SD-EX100H
1-BIT DIGITAL AUDIO SYSTEM
Accessories
1
This Quick Guide will help you to correctly install
and operate your system.
If you require any advice or assistance regarding your Sharp product, please visit
our web-site www.sharp.co.uk/support.
Customers without internet access may
telephone 08705 274277 during office
hours (or (01) 676 0648 if telephoning from
Ireland).
Remote control × 1
AM loop aerial × 1
Battery installation of the remote control
2
Use 2 “AAA” size batteries (UM-4, R03, HP-16 or similar).
Remove the battery
1
cover.
Speaker wire × 2
“AAA” size battery
(UM-4, R03, HP-16 or similar) × 2
AC power lead × 1
Insert the batteries
2
as shown.
FM aerial × 1
Speaker cushion × 4
Replace the cover.
3
TINSE0470AWZZ 02D R HK 1
SD-EX100H(E)_QG 02.4.19, 5:17 PM1
– 1 –
System connections
3
AM loop aerial
Right speaker
Wall socket
(AC 230 V, 50 Hz)
Transparent
Right speaker
FM aerial
Left speaker
Left speaker
MD recorder
To the optical line
input socket
Connection cable for digital recording
(Not supplied)
Line
VCR, DVD, etc.
To the line
output sockets
(CD only)
RCA lead
(Not supplied)
WhiteRed
SD-EX100H(E)_QG 02.4.19, 5:17 PM2
– 2 –
Turning on your system
4
Press the ON/STAND-BY
button to turn the power on.
Listening to a CD
Power indicator
1
2
3
4
Press the H/7 button.
Shutter closed (grey lid)
Load a CD into the slot.
Press the H/7 button.
Press the 06 button to start playback.
Shutter opened
Face the label side
towards you.
SD-EX100H(E)_QG 02.4.19, 5:17 PM3
– 3 –
Listening to the radio
1
2
FM stereo receiving indicator
FM stereo mode indicator
Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM).
Press the TUNING (X or W) button to tune in to the desired station.
● When the TUNING button is pressed for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the “STEREO” indicator.
● “ST” will appear when an FM broadcast is in stereo.
If trouble occurs
When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal
supply voltage due to lightning, etc.) or if it is operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1 Set the unit to the power stand-by mode and turn the power on again.
2 If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by resetting it.
Clearing all the memory (reset)
1 Unplug the unit.
2 Whilst holding down the ON/STAND-BY button, plug in the AC power lead. Press down the ON/STAND-BY button until
“RESET” is displayed.
3 Press the ON/STAND-BY button again to turn the power on.
Caution:
This operation will erase all data stored in
memory including clock, timer settings, tuner
preset, and CD programme.
– 4 –
SD-EX100H(E)_QG 02.4.19, 5:17 PM4
Loading...