Shop fox D4532 User Manual

Model D4532

#16600TS

Wide Single Mini

ON/OFF Switch

Instruction Sheet

Phone #: [phone] • Online Tech Support: [e-mail] • Web: www.shopfox.biz

To reduce risk of serious burns, electrocu­tion or death when installing this switch:

• Only use this switch to replace an exist­ing component switch that has the same
physical configuration and equivalent
electrical specifications/ratings.

• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.

• Turn OFF and completely disconnect all
power sources to the component before
installing the switch.

Figure 1. D4532 Wide Single Mini ON/OFF

Switch.

Introduction

The Model D4532 features a wide single ON/
OFF toggle switch and fits into a
rectangular hole.

3

⁄4" x 7⁄8"

• Only install this switch on the "hot" wires.
Do not install it on the neutral or ground
wires. Otherwise, the component could
still be receiving live current even when
the switch is turned OFF.

• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or
rated for these environments.

• Make sure there is a verified compo­nent ground on the circuit this switch is
installed.

Specifications

Rated Voltage ............................125V/250V

Rated Current ...................................... 6A

COPYRIGHT © MAY, 2014 BY WOODSTOCK INTERNATIONAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in China

D4532 Wide Single Mini ON/OFF Switch

Installation

When installing the D4532 switch, use the wiring
diagram in Figure 2 to ensure proper wire
connections.

This switch is intended to be connected to
stranded wire with insulated quick-discon­nect crimp-type female wire terminals hav-

1

ing a

All crimps must be "pull-checked" to ensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal machine vibration.

⁄4" tab.

Power Source

Hot

In

ON

Rear View

(|)

of Switch

OFF

(O)

Hot
Out

Component

KEDU HY39

Verified
Ground*

Figure 2. D4532 wiring diagram.

*The component MUST be connected to
a verified ground. In the event of certain
malfunctions or breakdowns, grounding reduces
the risk of electric shock by providing a path of
least resistance for electric current.

-2-