SHARP DTE210 Technical Report

Date: Aug.21, 1995

DUPLICATOR : SD-2060

1. MEASURES TO PREVENT THE CUTTING OF THE WIRE IN THE 1000
TRAY.

2. ADDITION OF A SHEET TO COVER THE ELEVATOR MOTOR T O
PREVENT THE INFI LTRA TION OF FOREIGN MA TTER.

1. Measures to prevent the cutting of the wire in the 1000 tray .

1.Model name: SD-2060/3062.

2.General: When the machines are left in countries with cold weather, for a long period of time with

the 1000 paper tray in the elevated position, the wires of the tray assume the shape of
the position, and when the tray is lowered this can caus e problems in the tray. If action
is taken to alleviate the trouble mentioned above, the wires sometimes become cut, and
to prevent this from happening, the following measures have been carr ied out.

No. : DTE-210

3.Description: Changes in the parts of the 1000 paper tray have been carried out so that it is easier to
lower, and the method of wrapping the wires has been changed. (Please refer to the
figure included on a separate page.)

1000 Paper tray → Change in shape
1000 Frame A unit → Change in shape (change in the no. of pulley bosses)

Old New

1000 Wire E (rear side)

1000 Wire D (both rear and front sides)

1000 Wire F (front side)

Note: When these wires are replaced, it is necessary to replace both wires in the 1000
paper tray simultaneously. (It is not possible to replace only one of the wires.)

4.Action: From the start of 1995 September production.

SHARP CORPORATION Reprography Division

1/3

Green

C

2/3