SHARP DTE273 Technical Report
DUPLICATOR : SD-4085
Date
:
May. 22, 1997
No. : DTE-273
MEASURE TO ALLEVIATE PROBLEMS OF FOLDED
CORNERS OF THE ORIGINAL DOCUMENT IN THE RDH.
1.Model Name: SD-4085
2.General: A change in shape has been carried out in the transport paper guide. This change has
been carried out as a measure to alleviate problems of folded corners and damage to
the rear edge of the original documents which has occurred in the RDH of the models
listed above.
3.Description 1) A taper has been added to the PU pawl flow locations.
2) The hook section has been cut.
3) A change in the shape of the hook section which had been getting caught on the
transport roller shaft section has been carried out.
Change : 3)
(Change in shape)
Change : 1) (Change to a tapered shape)
D-D cross-section
enlargement figure
Change : 3)
(Change in shape)
Change : 1) (Change to a tapered shape)
Change : 2) (The hook section has been cut)
E-E cross section
enlargement figure
SHARP CORPORATION Reprography Division
1/2
Green
C
4.Action: * 1) Inch series: From 1996 mid-October production.
AB series: From the start of 1996 mass production.
2) From the start of 1996 December production.
3) From the start of 1997 February production.
Ref.
Model
No.
SD-4085 All 41 -8 PGIDH1684FCZZ PGIDH1684FCZ1 AR
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
3. Current type cannot be used in place of new type.
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
Version P/G No.
name
New type cannot be used in place of current type.
New type can be used in place of current type.
Current parts New parts
Parts code Parts code
5. Interchangeable if replaced with same types of
related parts in use.
6. Others.
Price
rank
Parts name
Transport paper
guide
Effec-
tive
time
* 3
Inter-
change-
ability
Note
2/2
Loading...