SHARP SV SVL 2414 2416
Fanuc or Siemens machines installation procedure
This document is for Sharp SV and SVL 2414 and 2416 Fanuc and Siemens Control
machines.
Connect power (220V 3 Phase) to the main power switch.
Siemens control servo requires 380V, Machine equipped transformer to apply 380V to
the servo.
Remove all shipping brackets. (They are used to be paint RED)
X locking
bracket
Remove ATC locking screw or bracket. They are usually a red tag there.
Y locking
bracket
Installation procedure K. CHEN
SHARP INDUSTRIES INC
SHARP SV SVL 2414 2416
b
Fanuc or Siemens machines installation procedure
Caution tag
Connect air to the air regulator. Machine requires 85-90 PIS.
Air
Regulator
ATC locking
screw.
ATC
locking
racket
Pressure
switch.
Solenoid
valves
Using MPG move the Z axis up.(Positive direction) Then remove spindle seat.
For Siemens control machine, after power ON, you need to release E stop switch, Press
RESET, Press FEED START to enable manual movement.
Reset Feed Start
More detail information, Please read Siemens manual first.
Installation procedure K. CHEN
SHARP INDUSTRIES INC
SHARP SV SVL 2414 2416
Fanuc or Siemens machines installation procedure
Spindle seat
Install X and Y axis sliding way cover.
Level the machine within 0.0005” for both axes direction.
Put an indicator to tram the Z axis, The whole circle within 0.0005”
Installation procedure K. CHEN
SHARP INDUSTRIES INC
SHARP SV SVL 2414 2416
Fanuc or Siemens machines installation procedure
If not, readjust level bolts to correct it.
Install coolant tank, SV2414 tank in front of the machine, SV 2416 coolant tank in the
back of the machine.
Connect coolant pump and wash pump, they are labeled or colored.
Install bottom skirt. Please read factory operator’s manual before you work on the
machine. If you have any questions please do not hesitate to contact Sharp Service Dept.
at 310-323-3181. Thanks.
Installation procedure K. CHEN
SHARP INDUSTRIES INC
Loading...