Sharp SSC2489DS Installation Manual

™

Min.

2"

(5.1 cm)

SuperSteam+ Oven
Cutout

Electric Wall Oven /
Warming Drawer /
Microwave Drawer
Cutout

Min.

36"

(91.5 cm)

SSC2489DS SUPERSTEAM

+

OVEN

INSTALLATION MANUAL

SPECIAL WARNING

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CLEARANCES AND DIMENSIONS

For SAFETY CONSIDERATIONS do not install oven in any combustible cabinetry which is not in accord with the stated
clearances and dimensions on page 3, Figure 2 or page 4, Figure 3.

UNPACKING YOUR OVEN

• Remove all packing materials from inside the oven.

• Check the oven for any damage, such as misaligned or bent oven,

damaged oven seals and sealing surfaces or dents inside the
cavity or on the front side of the oven. If there is any damage,
do not operate the oven. Contact your dealer or a SHARP
AUTHORIZED SERVICER.

IMPORTANT NOTES TO THE INSTALLER

• Read all of the Installation Manual before installing the oven.

• Remove all packing material before connecting the electrical

sup ply.

• Observe all governing codes and ordinances.

• Be sure to leave these instructions with the consumer.

IMPORTANT NOTES TO THE CONSUMER

Keep this manual with your Operation Manual for future reference.

• As when using any oven generating heat, there are certain safety

precautions you should follow. These are listed in the Operation
Manual. Read all and follow carefully.

• This oven should only be installed and grounded properly by

a qualied installer or service technician.

Never leave children alone or unattended in

the area where an oven is in use.

• Do not use the oven as a storage space. This creates a

potentially hazardous situation.

INSTALLATION HARDWARE

NAME QTY PART CODE

Wood Screws 4 XTSS740P20000

CHOOSING A LOCATION FOR YOUR OVEN

You will use your oven frequently, so plan its location for ease
of use. Your oven can be built into a cabinet or wall by itself, or
above any electric wall oven or above other Microwave Drawer
models that specify the combination of this oven. The oven may
be mounted below a 36” countertop, including a cooktop or island.
It cannot be built in above any gas wall oven.

IMPORTANT SAFETY INSTRUCTIONS

If the information in this manual is not followed

exactly, a re or electric shock may result that could cause

property damage, personal injury or death.

• This oven must be electrically grounded in accordance with

local codes.

• Do not install this oven if the surrounding wall coverings and

the cabinets cannot withstand the heat generated by the oven.

E1

OVEN MEASUREMENTSOVEN MEASUREMENTS

11

/32"

(8.7 mm)

3

/8"

(10.0 mm)

1

/2"

23

(597.0 mm)

Figure 1A

1

/2"

19

(496.0 mm)

7

18

/8"

(479.4 mm)

17"

7

/16"

1

(37.0 mm)

FRONT BACK

(431.8 mm)

15

16

/16"

(430.2 mm)

Figure 1B

2E

CLEARANCES AND DIMENSIONS FOR STANDARD SURFACE MOUNT

11

/32"

Allow
overlap

Suggested electrical
outlet location

Allow 11/16"

overlap

Allow
overlap

A. 22" cutout

3

18

/4" cutout*

B.

E

Allow 11/16"

overlap

3

/8"

Note: Platform must be
able to support 70 lbs.

3

C. 15

/4" min. depth
D. 4"
E. 18"

* Critical dimension

90º

Ensure the shelf that the
appliance rests on is 90° to
the cabinet face.

Figure 2

E3

CLEARANCES AND DIMENSIONS FOR FLUSH MOUNT

A

C

A. 23 3/4" cutout*
B.
C. 21
D. 17

B

E. 1
F.

3

19

/4" cutout*

15

/16"

1

/4" min. depth

7

/16"

9

/16"

F

* Critical dimension

D

E

90º

Figure 3

Ensure the shelf that the appliance
rests on is 90° to the cabinet face.

4E

INSTALLATION INSTRUCTIONS

Always use caution lifting heavy products.

1. Open the SuperSteam+ Oven door and use lift points in Figure 4. Place the oven adjacent to the wall or cabinet opening. DO NOT LIFT
OVEN WITH HANDLE. Plug the power supply cord into the electrical outlet.

2. Carefully guide the SuperSteam+ Oven into the prepared opening. Avoid pinching the cord between the oven and the wall.

3. Slide the oven all the way until the mounting ange is ush with the face of the cabinet. See Figure 6.

Lift point

in cavity

DO NOT

lift unit using handle

Side Handle (x2)

Figure 4

Figure 5

E5