Sharp AN-GR500H User Manual

MODEL

AN-GR

500

H

HOME CINEMA RACK SYSTEM

This quick Start Guide will help you to correctly install and operate your system.

Accessories

1

If you require any advice or assistance regarding
your Sharp product, please visit our web-site
www.sharp.co.uk/customersupport.aspx
Customers without internet access may
telephone [phone] during office hours (or
[phone] if telephoning from Ireland).

Top glass x 1 Bottom glass x 1

"AA" size battery

(UM/SUM-3, R6, HP-7 or similar)

x 2

Installing the glass and the glass protector

2

1. Fix the glass protector to the top glass at each corner.
Make sure the "TEMPERED" sticker on top of the glass
is facing up.

TOP VIEW

Step 1 Step 2

Remote control x 1

2. Place the top glass on top of the frame.
Make sure all the glass protector guide is fitting to the frame hole.

“TEMPERED” sticker

FM aerial x 1

TEMPERED

Glass protector x 4AC power lead x 1

Adjustable nylon band x 3

Glass protector

TEMPERED

“TEMPERED” sticker

BOTTOM VIEW

Step 1

Notes:

It is advisable for the top glass to be carried by 2 persons.
Top glass with sticker on its surface, must face upwards.
Metal frame must not be removed to ensure safety.
The maximum load for the top glass on the unit is 100 kg.
The glasses are made of reinforced glass, but dropping pointed
objects on them or strongly hitting the surface may cause them to
break.
Top and bottom glass are not fastened to the unit. Always take
care when transporting it, otherwise these parts may fall off and
there is a risk of damage and injury.

TEMPERED

Step 2

Frame hole for
the glass protector
to fit in.

Subwoofer box

“TEMPERED”

sticker

Top glass

TEMPERED

Bottom

glass

3. Place the bottom glass on top of the subwoofer box.
Make sure the “TEMPERED” sticker on top of the glass is facing
up.

TINSEA270AWZZ
08G R MW 1

Remote control battery installation

3

Connecting the AC power lead

4

Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).

1 Open the battery cover.

2 Insert the batteries as shown.

3 Close the cover.

After checking all the connections have been made correctly,
connect the AC power lead to the AC power input socket, then
to the wall socket.

Wall socket
(AC 220 V- 240 V, 50 Hz)

Notes:

Never use a power lead other than the one supplied. Other­wise, a malfunction or an accident may occur.

Unplug the AC power lead from the wall socket if the unit will
not be in use for a prolonged period of time.

To turn the power on

5

Press the ON/STAND-BY button.

If the power does not turn on, check whether the power lead is plugged in properly.

To set the unit to stand-by mode:

Press the ON/STAND-BY button again.

Note:

After the unit enters the power stand-by mode, wait a few seconds to turn on again