SHARP DTE226 Technical Report

Date: Apr. 8, 1996

DUPLICATOR : SD-2060

No. : DTE-226

MIDDLE TRAY UNIT MEASURE TO PREVENT CRACKING OF THE PULLEY AND THE SHAFT.

1.Model name: SD-2060/3062

2.General: Cracking sometimes occurs in the shaft and pulley used in the middle tray unit due to

the load applied to the parallel pin. To alleviate this problem a change in the material has been carried out.

3.Description: Change locations in the pulley (only the four locations indicated by the arrows in the diagram).

SHARP CORPORATION Reprography Division

1/2

Green

Change locations in the shaft.

4.Action: From 1996 mid-February production.

Ref.

Model

No.

SD-2060 SD-3062

1. Interchangeable. 4. Not interchangeable.

2. C urr e nt t y pe c a n be u s ed i n p la ce of new ty pe . New ty pe cann ot be us ed i n place of curr ent type .

3. C urre nt ty pe cann ot be used i n place of new ty pe. New t y pe c a n be u sed in p lac e of c u r ren t ty p e.

Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with

specified ones for maintaining the safety and performance of the set.

name

Version P/G No.

All

31 -69 NROLR0952FCZZ NROLR0952FCZ1 AS Lower roller A

Current parts New parts

Parts code Parts code

NPLYZ0205FCZZ NPLYZ0310FCZZ AH Pulley 20T

Effec-

Price

5. Interchangeable if replaced with same types of relate d parts in use .

6. Others.

Parts name

rank

tive

time

Mid-

’96/2

Inter-

change-

ability

Note

2/2