REACH ANYWHERE |
STORE ANYWHERE |
Press the MultiFLEX® Lock Release |
Press the MultiFLEX Lock Release button |
button to lower the angle of the |
and fold the handheld vacuum forward. |
wand to increase your reach. |
To vacuum, lift up the handheld vacuum, |
|
|
|
until the wand locks in place. |
MultiFLEX
Lock Release
Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
POWERFINS
DuoClean® PowerFins Cordless Vacuum with Self-Cleaning Brushroll
EMPTYING THE DUST CUP
1.To empty dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.
2.Position dust cup over a trash bin and slide the lid release button forward.
Dust Cup
Release Button
Wand Release
Button
QUICK
START
GUIDE
For questions, visit us online at sharkclean.com
©2020 SharkNinja Operating LLC. |
|
|
DUOCLEAN, MULTIFLEX, and SHARK are registered trademarks of SharkNinja Operating LLC. |
|
IZ462H |
VERTEX is a trademark of SharkNinja Operating LLC. |
IZ462H_QSG_MP_Mv2 |
WHAT’S INSIDE: |
ASSEMBLY |
A Handheld Vacuum |
|
B MultiFLEX® Wand |
A |
CDuoClean® PowerFins Floor Nozzle
DCrevice Tool
E Pet Multi-Tool
F Anti-Allergen Brush
G Lithium-Ion Battery (Pre-Installed)
H Charger
I HEPA Post-Motor Filter (Pre-Installed)
D |
E |
F |
|
|
B |
|
|
2 |
|
|
(Click) |
G H I
|
1 |
C |
(Click) |
For additional parts and accessories, visit sharkclean.com
POWER SETTINGS
OFF
Slide switch to the top to turn off power. To begin vacuuming, slide switch to the appropriate setting.
HARD FLOOR |
CARPET SETTING |
BOOST MODE |
|
SETTING |
|||
|
|
||
Slide switch to the |
Slide switch to the |
For an added boost in |
|
middle. The brushrolls |
bottom. The brushrolls |
power, pull the Trigger |
|
spin slowly to clean |
spin faster to pick up |
on the handheld vacuum. |
|
hard floors and low-pile |
debris below the surface |
Release it to return to |
|
area rugs. |
of your carpets. |
standard power. |
LITHIUM-ION POWER PACK
In Use
Full |
Mid |
Low |
Nearly |
No |
Charge |
Charge |
Charge |
Empty |
Charge |
Charging |
|
|
|
|
Low |
Mid |
Nearly |
Full |
|
Charge |
Charge |
Full |
Charge |
|
NOTE: Full charge takes approximately 3 hours.
Battery Indicator Lights
NOTE: The Lithium-Ion Power Pack battery comes partially charged. Charge fully before first use, then run the battery down until it is completely out of power. This will condition the battery so the LED indicators will work properly.
|
CHARGING |
IN THE VACUUM: MULTIFLEX® WAND |
OUT OF THE VACUUM |
To put the vacuum in storage mode, press the MultiFLEX |
To remove the battery, press the Battery Release |
Lock Release button while folding the handheld vacuum |
button and slide out the battery. Plug the charger |
forward until the wand clicks and locks. Plug the charger |
into the charging port on the battery. |
into the charging port on the battery. |
|