Sharp 32K-S400, 36K-S400 Schematic
32K-S400, CK32S40
36K-S400, CK36S40
SERVICE MANUAL
S28L932K-S400
COLOR TELEVISION
Chassis No. SN-82
32K-S400, CK32S40
MODELS
In the interests of user-safety (Required by safety regulations in some countries) the set should be restored to its
original condition and only parts identical to those specified should be used.
36K-S400, CK36S40
CONTENTS
Page
» ELECTRICAL SPECIFICATIONS........................................................................................................... 1
» IMPORTANT SERVICE SAFETY PRECAUTION ..................................................................................2
» LOCATION OF USER'S CONTROL....................................................................................................... 6
» INSTALLATION AND SERVICE INSTRUCTIONS ................................................................................. 7
» CHASSIS LAYOUT .............................................................................................................................. 13
» BLOCK DIAGRAM ............................................................................................................................... 14
» SCHEMATIC DIAGRAMS .................................................................................................................... 15
» PRINTED WIRING BOARD ASSEMBLIES.......................................................................................... 27
» REPLACEMENT PARTS LIST ............................................................................................................. 33
» PACKING OF THE SET ....................................................................................................................... 46
ELECTRICAL SPECIFICATIONS
POWER INPUT .................................................... 120V AC 60 Hz
POWER RATING
32K-S400, CK32S40 ......................................................... 140W
36K-S400, CK36S40 ......................................................... 165W
PICTURE SIZE
32K-S400, CK32S40 ............................... 3,073cm2 (476sq inch)
36K-S400, CK36S40 ............................... 3,905cm2 (605sq inch)
CONVERGENCE............................................................. Magnetic
SWEEP DEFLECTION .....................................................Magnetic
FOCUS ............................................... Hi-Bi-Potential Electrostatic
INTERMEDIATE FREQUENCIES
Picture IF Carrier Frequency ..................................... 45.75 MHz
Sound IF Carrier Frequency ...................................... 41.25 MHz
Color Sub-Carrier Frequency..................................... 42.17 MHz
(Nominal)
AUDIO POWER
OUTPUT RATING.............. 2.5W + 2.5W (at 10% distortion and
Dual CH Operate)
SPEAKER
SIZE ............................................................12 cm x 6 cm (2pcs)
VOICE COIL IMPEDANCE............................... 8 ohm at 400 Hz
ANTENNA INPUT IMPEDANCE
VHF/UHF .................................................... 75 ohm Unbalanced
TUNING RANGES
VHF-Channels .............................................................. 2 thru 13
UHF-Channels ............................................................14 thru 69
CATV Channels ..........................................................1 thru 125
(EIA, Channel Plan U.S.A.)
Specifications are subject to change without
prior notice.
SHARP CORPORATION
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
1
32K-S400, CK32S40
36K-S400, CK36S40
32K-S400, CK32S40
36K-S400, CK36S40
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
H
1. The unit of resistance "ohm" is omitted.
(K=kΩ=1000Ω, M=MΩ)
2. All resistors are 1/8 watt, unless otherwise noted.
3. All capacitors are µ F, unless otherwise noted.
(P=pF=µµF)
4. (G) indicates ±2% tolerance may be used.
5. indicates line isolated ground.
G
6. indicates hot ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
F
2. All voltages measured with 1000µ V B & W or Color
signal.
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2.
indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å
AND SHADED ( ) COMPONENTS
= SAFETY RELATED PARTS.
'
MARK= X-RAY RELATED PARTS.
DRGANNES MARQUES å ET HACHRES ( ):
PIECES RELATIVES A LA SECURITE.
MARQUE ' : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
SCHEMATIC DIAGRAM: CRT Unit
MODELS 32K-S400, CK32S40
H
G
F
E
E
WA VE FORMS
MODELS 36K-S400, CK36S40
D
C
B
D
C
B
A
123456789101112
A
1 23456
15 16
Loading...