ShoreLand'r SS913 User Manual
®
SS913
Front Roller Arm Assembly
For 2X5 Frames Only
SS913 Front Roller Arm
REF# PART# DESCRIPTION QTY
1 0210127 3/8” X 3” CARR BOLT W/1” THRDS 4
2 0210130 3/8” X 3-3/4” CARR BOLT .............. 1
3 0210220 1/2” X 4-1/2” CARR BOLT .............. 1
4 0240210 1/2” X 3 “ CARR BOLT ................... 2
5 1310121 3/4” USS FLAT WASHER............... 8
6 1410109 3/8” HEX NUT ................................ 1
7 1440102 1/2” FLANGE LOCK NUT............... 3
8 1540350 BULL RING .................................... 8
9 3510538 MOLDED REAR CROSSMEMBER 1
10 1440100 3/8” HEX LOCK NUT...................... 4
11 S-3184 PLSTC MOLDED SWIVEL BLOCK 2
12 S-3382 5” ROLLER W/MOLDED HUB ....... 8
13 S-3383 MOLDED ROLLER BUSHING ....... 8
14 66888-- ROLLER ARM MTG BRACKET ..... 1
15 62087 PLASTIC SPACER......................... 1
16 S-3368 WHITE IN-LINE ROLLER PIN........ 8
17 S-3384 2” OD X 1.150 ID FLAT WASHER .. 8
18 61913-- ROLLER ARM ................................ 8
19 1340030 3/8” S/TMED LOCK WASHER ....... 1
20 1340095 3/8” USS FLAT WASHER............... 1
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com 0003040
NOTE: SS913 consists of only one (1) front roller arm assembly.
Place the roller arm mounting bracket (Ref.#14) onto the
front crossmember using a 1/2” X 4-1/2” carriage bolt
(Ref.#3) and secure with 1/2” flange lock nut (Ref.#7).
Insert the plastic spacer (Ref.#15) into the roller arm
mounting bracket. Mount the roller assembly into the roller
arm mounting bracket just installed using two (2) 1/2” X 3”
carriage bolt (Ref.#4) and securing the two (2) 1/2” flange
lock nuts (Ref.#7). Adjust the roller assmbly to the proper
position and tighten the 1/2” flange lock nuts. Repeat the
same roller assembly mounting instructions on the opposite
side of the trailer.
Place the 3/8” X 3-3/4” carriage bolt (Ref.#2) through the
hole in the molded crossmember pad (Ref.#9). Place into
position as shown in the drawing. Secure with a 3/8” USS
flat washer (Ref.#20) and 3/8” S/T medium lock washer
(Ref.#19). Secure with 3/8” hex nuts (Ref.#6).
Mounting Instructions
REV 4/23/02
Loading...