Shop fox D3124 User Manual
D3124 OPTIONAL
3
0
0
1
EXTENSION TABLE
INSTRUCTION SHEET
Important
• READ and understand your shaper Instruction
Manual before using this extension table. Otherwise,
serious personal injury may occur!
• Woodstock International Inc.
damage or injuries caused by improper installation
or use of the Optional Extension Table.
• DO NOT modify this Optional Extension Table in
any way to fit on a different brand of shaper, or
modify it for a job that it is not designed for.
• DO NOT use the table edge as a fulcrum to pivot
heavy lumber onto the table, as this may damage
the table and laminate edge.
• DO NOT store the table in a damp or a very hot
location. The table is made of wood and it may
warp, delaminate, or catch fire.
REF PART # DESCRIPTION
1 XPW02 FLAT WASHER
2 XPB18 HEX BOLT
is not responsible for
3
⁄8"
3
⁄8"-16 x 1"
2
1
Introduction
Made with high-quality laminated wood in a reinforced
design, this 23" deep x 40" wide extension table snugly
®
fits the SHOP FOX
Model W1674 2 HP Shaper table.
Covered with strong laminate, this economical and
light-weight extension table will last many years. The
miter slot is also slightly wider than that of the table for
ease of miter alignment
.
UNPLUG the shaper during
installation. Otherwise,
serious personal injury
may occur!
GET installation assistance
to hold the extension table
in position while you bolt
it to the shaper table.
Installation
To install the extension table, do these steps:
1. Have an assistant hold the extension table in
position so it mates flush with the shaper table.
Figure 1. Extension table and mounting hardware.
SHOP FOX® is a registered trademark of Woodstock International, Inc.
COPYRIGH T © 2 00 3 BY WO OD STOCK INT ER NA TI ON AL , INC. WARNING: NO PORTION OF THIS DOCUMENT M AY
BE REPRODUCED I N ANY S HA PE OR FORM W IT HO UT THE WR ITTEN A PP RO VA L OF WO OD STOCK INT ER NA TI ON AL , INC.
2. Install seven 3⁄8" flat washers and seven 3⁄8"-16 x
1" bolts and tighten finger tight. See Figure 1.
3. Hold tables flush with one another and tighten
the mounting bolts in an alternating pattern until
snug.
4. For questions on this product, contact your dealer,
or call Woodstock International Technical Support
Department at 1-360-734-3482, or e-mail us at:
tech-support@shopfox.biz.
shop fox.biz
Loading...