SHARP SP2367 Technical Report

COPIER(OPTION) : SF-S54N

Date

:

May. 31, 1999

No. : SP-2367

CHANGE CARRIED OUT IN THE F/R FIXING
SCREWS OF THE SORTER RECEIVE RACK.

1.Model Name: SF-S54N

2.General: The F/R screws included in the shipping box which are used to affix the sorter receive

rack when the SF-S54N is mounted to the SF-2530 are normally used for taps, even
though the frame on the machine side has not been prepared with taps. Since the
sorter receive rack could not be attached to the machine, a change has been carried
out and new screws and spacers have been included in the shipping box.

(Temporary action)

S-tight screws

Spacers

Changed screws
(Q’ty: 4)

The screws and spacers described above should only be used when carrying out
attachment operations of the SF-S54N to the SF-2530. Attachment operations to the
original machines should be carried out with the original screws. It is important to note
that the screws used in the permanent action are being supplied as service parts.

3.Action: Temporary action: From the 1st lot of 1999 February production.

Permanent action: From the 1st lot of 1999 April production.

SHARP CORPORATION Document Division I

1/3

Green

C

2/3

A bag containing the screws and
spacers has been attached.

There has been a change carried out in the screws which are used in the permanent
action described above. The change has been carried out as of 1999 April production,
and in accordance with this action this Installation Procedures Manual has been
discontinued.