Shindaiwa 80702, SP518 User Manual
WARNING!
Minimize the risk of injury to
yourself and others! Read this
manual and familiarize yourself with
the contents. Always wear eye
protection, gloves and a respirator
when operating this unit.
SHINDAIWA OWNER’S/OPERATOR’S MANUAL
SP518 BACK PACK SPRAYER
Shindaiwa Inc.
11975 S.W. Herman Road
Tualatin, Oregon 97062
Telephone: 503 692-3070
Fax: 503 692-6696
www.shindaiwa.com
䊚2002 Shindaiwa, Inc.
Part Number 80702
Revision 4/02
Shindaiwa is a registered trademark
of Shindaiwa, Inc.
Specifications subject to change without notice.
Printed in Brazil
䉸
䉸
䊛
Part Number 80702 Rev. 4/02
Introduction
This manual contains information for the proper assembly,
operation and care of your SP518 sprayer. Carefully read and
follow the instructions contained in this manual before operating your sprayer.
Cap
Pump
Chamber
Packing Ring
Nut
Lever
Vent
Diaphragm
Tank
Prepare to Assemble
Unpack the following
items shipped in
your sprayer box:
■ Wand
■ Pump Lever and
Connecting Rod
■ Tank Assembly
■ Small Parts Kit
■ From inside the
sprayer tank,
remove the
plastic bag from
the tank strainer.
Connecting
Rod
Wand Tank
Pump
Small parts
Lever
Hitch Pins and Washers
Kit
NOTES
Trigger
Valve
Manual
Wand
Nozzle
THE SERIAL NUMBER IS LOCATED
ON THE BOTTOM OF THE TANK.
Trigger Valve
Specifications
Net Weight ........................................................ 11 pounds (5.0 kg)
Tank Capacity ..................................... 4.75 U.S. gallons (18 liters)
Tank Material ............................................................. Polyethylene
Fill Opening Diameter .................................. 4.5 inches (114 mm)
Pump Type/Material ................................................. Piston/Brass
Operating Pressure ....................... 15-90 psi (1.05-6.3 kg/sq. cm)
Wand Assembly Length ............................. 29.5 inches (749 mm)
Hose Length ............................................. 69.75 inches (1771 mm)
Nozzle Installed ............................................ Red Adjustable Cone
Specifications subject to change without notice.
Small Parts included in the plastic bag
Install the Shaft
1. Fit the pump lever
shaft into the hole
in the sprayer base
as shown.
(chamber side).
2. Push the pump
lever shaft in until
the hole in the shaft
matches the opening in
the base reinforcement.
3. Lock the shaft in place
Pump Lever
Shaft
with the shaft retaining pin.
Install the Wand Holders
Fold the wand holders
around the pump lever
connecting rod, then secure
with the screws provided.
Wand Holder
Shaft Retaining
Pin
Base
Reinforcement
2.5 in.
(60 mm)
2
Wand
Holder
Connecting
Rod
Screw
12 in.
(300 mm)
11
Loading...