Sherwood DS-10 User Manual
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지1
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지2
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings.
ENGLISH
Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other.
A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of
the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. Only use attachments accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
PORTABLE CART WARNING
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus have been
exposed to rain or moisture, does not operate normally,
or has been dropped.
2
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지3
Introduction
READ THIS BEFORE OPERATING YOUR UNIT
CAUTION
: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
ACK). NO USER-SERVICEABLE PARTS
B
INSIDE. REFER SERVICING TO QUALIFIED
ERVICE PERSONNEL.
S
his symbol is intended to alert the user to the presence of
T
uninsulated "dangerous voltage" within the product's enclo-
ure that may be of sufficient magnitude to constitute a risk
s
of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
ENGLISH
WARNING
FCC INFORMATION (FOR U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.
FOR YOUR SAFETY
Units shipped to the U.S.A and CANADA are designed for
operation on 120 V AC only.
Safety precaution with use of a polarized AC plug.
However, some products may be supplied with a nonpolarized plug.
CAUTION
ATTENTION
: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
could void the user’s authority to operate the equipment.
FOR YOUR SAFETY
U.S.A.
CANADA
: To prevent electric shock, match wide blade
of plug to wide slot, fully insert.
: Pour éviter chocs électriques, introduire
la lame la plus large de la fiche dans la
borne correspondante de l a p rise et
pousser jusqu’ au fond.
120 V
Units shipped to Australia are designed for operation on 240 V
AC only.
To ensure safe operation, the three-pin plug supplied must be
inserted only into a standard three-pin power point which is
effectively earthed through the normal household wiring.
Extension cords used with the equipment must be three-core
and be correctly wired to provide connection to earth.
Improper extension cords are a major cause of fatalities.
The fact that the equipment operates satisfactorily does not
imply that the power point is earthed and that the installation is completely safe. For your safety, if in any doubt
about the effective earthing of the power point, consult a
qualified electrician.
PAN-EUROPEAN UNIFIED VOLTAGE
All units are suitable for use on supplies 220-240 V AC.
EUROPE
AUSTRALIA
220 V
-
240 V
3
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지4
CAUTION
Leave a space around the unit for sufficient ventilation.
•
Avoid installation in extremely hot or cold locations, or in an area that is exposed to direct sunlight or heating equipment.
•
Keep the unit free from moisture, water, and dust.
•
Do not let foreign objects in the unit.
•
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, cur-
•
tains, etc.
No naked flame sources, such as lighted candles, should be placed on the unit.
ENGLISH
•
Please be care the environmental aspects of battery disposal.
•
The unit shall not be exposed to dripping or splashing for use.
•
No objects filled with liquids, such as vases, shall be placed on the unit.
•
• Do not let insecticides, benzene, and thinner come in contact with the set
Never disassemble or modify the unit in any way.
•
■Notes on the AC power cord and the wall outlet.
The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, even if the unit has
•
been turned off.
To completely disconnect this product from the mains, disconnect the plug from the wall socket outlet.
•
When setting up this product, make sure that the AC outlet you are using is easily acceptable.
•
Disconnect the plug from the wall outlet when not using the unit for long periods of time.
•
.
FOR EUROPE
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic
products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling
of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality,
your waste disposal service or the point of sale where you purchased the items.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please contact your local
authorities or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
The sign Pb below the symbol for batteries indicates that this batteries contains lead.
4
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지5
Contents
• IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
• Introduction
READ THIS BEFORE OPERATING YOUR UNIT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
• System Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
• Remote Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
REMOTE CONTROL OPERATION RANGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
LOADING BATTERY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
• Operations
SETTING THE OSD MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
MUSIC MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
VIDEO MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
OTHER FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
USING THE RECEIVER'S REMOTE CONTROL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
• Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
• Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Compatible iPod models
ENGLISH
• iPod touch
• iPod classic
• iPod nano (1st~3rd generation)
• iPod (4th~5th generation)
• iPod photo
• iPod mini
■
Notes :
• On iPod classic and iPod nano 3rd generation models, the video menu for the OSD can be displayed on a TV connected
to the Sherwood iPod Dock.
• On iPod touch model, Ver 2.0 or higher supports the video menu.
• Before using the iPod Dock, update your iPod with the latest software, available from the Apple Web site at :
www.apple.com
*
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
5
System Connections
12 3
• Please be certain that this unit is unplugged from the AC outlet before making any connections.
• Since different components often have different terminal names, carefully read the operating instructions of the component
connected.
• Be sure to observe the color coding when connecting audio and video cables.
• Make connections firmly and correctly. If not, it can cause loss of sound, noise or damage to the receiver.
ENGLISH
DS-10(A)_ENG_090212:DS-10(A)2009-02-19오 10:43페이지6
1. CONNECTING DIGI LINK-I JACK FOR SYSTEM CONTROL
• Connect this jack to the DIGILINK-I jack of Sherwood receiver that allows you to control the iPod with the receiver's remote
control.
■
Notes :
• When making DIGILINK-I connection, you should use the supplied DIGI LINK-I cable.
• Do not connect headphones to the DIGI LINK-I jack, it can cause damage to the unit.
Sherwood receiver such as RD-7503, etc.
6
Loading...