Shop fox D4166 User Manual

Model D4166

#16597TS

Safety Locking ON/OFF

Switch

Instruction Sheet

Phone #: [phone] • Online Tech Support: [e-mail] • Web: www.shopfox.biz

To reduce risk of serious burns, electrocution
or death when installing this switch:

• Only use this switch to replace an existing
machine switch that has the same physical
configuration and equivalent electrical
specifications/ratings.

Safety

Key

• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.

• Turn OFF and completely disconnect all
power sources to the machine before
installing the switch.

• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or
rated for these environments.

• Make sure there is a verified machine
ground on the circuit this switch is
installed.

Figure 1. D4166 Safety Locking ON/OFF Switch.

Introduction

The Model D4166 features a large ON/OFF
paddle with a removable safety key that can
be used to disable the switch. This switch is
designed to fit into
or be mounted over a 1
hole with four #5 screws.

7

⁄8" x 1 1⁄2" rectangular hole

1

⁄8" x 2 1⁄4" rectangular

Specifications

Rated Horsepower ................................2HP

Rated Voltage ............................ 125V/250V

Rated Current Amperage ........................ 20A

COPYRIGHT © MAY, 2014 BY WOODSTOCK INTERNATIONAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in China

D4166 Safety Locking ON/OFF Switch

Installation

When installing the D4166 switch, use the wiring
diagram in Figure 2 to ensure proper wire
connections.

This switch is intended to be connected to
stranded wire with insulated quick-discon­nect crimp-type female wire terminals hav-

1

ing a

All crimps must be "pull-checked" to ensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal machine vibration.

⁄4" tab.

Machine

Verified

Ground*

Operation

To turn the switch ON, make sure the safety key
is properly inserted, then flip the paddle up.

To turn the switch OFF, flip the paddle down.

To disable the switch, turn the switch OFF, then
pull the yellow key from the switch and store it
in a well hidden or secure location.

Hot
Out

Out

125V Neutral

or 250V Hot

Rear View

KEDU

Hot

In

Power Source

125V Neutral

or 250V Hot

HY18-XX

In

of Switch

Figure 2. D4166 wiring diagram.

*The machine MUST be connected to a verified
ground. In the event of certain malfunctions
or breakdowns, grounding reduces the risk
of electric shock by providing a path of least
resistance for electric current.

-2-