SHARP XL-E80E User Manual

If you require any advice or assistance regarding your Sharp product, please visit our web-site www.sharp.co.uk/customersupport. Customers without Internet access may telephone 08705 274277 during office hours (or (01) 676 0648 if telephoning from Ireland).
0301
MODEL
AM loop aerial
Right speaker
FM aerial
Left speaker
Wall socket (AC 230 - 240 V, 50 Hz)
Black
Red
Right speaker
Left speaker
XL-E80E
MICRO COMPONENT SYSTEM
This Quick Start Guide will help you to correctly install and oper­ate your system.
2
Remote control battery installation
1
Accessories
AC power lead × 1
FM aerial × 1 Speaker wire × 2
3
System connections
Remote control × 1 AM loop aerial × 1
Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included.
1 Remove the battery cover.
2 Insert the batteries as shown.
3 Replace the cover.
4
Turning on your system
Press the ON/STAND-BY button to turn the power on.
XL_E80E_E_QG.pm 04.4.14, 2:12 PM1
TINSEA023SJZZ 04D N HK 1
Listening to a CD
12 cm (5") 8 cm (3")
Listening to a cassette tape
1 Press the FUNCTION button until “CD” appears on the dis-
play .
2 Press the OPEN/CLOSE
button to open the disc tray.
3 Place the disc on the disc tray, label side up.
4 Press the OPEN/CLOSE 5 Press the
button to start playback from track 1.
button to close the disc tray.
Listening to the radio
1 Press the FUNCTION button until “TAPE” appears on the
display.
2 Open the cassette compartment by pushing the area marked
“PUSH EJECT
”.
3 Load a cassette into the cassette com-
partment with the side to be played facing toward you.
4 Close the cassette compartment by pushing the area marked
“PUSH EJECT
5 Press the
If trouble occurs
When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is operated incorrectly , it may malfunction.
If such a problem occurs, do the following:
1. Set the unit to the stand-by mode and turn the power on again.
2. If the unit is not restored in the previous operation, un­plug and plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by resetting it.
”.
button to start playback.
1 Press the FUNCTION button until “FM” or “AM” appears on
the display.
2 Press the TUNING (
station. When the TUNING button is pressed for more than 0.5 sec­onds, scanning will start automatically and the tuner will stop at the first receivable broadcast station.
To receive an FM stereo transmission:
Press the FUNCTION button to display the “ST” indicator.
” will appear when an FM broadcast is in stereo.
XL_E80E_E_QG.pm 04.4.14, 2:12 PM2
or ) button to tune in to the desired
FM stereo mode indicator FM stereo receiving indicator
Clearing all the memory (reset)
1. Press the ON/ST AND-BY button to enter the power stand­by mode.
2. Whilst pressing down the MEMORY/SET button and the TAPE “CLEAR” appears.
button, press the ON/STAND-BY button until
Caution:
This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.
Maintenance
Routine maintenance is required for continued optimum perfor­mance, refer to the operation manual (page 29).
TINSEA023SJZZ
Loading...
+ 1 hidden pages