Shop fox D4151 User Manual
Model D4151
#16593TS
120V/230V ON/OFF
Paddle Switch
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
To reduce risk of serious burns, electrocution
or death when installing this switch:
• Only use this switch to replace an existing
machine switch that has the same physical
configuration and equivalent electrical
specifications/ratings.
• Installation must only be performed by an
electrician or qualified service personnel,
and all applicable electrical codes must
be adhered to.
Figure 1. D4151 ON/OFF Paddle Switch.
• Turn OFF and completely disconnect all
power sources to the machine before
installing the switch.
• Do not use this switch in wet or damp
locations, or near explosive fumes or
flammable liquids. It is not sealed or
rated for these environments.
• Make sure there is a verified machine
ground on the circuit this switch is
installed.
Introduction
The Model D4151 features a recessed START
button that can be disabled with a padlock, and
a large STOP paddle that ensures fast shut-off.
Specifications
Rated HP @ 120V ................................2 HP
Rated HP @ 230V ................................3 HP
Rated Voltage Range .................... 120V/230V
Rated Current @ 125V ........................... 35A
Rated Current @ 230V ........................... 20A
Resistive Rating ............................600V/15A
Padlock Shaft Size ...............................
3
⁄16"
COPYRIGHT © MAY, 2014 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
D 4151 120V/2 30V ON/OFF Paddle Switch
Installation
When installing the D4151 switch, use the wiring
diagram in Figure 2 to ensure proper wire
connections.
This switch is intended to be connected to
stranded wire with insulated crimp-type
ring wire terminals.
All crimps must be "pull-checked" to ensure
that wires are securely crimped and will
not fall out with moderate tension or when
exposed to normal machine vibration.
Machine
Verified
Ground*
Hot
Out
Load
KEDU
HY56
Line
Hot
In
Power Source
Out
120V Neutral
or 230V Hot
Rear View
of Switch
In
120V Neutral
or 230V Hot
Disabling & Locking Switch
The switch can be disabled and locked by
inserting a padlock through the ON/START
button, as shown. Locking the switch in this
manner can prevent unauthorized operation of
the machine, which is especially important if the
machine is not stored inside an access-restricted
building.
IM PO R TA NT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Shaft
ON / START
Button
OFF / STOP
Paddle
Figure 3. Switch disabled by padlock.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a wellhidden or secure location.
Padlock
Figure 2. D4151 wiring diagram.
The padlock shaft diameter is important to
the disabling function of the switch. With
any padlock used to lock the switch, test the
switch after installation to ensure that it is
properly disabled.
-2-
Loading...