Page 1
UM-0178A-001-00
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
High Tech Campus 92, 5656 AG Eindhoven, The Netherlands Phone: +31-402-612222
3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan
English
CM-1100
SHIMANO SPORT CAMERA
Safety precautions
DANGER
• Do not leave the CM-1100 near sources of heat such as heaters. Do not heat the CM-1100
or throw it into a fi re. Doing so may cause bursting or ignition of the built-in battery.
• Do not throw the CM-1100 or subject it to strong shocks. Doing so may cause overheating,
bursting, or ignition of the built-in battery.
• Do not deform, modify, or disassemble the CM-1100. Do not use the built-in battery for
other than intended purposes. Doing so may cause leakage, overheating, bursting, or
ignition.
WARNING
•
The operating temperature ranges for the battery are given below. Do not use the battery in
temperatures outside these ranges. If the battery is used or stored in temperatures outside
these ranges, fi re, injury or problems with operation may occur.
1. In use: –10°C - 40°C
2. In storage: –20°C - 60°C
• Store it in a safe place out of the reach of children and infants. Infants may swallow the
memory card accidentally as it is small. If they swallow it accidentally, seek medical advice
immediately.
CAUTION
•
Do not leave the CM-1100 in a place exposed to direct sunlight, inside a vehicle parked under
the blazing sun, or other places under high temperature. Doing so may cause the built-in
battery to leak.
• If any leaked fl uid gets on your skin or clothes, wash it off immediately with clean water.
The leaked fl uid may damage your skin.
The latest version of this user manual is available on the website below.
http://si.shimano.com
Precautions
• Observe the general rules of etiquette when shooting.
• Be aware that taking pictures of others and making them available to the public may
violate their rights such as their image right.
• Do not use the CM-1100 in a manner against public order and morals, such as shooting
commercially available books or literary works whose shooting is prohibited.
• Save important data to a PC, etc.
• Inserting the memory card in the wrong orientation may damage the memory card,
memory card slot, or image data.
• Do not insert anything other than a memory card of supported size into the memory card
slot. Doing so may cause a malfunction. Be careful as the memory card may pop out
unexpectedly when it is inserted or removed.
• The CM-1100 is guaranteed to operate under operating temperatures ranging from -10 °C
to 40 °C, but the operating temperature range guaranteed may vary according to the type
of memory card.
For details, read the user's manual for your memory card.
Cautions when disposing of the memory card or giving it to someone else
The data in the memory card may not be completely deleted using "Format" or
"Deletion" functions of the CM-1100 or PCs. If you intend to give the memory card to
someone else, we recommend you delete the data completely using data deletion
software for PCs.
When disposing of the memory card, we recommend you destroy the memory card
physically.
• Contact the place of purchase for updates of the component software.
The most up-to-date information is available on the Shimano website.
• Please review any precautions that apply to use of the mount you are utilizing.
• Products are not guaranteed against natural wear and deterioration from normal use and
aging.
Battery
• If it will not be used for an extended period of time, charge the battery before
storing it.
• If the battery has become completely empty, discharged, charge it as soon as possible.
If the battery is left uncharged, it will deteriorate.
• Products are not guaranteed against natural deterioration from normal use and
aging.
Software updates
Use the sport camera after updating the software to the
latest version. For details, check the "UPDATE" section of
the following website.
http://www.shimano-sportcamera.com/
You can also access it
using this QR code.
Preparation for taking pictures
Lamp (left)
USB cable
(provided)
Open the
waterproof cover
Memory card
(sold separately)
To PC
Charging the battery
Open the waterproof cover and connect
the USB cable provided to the socket.
Connect the USB cable to the PC and
fully charge the battery.
The charging status is indicated by the
lamp (left) as follows:
•
Charging: Orange (Flashing)
•
Fully charged: Orange (Lit)
Standard charging time: 4 hours
Recordable Time: Approximately 1.5
hours (Full HD 60fps)
Replacing the memory card
Open the waterproof cover and insert
the memory card (sold separately) into
the slot with the label side facing up
until it clicks. Press in the inserted
memory card again to remove.
Supported memory cards:
Micro SD/SDHC/SDXC
class 10 or higher
(up to 128GB)
Turning the power ON/OFF
Wi-Fi/POWER
button
REC/STOP
button
Pressing the button for about 2 seconds turns
on the power with a beep.
Pressing the button for about 2 seconds again
turns off the power with two beeps.
Used to start/stop recording.
Connecting to a smartphone
Downloading a custom app
Download the smartphone application from the App Store for
iPhones or Play Store for Android phones.
Type "shimano" to search for the smartphone application.
Connecting your smartphone to the CM-1100 through Wi-Fi using the
custom app
Turn on the camera and press the
Wi-Fi/POWER button.
A beep sounds, the lamp (right) lit
1
in green, and the camera transmits
Wi-Fi signals.
Turn on Wi-Fi in your smartphone and
select the network "SMN_CAM-xxxx".
2
Enter "shimano_cam" for the Wi-Fi
password to establish the connection.
Carefully type the password as it
contains upper and lowercase letters
and an underscore.
3
After the connection is established, start
the smartphone application.
For details on operating the smartphone
application, please refer to the
application help manual.
Lit in green
Precautions
• We are not liable for data save errors or loss of data due to any malfunction of the
CM-1100 or the SD card.
• Do not drop the CM-1100. Doing so may cause damage.
• Do not leave the CM-1100 in an area exposed to strong sunlight for an extended period of
time.
• Condensation sometimes forms on the CM-1100, such as when it is moved from outdoors
to a warm place indoors in winter. Entry of condensation (dew) into the product may cause
a malfunction. To prevent condensation, seal the product in a bag and after coming
indoors, leave it at ambient temperature for a while before removing it from the bag.
Finally open the cover and leave the product for a few hours.
• If the CM-1100 gets seawater on it, wash the salt, sand, and dirt attached to the CM-1100
off with fresh water such as from a shower. Then, remove the lens protector and dry the
CM-1100.
• Do not expose the camera lens to direct sunlight for an extended period of time.
• To clean the lens surface, lightly blow off the dirt and dust with a blower and gently wipe
the lens with a soft, dry cloth.
• Straight lines in pictures taken by the CM-1100 may be distorted due to a characteristic
(distortion) of the lens, but this is not a malfunction.
• If the CM-1100 becomes hot after continuous use, the protection circuit may turn on to
stop the operation of the CM-1100.
• Waterproof function
* The CM-1100 is equivalent to JIS waterproof grade 8 (IPX8) and can be used at depths of
up to 18 m for up to 1 hours (up to 18 m when equipped with a standard lens
protector).
* The waterproof capability is as per our test standards and does not guarantee the
complete prevention of damage, malfunction or waterproofi ng under all conditions.
* If you subject the CM-1100 to a strong impact by hitting it, dropping it, etc., the
waterproof function is not assured.
* Do not use the CM-1100 under water pressure higher than the specifi cations, in hot
springs, or in water at temperatures of 40 °C or higher.
* The waterproof function of the CM-1100 is effective only against seawater and fresh
water.
* Malfunction resulting from the penetration of water caused by inappropriate use is not
covered by the warranty.
• Use the underwater lens protector when using the CM-1100 underwater. The lens
protector may prevent the device from performing adequately, for example by limiting the
angle of view or preventing proper focus.
• The underwater lens protector can only be used for a viewing angle of 135 degrees.
• To ensure the waterproof function, be sure to close the waterproof cover and attach the
lens protector.
• 2.4GHz digital wireless system
2.4GHz-frequency digital wireless technology, which is the same technology used for
wireless LAN.
However, in very rare occasions, objects and places may generate strong electromagnetic
waves and interference, which may result in incorrect measurement.
* Televisions, PCs, radios, motors/engines, or in cars and trains.
* Railroad crossings and near railway tracks, around television transmitting stations and
radar bases.
* Other wireless computers or digitally controlled light.
Package contents
Please check that all the items below are included in the package before use.
CM-1100
(with standard lens protector
preinstalled)
Lens protector
(for Super Wide)
Replace the lens protector according to the viewing angle set for recording.
Install the protectors with the mark at the top.
USB cable
User's manual (this manual)
For Wide viewing angle For Super Wide viewing angle
Standard lens protector Lens protector
Mount set
(
mount A, mount B, bolt,
leash, belt, rubber, doublesided adhesive tapes)
(for Super Wide)
When the camera is turned on, the two lamps light up for
about 3 seconds. The lamps indicate the following status.
Lamp(left):Batterylevel Lampcolor
(51% or higher) Green (remaining 21% or more)
▼ ▼ ▼
(21-50%) Orange (remaining 20% or less)
(20% or lower: Charging required)
When the shooting standby mode, lamp (left) is lit in red regardless of the
remaining battery power.
During the recording, lamp (left) is lit in green regardless of the remaining
battery power.
▼ ▼ ▼
Red (memory card not inserted)
Lamp(right):Memorycardcapacity
Recording video
Start recording
Pressing the REC/STOP button starts
video recording with a long beep.
Video recording cannot be performed unless a memory card is inserted.
•
•Pressing the
shoot still images.
Useful functions
The following settings can be confi gured by connecting the camera with a
smartphone through Wi-Fi. For details on the setting procedures, refer to the
help manual for the custom application.
Switching between the recording modes
In addition to Full HD (1920 x 1080) 60 fps (default setting), various settings
can be confi gured for image quality and smoothness of the video. You can
also shoot still images.
AUTO REC
By connecting the camera with an ANT+TM devices, recording can be started
or stopped automatically.
For details on operation procedures for connecting to Wi-Fi and ANT+TM devices,
applications required to use peripheral devices, etc., please visit our support website.
Wi-Fi/POWER button while recording a video allows you to
http://www.shimano-sportcamera.com/
Stopping recording
Pressing REC/STOP button again while
recording stops video recording with a beep.
Other operations
Waking up from the sleep mode
With the CM-1100, when no operations are performed for a certain period of
time (default: 3 minutes), the camera enters the sleep mode. At this time, the
lamp (left) fl ashes in green.
Pressing the Wi-Fi/POWER button or REC/STOP button wakes up the
camera from the sleep mode.
Key lock
With the power off, press the Wi-Fi/POWER button and REC/STOP button
at the same time for about 4 seconds. The operation key is locked with two
beeps. To unlock, press the Wi-Fi/POWER button and REC/STOP button
again for about 4 seconds.
Resetting the CM-1100
If the CM-1100 does not respond to any operations, it may have frozen.
Press and hold both the Wi-Fi/POWER button and REC/STOP buttons (8
seconds or longer) to reset the CM-1100.
Connecting to a PC
After turning on the CM-1100, open the waterproof cover and connect one end
of the USB cable provided to socket and the other to the PC. When the PC
detects the CM-1100 as an external storage device, the connection is established.
Connecting to an ANT+TM product
The CM-1100 can be connected to ANT+TM products.
* See
operating manual for your transmitter.
the
Please note: specifi cations are subject to change for improvement without notice. (English)
© April 2017 by Shimano Inc. ITP
Loading...