SHARP DTE242 Technical Report
Date: Nov. 12, 1996
DUPLICATOR : SD-4085
No. : DTE-242
1.CHANGE IN THE EXPOSURE LIGHT PG-B.
2.CHANGE IN THE SCREWS OF THE RIGHT CABINET U UNIT.
3.CHANGE IN THE TREATMENT OF TH E ADU HARNESS.
4.CHANGE IN THE HEIGHT ADJUSTMENT OF TRAY 3.
1. Change in the exposure light PG-B.
1.Model Name: SD-4085
2.General: Problems have occurred with blurred images caused by the original copy becoming
caught on the exposure PG-B when it rises higher than the RDH glass. As a measure to
alleviate these problems, a change in the shape of the PG-B has been carried out.
2nd register roller
Cut 1.5 mm
Change in the bend
Change in the bend
Exposure frame F/R
Cut 0.5 mm
3.Action: From the start of 1996 August production.
2. Change in the screws of the right cabinet U unit.
1.Model Name: SD-4085
2.General: A change has been carried out in the length of the screw used to tighten both the right
cabinet hinge and the spring in the right cabinet U unit. This change has been carried
out as a measure to improve operation efficiency.
3.Action: From 1996 mid-August production.
SHARP CORPORATION Reprography Division
1/3
Green
C
3. Change in the treatment of the ADU harness.
1.Model Name: SD-4085
2.General: A change in the treatment of the ADU harness has been carried out as a measure to
improve the breadth of the ADU paper flow.
R side
F side
rack
Front side
A section
3.Action: From the start of 1996 July production.
4. Change in the height adjustment of tray 3.
1.Model Name: SD-4085
2.General: Problems have occurred with jams which occur when invoice paper is passed from tray
3. As a measure to alleviate these problems a change in the height adjustment has
been carried out on tray 3.
3.Description: A change in the height of tray 3 has been carried out as indicated in the figure shown
below. The height has been changed from 6.5 to 7.5 mm.
Tray 500
Size guide plate 500 R
Size guide plate 500 F
A section
Tray 3
4.Action: From the start of 1996 July production.
2/3
B section
Loading...