22 mm
(7/8 in.)
Centraverse™ Series
Installed Sound Microphones
CVG
Centraverse Gooseneck Microphone
The Shure Centraverse CVG is a professional gooseneck electret condenser microphone for use in general
installed sound reinforcement applications. With dual
gooseneck sections for full articulation, the CVG12/18
provides scalable, best-in-class performance in a wide
variety of locations, including podiums and desktops.
Features
• Cardioid polar pattern with tailored response for
speech
• Dual-section gooseneck enables ease of
positioning and placement options
• Three model variations with inline preamps:
standard, mute switch, and light ring indicator
• Available in 12” (30.4 cm) and 18” (45.7 cm)
gooseneck lengths
• Commshield® technology guards against unwanted
RF interference from portable wireless devices
(smartphones, etc.)
• Included flange mount and snap-fit windscreen
Model Variations
① Gooseneck Length
12: 12" gooseneck
18: 18" gooseneck
② Mute Button and LED Indicator*
S: Includes mute button and bi-color LED on microphone body
RS: Includes mute button and On/Off colored indicator ring
*The Standard model does not feature a mute switch or LED
③ Color
B: Black
④ Polar Pattern
C: Cardioid
Installation
1. Drill a 22 mm (7/8 in.) hole in the mounting surface for the flange and three additional holes for the screws.
2. Screw the flange into place, and then set the microphone into the center hole.
3. Connect the microphone to a mixer or P.A. system using an XLR cable.
Note: This microphone requires +48V phantom power to operate.
Mute Button Operation
Press the button on the microphone body to turn
the mute on/off. The standard model does not feature a mute button.
1. CVG12S: Mute is indicated by an LED on the
microphone body:
• Green = Microphone is on
• Red = Microphone is muted
2. CVG12RS: Mute is indicated by a light ring on
the microphone head:
• Red = Microphone is on
• Off = Microphone is muted
Guidelines For Use
1. Maintain a distance of approximately 15 - 30 cm
(6 - 12 in.) between the sound source and the
microphone.
2. Always use the supplied windscreen to control plosives and wind noise.
Note: Model availability depends on region. See
your local Shure dealer or distributor for details.
©2013 Shure Incorporated
27A20375 (Rev. 1)
Page 2
Specifications
Accessories
Cartridge Type
Electret Condenser
Polar Pattern
Cardioid
Frequency Response
70–16000 Hz
Output Impedance
180Ω
Sensitivity
open circuit voltage, @ 1 kHz, typical
–33 dBV/Pa[1] (22 mV)
Maximum SPL[2]
1 kHz at 1% THD
120 dB SPL
Signal-to-Noise Ratio[3]
Ref. 94 dB SPL at 1 kHz
67 dB
Dynamic Range
93 dB
Self Noise
equivalent SPL, A-weighted, typical
27 dB SPL
Preamplifier Output Clipping Level
@ 1 kHz, at 1% THD
-7 dBV
Common Mode Rejection
10 Hz to 100 kHz
>45 dB
Polarity
Positive pressure on diaphragm produces positive
voltage on pin 2 with respect to pin 3
Environmental Conditions
Operating
–18 to 57°C (0 to 135°F)
Temperature
Storage
–29 to 74°C (–20 to 165°F)
Temperature
Relative
0 to 95%
Humidity
Power Requirements
CVG 11–52 V DC[4], 2.0 mA
CVG/S 11–52 V DC[4], 5.5 mA
CVG/RS 11–52 V DC[4], 5.0 mA
Weight
CVG/12 6.3 oz. (177 g)
CVG/18 6.8 oz. (191 g)
[1] 1 Pa=94 dB SPL
[2] THD of microphone preamplifier when applied input sig-
nal level is equivalent to cartridge output at specified SPL
[3] S/N ratio is the difference between 94 dB SPL and
equivalent SPL of self noise, A-weighted
[4] All specifications measured with a 48 Vdc phantom
power supply. The microphone operates at lower voltages,
but with slightly decreased headroom and sensitivity.
Furnished Accessories
Windscreen 95A16670
Mounting Flange RPM640
Optional Accessories
Desktop Base CVD-B
Replacement Windscreens (4-pack) ACVG4WS-B
Microphone Clip A57F
25’ XLR Cable C25J
Shock Mount A400SM
Certifications
Meets essential requirements of all applicable European
Directives.
Eligible for CE marking.
The CE Declaration of Conformity can be obtained from
Shure Incorporated or any of its European representatives.
For contact information please visit www.shure.com
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
Page 3
20
Hz
15
2 ft. (0.6 m) from sound source
10
5
0
-5
dB
-10
-15
-20
-25
-30
20 100 1k 10k 20k
CVG-18
250 Hz
500 Hz
1,000 Hz
CVG-12
58.09 cm (22.87 in)
44.09 cm (17.36 in)
Europe, Middle East, Africa:
Shure Europe GmbH
Jakob-Dieffenbacher-Str. 12,
75031 Eppingen, Germany
Phone: 49-7262-92490
Fax: 49-7262-9249114
Email: info@shure.de
2,000 Hz
4,000 Hz
15.09 cm
(5.95 in)
15.09 cm
(5.95 in)
PT. GOSHEN SWARA INDONESIA
Kompleks Harco Mangga Dua Blok L No. 35 Jakarta Pusat
I.16.GSI31.00501.0211
Loading...