Shindaiwa M235, T235 Operator's Manual

M235 Multi-Tool

Operator’s Manual

ENGLISH

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

Read and understand operator’s manual (and safety manual if included) before use. Failure to read the manuals could result in serious injury.

Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice. Illustrations may include optional equipment and accessories, and may not include all standard equipment.

X7732275501

TABLE OF CONTENTS M235

TABLE OF CONTENTS

Table of Contents ........................................................................................ 2

Introduction ................................................................................................. 3

Servicing Information .................................................................................. 3

Parts/Serial Number ............................................................................ 3

Service................................................................................................. 3

Consumer Product Support ................................................................. 4

Product Registration ............................................................................ 4

Additional or Replacement Manuals .................................................... 4

Safety.......................................................................................................... 4

Manual Safety Symbols and Important Information............................. 4

International Symbols .......................................................................... 5

Personal Condition and Safety Equipment .......................................... 7

Equipment.......................................................................................... 12

Emission Control (Exhaust & Evaporative) .............................................. 14

CARB And EPA Emissions Control Information................................. 14

Description ................................................................................................ 15

Contents.................................................................................................... 16

Assembly................................................................................................... 17

Power Head Shaft to Lower Shaft Assembly ..................................... 17

Support Handle Installation................................................................ 18

Operation .................................................................................................. 18

Fuel.................................................................................................... 19

Starting Cold Engine.......................................................................... 22

Stopping Engine ................................................................................ 24

Maintenance ............................................................................................. 25

Skill Levels......................................................................................... 25

Maintenance Intervals........................................................................ 25

Air Filter ............................................................................................. 27

Fuel Filter........................................................................................... 27

Spark Plug ......................................................................................... 28

Cooling System.................................................................................. 28

Exhaust System................................................................................. 30

Carburetor Adjustment....................................................................... 32

Lubrication ......................................................................................... 33

Troubleshooting......................................................................................... 34

Storage...................................................................................................... 36

Long Term Storage (Over 30 Days) ................................................... 36

Specifications............................................................................................ 37

SHINDAIWA Optional Attachments ................................................... 38

Product Registration.................................................................................. 38

2 X7732275501

M235 INTRODUCTION

INTRODUCTION

This product was designed and manufactured to provide long life and onthe-job dependability. Read and understand all provided literature. Keep manuals in a safe place for future reference. Literature contains specifications and information for safety, operation, maintenance, storage and assembly specific to this product. Scan QR codes for more information.

For questions regarding terms used in this manual, visit:

https://www.echo-usa.com/Support-Help/TechnicalDocuments

https://www.shindaiwa-usa.com/Tech-Support/TechnicalDocuments

SERVICING INFORMATION

ENGLISH

Parts/Serial Number

Genuine SHINDAIWA Parts and Assemblies for your SHINDAIWA products are available only from an Authorized SHINDAIWA Dealer. When you do need to buy parts always have the Model Number and Serial Number of the unit with you. You can find these numbers on the engine housing. For future reference, write them in the space provided below.

Model No. _________________ Serial No. _________________

Service

Service of this product during the warranty period must be performed by an Authorized SHINDAIWA Service Dealer. For the name and address of the Authorized SHINDAIWA Service Dealer nearest you, ask your retailer or call: 1-877-986-7783. Dealer information is also available on WWW.SHINDAIWA-USA.COM. When presenting your unit for Warranty service/repairs, proof of purchase is required.

X7732275501 3

SAFETY M235

Consumer Product Support

If you require assistance or have questions concerning the application, operation or maintenance of this product you may call the SHINDAIWA Consumer Product Support Department at 1-877-986-7783 from 8:00 am to 5:00 pm (Central Standard Time) Monday through Friday. Before calling, please know the model and serial number of your unit.

Product Registration

To ensure trouble free warranty coverage it is important that you register your SHINDAIWA equipment on-line at WWW.SHINDAIWA-USA.COM or by filling out the product registration sheet included in this manual. Registering your product confirms your warranty coverage and provides a direct link between you and ECHO if we find it necessary to contact you.

Additional or Replacement Manuals

Replacement Operator and Parts Catalogs are available from your

SHINDAIWA dealer or at WWW.SHINDAIWA-USA.COM or by contacting the Consumer Product Support Department (1-877-986-7783). Always check WWW.SHINDAIWA-USA.COM for updated information.

SAFETY

Manual Safety Symbols and Important Information

Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you.

The safety alert symbol accompanied by the word “DANGER” calls attention to an act or condition which WILL lead to serious personal injury or death if not avoided.

The safety alert symbol accompanied by the word “WARNING” calls attention to an act or condition which CAN lead to serious personal injury or death if not avoided.

4 X7732275501

M235 SAFETY

The safety alert symbol accompanied by the word “CAUTION” calls attention to an act or condition which may lead to minor or moderate personal injury if not avoided.

The enclosed message provides information necessary for the protection of the unit.

Note: This enclosed message provides tips for use, care and

maintenance of the unit.

CIRCLE AND SLASH SYMBOL This symbol means the specific action shown is prohibited. Ignoring these prohibitions can result in serious or fatal injury.

International Symbols

ENGLISH

Symbol Description Symbol Description

Warning, See

Operator’s Manual

Wear Eye, Ear

and Head

Protection

Wear Hand and

Foot Protection

Safety / Alert Emergency Stop

Carburetor

Adjustment - High

Speed Mixture

Carburetor

Adjustment - Idle

Speed

Carburetor

Adjustment - Low

Speed Mixture

X7732275501 5

SAFETY M235

Symbol Description Symbol Description

Hot Surface Fuel and Oil Mixture

AVOID KICKOUT

Keep Bystanders At Least

15 m (50 ft.) Away

Beware Thrown Objects

Wear Eye Protection

Keep Bystanders and Helpers

Away 15 m (50 ft.)

DO NOT Allow

Flames or Sparks

Near Fuel

DO NOT Smoke

Near Fuel

Choke Control

“RUN” Position

(Choke Open)

Keep Feet Away

From Blade

Ignition

ON / OFF

Primer Bulb

Choke Control “COLD START” Position (Choke

Closed)

Rotating Cutting

Attachment

Thrown Objects Wear Face Shield

6 X7732275501

M235 SAFETY

Symbol Description Symbol Description

Finger Severing

Do not operate

closer than 15 m

(50 ft.) from

electrical hazards.

Keep bystanders

a t l ea st 1 5 m (50 ft.) away.

Plan retreat path

from falling

objects.

Wear Slip Resistant

Footwear

ENGLISH

DO NOT USE

BLADES - Line

Head Only

Personal Condition and Safety Equipment

Cancer and Reproductive Harm www.P65Warnings.ca.gov

X7732275501 7

SAFETY M235

The muffler or catalytic muffler and surrounding cover may become extremely hot. Always keep clear of exhaust and muffler area, otherwise serious personal injury may occur.

Users of this product risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating unit.

Physical Condition

Your judgment and physical dexterity may not be good:

• If you are tired or sick

• If you are taking medication

• If you have taken alcohol or drugs

Operate unit only if you are physically and mentally well.

Eye Protection

◆ Eye protection that meets ANSI Z87.1 or CE requirements

must be worn whenever you operate the unit.

◆ For additional safety, a full-face shield may be worn over

safety glasses or goggles to provide protection from sharp branches or flying debris.

Hand Protection

Wear sturdy, no-slip, rubber work gloves to improve your grip on the handles. Gloves also provide protection against cuts and scratches, cold environments, and reduce the transmission of machine vibration to your hands.

Hearing/Ear Protection

ECHO recommends wearing hearing protection whenever unit is used.

8 X7732275501

M235 SAFETY

Breathing Protection

Operators who are sensitive to dust or other common airborne allergens may need to wear a dust mask to prevent inhaling these materials while operating unit. Dust masks can provide protection against dust, plant debris, and other plant matter such as pollen. Make sure the mask does not impair your vision, and replace the mask as needed to prevent air restrictions.

Proper Clothing

Wear snug-fitting, durable clothing:

• Pants should have long legs, shirts should have long sleeves.

• DO NOT WEAR SHORTS.

• DO NOT WEAR TIES, SCARVES, JEWELRY, or clothing with loose or hanging items that could become entangled in moving parts or surrounding growth.

• Keep clothing buttoned or zipped, and keep shirt tails tucked in.

ENGLISH

Wear sturdy work shoes with nonskid rubber soles:

• DO NOT WEAR OPEN TOED SHOES.

• DO NOT OPERATE UNIT BAREFOOTED.

Keep long hair away from engine and air intake. Retain hair with cap or net.

Heavy protective clothing can increase operator fatigue, which may lead to heat stroke. Schedule heavy work for early morning or late afternoon hours when temperatures are cooler.

The components of this machine generate an electromagnetic field during operation, which may interfere with some pacemakers. To reduce the risk of serious or fatal injury, persons with pacemakers should consult with their physician and the pacemaker manufacturer before operating this machine. In the absence of such information, ECHO does not recommend the use of this machine by anyone who has a pacemaker.

X7732275501 9

SAFETY M235

Extended Operation / Extreme Conditions

Prolonged exposure to cold and/or vibration may result in injury. Read and follow all safety and operation instructions to minimize risk of injury. Failure to follow instructions may result in painful wrist/hand/arm injuries.

It is believed that a condition called Raynaud’s Phenomenon, which affects the fingers of certain individuals, may be brought about by exposure to vibration and cold. Exposure to vibration and cold may cause tingling and burning sensations, followed by loss of color and numbness in the fingers. The following precautions are strongly recommended, because the minimum exposure, which might trigger the ailment, is unknown.

• Keep your body warm, especially the head, neck, feet, ankles, hands, and wrists.

• Maintain good blood circulation by performing vigorous arm exercises during frequent work breaks, and also by not smoking.

• Limit the hours of operation. Try to fill each day with jobs where operating the unit or other handheld power equipment is not required.

• If you experience discomfort, redness, and swelling of the fingers followed by whitening and loss of feeling, consult your physician before further exposing yourself to cold and vibration.

10 X7732275501

M235 SAFETY

Repetitive Stress Injuries (RSI)

It is believed that overusing the muscles and tendons of the fingers, hands, arms, and shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI). An extreme RSI condition is Carpal Tunnel Syndrome (CTS), which could occur when your wrist swells and squeezes a vital nerve that runs through the area. Some believe that prolonged exposure to vibration may contribute to CTS. CTS can cause severe pain for months or even years.

To reduce the risk of RSI/CTS, do the following:

ENGLISH

• Avoid using your wrist in a bent, extended, or twisted position. Instead try to maintain a straight wrist position. Also, when grasping, use your whole hand, not just the thumb and index finger.

• Take periodic breaks to minimize repetition and rest your hands.

• Reduce the speed and force with which you do the repetitive movement.

• Do exercises to strengthen the hand and arm muscles.

• Immediately stop using all power equipment and consult a doctor if you feel tingling, numbness, or pain in the fingers, hands, wrists, or arms. The sooner RSI/CTS is diagnosed, the more likely permanent nerve and muscle damage can be prevented.

All over head electrical conductors and communications wires can have electricity flow with high voltages. This unit is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death may result.

Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death.

X7732275501 11

SAFETY M235

Read the Manuals

• Provide all users of this equipment with the Operator’s Manual for instructions on safe operation.

Clear the Work Area

• Spectators and fellow workers must be warned, and children and animals prevented from coming nearer than 15 m (50 ft.) while the unit is in use.

Keep a Firm Grip

• Always hold throttle handle and support handle with thumbs and fingers tightly encircling the handles.

Keep a Solid Stance

• Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not over reach.

Avoid Hot Surfaces

• During operation, the drive shaft housing and attachment bearing housing may become very hot, too hot to touch. Avoid contact during and immediately after operation.

Equipment

Use only SHINDAIWA attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and safety manual.

◆ Check unit for loose/missing nuts, bolts, and screws.

Tighten and/or replace as needed.

◆ Inspect guards and shields for damage and to ensure that

they are securely in place. Replace if damaged or missing.

◆ Check that the attachment is firmly attached and in safe

operating condition.

12 X7732275501

+ 28 hidden pages

Shindaiwa M235, T235 Operator's Manual

Specifications and Main Features

Frequently Asked Questions

User Manual