Sharp AN-C12MZ User Manual

Wide-zoom lens for LCD projector Weitwinkel-zoomobjektiv für LCD-Projektor Objectif grand angle-zoom pour projecteur LCD Objetivo granangular-zoom para proyector LCD
English
Deutsch
Français
Español
INSTALLATION MANUAL INSTALLATIONSHANDBUCH MANUEL D’INSTALLATION MANUAL DE INSTALACIÓN
Changing the Lens
When changing the lens, use the supplied lens cover stick.
Info
Before changing the lens turn off the power to the projector and remove the power cord from the wall outlet.
Do not attempt to change the lens while the projector is mounted on the ceiling.
1 Pull out the carrying handle. 2 Use the tip of the supplied lens cover stick
to push down on the groove on top of the upper half of lens cover while pulling for­ward to remove it with your hand.
3 To remove the bottom half of the lens cover,
pull it down and towards you.
4 To remove the lens, hold it in one hand, to
keep it from dropping, while you turn the lens fastener catch tab in the direction of the ar­rows in the illustration with your other hand.
If the lens fastener ring is stiff, attach the sup­plied lock release strap to the catch tab on the lens fastener ring and pull the strap to turn it.
5 Remove the lens.
Upper half of the lens cover
2
1
Carrying handle
Lower half of the lens cover
Lens fastener catch tab
3
4
5
Procedure for loosening the stiff lens fastener ring
-1
Lock release strap
Lens fastener catch tab
6 First insert tabs
tab holes
bb
b into tab holes
bb
AA
A of the projector, then push tabs
AA
aa
a of the lens cover into
aa
BB
B until it clicks into place.
BB
7 Push in the carrying handle.
8 Remove the cap from the end of the lens that
you will attach to the projector.
7
Tabs b
Tab holes B
6
Tabs a
Tab holes
8
A
9 Make sure that the two grooves on the lens
fastener ring are facing upward.
10 Ensure that the two grooves on the lens
mount face upward and the pin of lens in­sertion area is inserted into the hole of the lens mount as you push the lens into the projector.
Make sure the lens is pushed into the projec­tor interior firmly.
11 Turn the lens fastener catch tab in the direc-
tion of the arrows in the illustration until it stops.
Be careful not to turn the lens fastener ring too tight, as the lens fastener ring will be stiff the next time the lens is changed.
12 After inserting the upper half of the lens
cover tabs into the projector tab holes, slide the lens cover towards the projector until it clicks into place.
If the upper half of the lens cover is not se­cured to the projector, you will not be able to turn the power on.
Grooves
Lens mount
12
Lens fastener ring
Hole
11
9
Pin
10
Tabs
Tab holes
-2
Adjust the picture size and focus
Zoom ring
Turn the zoom ring to adjust picture size. Turn the focus ring to adjust the focus.
Picture size and projection ditance chart
Base line:
Screen
H
L : Projection distance
NORMAL Mode (4:3)
Picture (Screen) size Projection distance (L)
Diag. (X) Width Height Maximum (L1) Minimum (L2) 300" (762 cm) 240" (609.6 cm) 250" (635 cm) 200" (508 cm) 150" (381 cm) 200" (508 cm) 160" (406.4 cm) 150" (381 cm) 100" (254 cm) 80" (203.2 cm) 84" (213.3 cm) 67" (170.1 cm) 50" (127 cm) 72" (182.8 cm) 58" (147.3 cm) 60" (152.4 cm) 48" (121.9 cm) 36" (91.4 cm) 40" (101.6 cm) 32" (81.2 cm) 24" (60.9 cm)
120" (304.8 cm)
180" (457.2 cm)
120" (304.8 cm) 90" (228.6 cm) 60" (152.4 cm)
43" (109.2 cm)
30' 5" (9.26 m) 24' 3" (7.38 m) 17 25' 4" ( 20' 3" (6.15 m) 16' 1" (4.89 m) 11 15' 2" (4.60 m) 12' (3.65 m) 8 10' (3.04 m) 7'11" (2.41 m) 5
7.71
m) 20' 2" (
8' 4" (2.54 m) 6' 8" (2.02 m) 4 7' 2" (2.17 m) 5' 8" (1.72 m) 4 5'11" (1.80 m) 4' 8" (1.42 m) 3 3'11" (1.18 m) 3' 1" (0.92 m) 2
STRETCH Mode (16:9)
Picture (Screen) size Projection distance (L)
Diag. (X) Width Height Maximum (L1) Minimum (L2) 300" (762 cm) 261" (662.9 cm) 250" (635 cm) 218" (553.7 cm) 225" (571.5 cm) 200" (508 cm) 174" (441.9 cm) 98" (248.9 cm) 150" (381 cm) 131" (332.7 cm) 74" (188 cm) 133" (337.8 cm) 106" (269.2 cm) 100" (254 cm) 87" (220.9 cm) 92" (233.6 cm) 80" (203.2 cm) 84" (213.3 cm) 73" (185.4 cm) 72" (182.8 cm) 63" (160 cm) 35" (88.9 cm) 60" (152.4 cm) 52" (132 cm) 29" (73.6 cm) 40" (101.6 cm) 35" (88.9 cm) 20" (50.8 cm)
196" (497.8 cm)
116" (294.6 cm) 65" (165.1 cm) 92" (233.6 cm) 52" (132 cm)
147" (373.4 cm) 123" (312.4 cm) 110" (279.4 cm)
49" (124.4 cm) 45" (114.3 cm) 41" (104.1 cm)
33' 2" (10.10 m) 26' 5" (8.04 m) –5 27' 7" (8.40 m) 22' (6.69 m) –4 24'10" (7.55 m) 19' 9" (6.01 m) –3 22' 1" (6.71 m) 17' 7" (5.34 m) –3 16' 6" (5.01 m) 13' 2" (3.99 m) –2 14' 7" (4.44 m) 11' 7" (3.53 m) –2 11' 7" (3.52 m) 9' 3" (2.80 m) –1 10'11" (3.32 m) 8' 8" (2.63 m) –1 10' 1" (3.05 m) 8' (2.42 m) –1
9' 2" (2.78 m) 7' 3" (2.20 m) –1 7'10" (2.37 m) 6' 3" (1.88 m) –1 6' 6" (1.97 m) 5' 2" (1.55 m) – 4' 3" (1.29 m) 3' 4" (1.01 m)
Horizontal line passing through the lens center
Lens center
Distance from the lens center
to the bottom of the image (H)
3 / 4"
"
13 / 16" 13 / 16"
7 / 8" 7 / 8"
15 / 16"
1 / 4" 9 / 16" 3 / 8"
3 / 16" 3 / 4" 3 / 8" 1 / 2" 3 / 16" 3 / 4" 5 / 8" 9 / 16" 7 / 16"
3 / 16" 31 / 32" 11 / 16"
(45.1 cm) (37.6 cm) (30.0 cm) (22.5 cm) (15.0 cm) (12.6 cm) (10.8 cm)
(9.0 cm) (6.0 cm)
(–12.7 cm) (–10.6 cm) (–9.5 cm) (–8.5 cm) (–6.4 cm) (–5.6 cm) (–4.5 cm) (–4.2 cm) (–3.9 cm) (–3.6 cm) (–3.0 cm)
(–2.5 cm) (–1.7 cm)
6.14
m) 14
Distance from the lens center
to the bottom of the image (H)
The formula for picture size and projection distance L1 (ft)= L2 (ft)= H (in) =
X: Picture size (diag.) (in) L: Projection distance (ft) L1: Maximum projection distance (ft) L2: Minimum projection distance (ft) H: Distance from the lens center to
The formula for picture size and projection distance L1 (ft)= L2 (ft)= H (in) =
Focus ring
(0.0311X – 0.0676) / 0.3048 (0.0248X – 0.0693) / 0.3048 (0.1504X – 0.0328) / 2.54
the bottom of the image (in)
(0.0339X – 0.0669) / 0.3048 (0.027X – 0.0683) / 0.3048 (– 0.0424X + 0.0079) / 2.54
Note
There is error of ±3% in the formula above.
Values with a minus(–) sign indicate the distance of the lens center below the bottom of screen.
-3
Handling Precautions
Do not disassemble this lens.
Please refer to your authorized dealer for any maintenance and inspections requiring an open cabinet.
Except for the lens fastener ring, touching any other internal part could cause personal injury or machine malfunction.
Do not touch any glass or protruding part of the lens. This may cause personal injury and reduced performance of the projector.
When maintaining the projector the following points should be noted.
When cleaning the lens be sure to use a commercial air blower or lens cleaning paper (used
in cleaning glasses and cameras).
The surface of the lens is very delicate. Do not allow hard objects to bump or rub against it.
Supplied Accessories
1 lens cover stick 1 lock release strap
Installation Manual (this manual)
Projector and Lens Dimensions
ø107
Specifications
Product type Wide-zoom lens for LCD projector Model AN-C12MZ Type of lens Zoom lens Picture size (diagonal) 30'' to 300'' Focal length 24.5 to 30.7 mm (15/16'' to 13/16'') F no. 2.2 to 2.7 Throw ratio 1:1.18 to 1.48 Weight 1,520g (3.35 lbs) Dimensions ø107 × 202 mm (7
377.3 - 379.3 (147/8" - 1415/16")
15
Unité : mm (pouces)
/16'')
-4
SHARP CORPORATION
Printed in Japan Gedrukt in Japan Imprimé au Japon Improso en Japón
02P07-JM
Loading...