SHUOYING PA0852 User Manual

PA0852 User Guide

SHUOYING INDUSTRIAL（SHENZHEN）CO.,LTD

shuoying Road,Hebei Industry Area,Dalang,LongHua

FCC DECLARATION

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) Th is dev ice may not caus e harmfu l interfe rence, and (2) this device must accept any interference received, including interference that may cause undesired opera tion. Privacy of communications may not be ensured when using this device. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the inst ruct ions, may ca use ha rmfu l int erf erence to rad io communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the us er is encouraged t o try to correc t the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

Town,Baoan,Shenzhen,China

which the receiver is connected.

- Consult the dealer or an experienced radio TV technician for help. Pertinent testing documentation is available for verification.

- FCC RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Attention: This handbook contains importa nt security measures and product information essential for using the device safely. Please read this manual carefully before using the device. z Do not place the device in high temperatures, moist areas or very dusty

places.

z During seasons with hot temperatures do not leave the device in a car with

the windows closed.

z This tablet is a sophisticated device. Please handle with care and do not

drop as it may damage the display screen.

z Please choose the appropriate v olume. When utilizi ng head p hone s plea se

ensure the volume is not set at high level.

z Charge the device under the following conditions,

A、 The battery power ICONS show there is no power B、 The system automatically shuts off C、 The Operation buttons does not respond

z Do not disconnect the device when it is formatting, downloading or

uploading a file as it can cause an application error.

z Follow the user manual for standardized operational use of the device. z Don’t disassemble the product. Do not use alcohol, thinner or benzene to

scrub the product.

z Don't use the device in a place that prohibits use of electronic equipment. z Please don't use the Tablet PC when you are driving or walking down the

street.

z USB is only to be used for data transmission.

The company reserves the right to improve the product, product specifications and design and/or make any other change s. Th e inf ormatio n is s ubject to ch ange without prior notice.

(This tablet does not have a waterproof function)

【Remark】All pictures in this manual are only for your reference. The products specification and design may change. The information is subject to change without prior notice.

1. Appearance and button:

Vo l- Vol + E SC

Headphone Jack

Touch Panel

1.1 Touch panel

8” Capacitive touch panel: In the Operation, to click, drag on the touch

panel

1.2 POWER

Startup: Hold down the power button for several seconds. The tablet will turn

on and then the system will enter the main interface. Shutdown: In the main menu interface, Press the power button for several

seconds to shutdown, The sy stem w ill hint th e "pow er off" option, Click ”ok”. Now you can safely shut down.

Turn off screen: When the screen is on, short press Power button to turn off screen. Short press Power button again to turn on screen. Remark 1.When the power is depleted the system will shut down automatically.

2. Restart will scan and restore the disk. It may take a longer time to

enter into system.

1.3 Home

Press the Home button to return to the last interface.

1.4 Volume +, Volume-

Use the buttons on the top Volume + and Volume- to adjust the volume.

1.5 Headphone jack

3.5 mm standard headphone jack

1.6 TF card

TF-CARD slot: external T-FLASH card

1.7 Micro USB

Micro USB jack: can be used to connect the computer for data transmission,

charging and an external connection for a USB flash drive.

1.8 Power Jack

One end of the AC adaptor can be inserted to the Power Jack and then the charger is inserted to a standard AC wall outlet to charge the battery of the tablet.

1.9 Reset

In case the operation of the tablet is interrupt ed for any reason, press Reset button to reset and resume operation.

2. First use

2.1 Battery management and charge

Prior to first use, make sure the battery is fully charged To charge simply connect the adaptor or USB interface. Charge for six hours for the first two times .Following that the battery need only be charged for 4 hours. 【Remark】: This tablet has a Built-in type Lithium ion battery, To charge, use a standard adaptor (Input: AC100~240V 50/60Hz Max：0.3A. Output: DC5V/2A). Without adaptor, use USB cable to connect to micro USB jack of the tablet and USB port on your computer to charge. While charging, the battery icon will scroll. When charging is complete the battery icon will become green and stop scrolling. In order to prolong the service life of the device, let the battery deplete before charging. 【Remark】: 1. Charge the battery at least once a month to avoid power consumption caused damage.

2、After low battery shut down, connect the DC adaptor. While charging, you will need to wait some time until the battery has enough power to switch on and enter into main menu.

3. Device charging should be in standby status to reach normal charging

time; charging time may take longer if using the tablet during charging.

2.2 Connection with PC

Use USB cable to connect the device to a PC. After several seconds, click the right bottom corner of th e scre en. A menu comes out on the right bottom corner. Click the option ‘USB connected’. The device will pop up the USB connection window. Click Turn on USB storage to connect to PC

In storage mode, it can copy; delete the file on the device and the file on the memory card.

3. Equipment operation interface

3.1 Unlock Interface After start up, the Locking interface will be as follows:

Tablet can operate only after unlocking. Unlocking method: touch the right Lock ic on, drag it nex t to a lock at the right and then release. The system will be unlocked and will enter the main interface.

3.2 Main interface description The main interface of the handheld tablet includes two modes: the small tools

on the desktop mode and the icons of application programs mode, both of which can be switched between each other via the buttons at the corners. The mode of small tools on the desktop is shown as follows:

Tap button at the top right corner to enter the interface of icon modes for

application programs, which is shown as follows:

Tap

Note: If the tablet is switched on for the first time after being purchased, it will automatically install the built-in application programs. The tablet may operate slowly and some hints may appear on the screen. After installation of programs has been completed, the operation of tablet resumes normal.

3.3 Shortcut Mode Under the interface of the mode of sm all tools on the desktop, af ter t appi ng Men u button, the Shortcut menu will pop up at the bottom of the screen, shown as follows:

button to enter the desktop interface.

3.4 Usage of Small Tools on Desktop

Users can add or delete the small tools on the desktop, as well as add or delete icons of application programs or adjust the positions of icons; the icons can be dragged within the working zone of the desktop. Under the interface of the mode of small tools on the d esktop, press an d hold the icons of small tools, a sign of ‘Remove’ will pop up in the central top edge of the desktop. At that time, you are able to drag the icon anywhere on the desktop, or drag it directly to the ‘Remove’ sign to delete it.

Menu button

+ 23 hidden pages