Shark V1950Q User Manual

Cordless Sweeper

Barredora Electrónica

Model/Modelo: V1950Q

7.2 Volt DC – 7,2 Voltios CC

To Maximize the life of your NiCd batteries:

1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce the product’s battery life significantly.

2. Do not store unit with the charging adapter attached and plugged in.

3. Only recharge when the batteries are fully discharged (or as close to fully discharged as possible).

4. Do not store in areas of high temperature or humidity.

5. After 3 months of non-use, the product should be fully discharged and then recharged to maximize battery power.

6. Use only the charger supplied with the product. If other chargers are used, the batteries can fail causing damage to the battery, product, or personal property.

NiCd batteries have a long useful life but at some time they will need to be replaced. To purchase replacement batteries,

call Customer service at 1 (800) 798-7398. Note: 1. The On/Off switch must be in the “Off” position in

order to charge the unit. If the charging indicator does not light, depress the On/Off switch once.

2. If the product has never been used or has been stored for an extended period of time without use – it will take several complete charge and discharge

IMPORTANT

EURO-PRO Operating LLC

Boston, MA 02465

Tel. : 1 (800) 798-7398

cycles to realize the full opera t ional time of your product.

IMPORTANT SAFEGUARDS

READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS SWEEPER.

When using an electrical appliance, basic safety precautions should always be observed, including the following:

WARNING: To reduce the risk of fire, electrical shock, or injury:

1. Do not charge this unit outdoors.

2. Do not use outdoors or on wet surfaces.

3. Do not allow to be used as a toy. Close attention is necessary when used by or near children.

4. Use only as described in this manual. Use only manufacturer’s recommended attachments.

5. Do not use with damaged cord or plug. Do not use cordless sweeper if it has been dropped, damaged, left outdoors, or dropped in water. Return it to EURO- PRO Operating LLC for examination, repair or adjustment.

6. Do not abuse the charger cord. Never carry the charger or base by the cord or yank to disconnect from an outlet; instead grasp the charger and pull to disconnect.

7. Keep charger cord away from heated surfaces.

8. This product includes rechargeable nickel cadmium batteries. Batteries must be recycled or disposed of properly. Do not incinerate batteries or expose to high temperatures, as they may explode.

9. Do not handle plug or appliance with wet hands.

10. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.

11. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.

12. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

13. Do not attempt to change accessories while unit is running.

14. Use extra care when cleaning on stairs.

15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.

16. Read and follow all label, operational and marking instructions.

17. Do not use charger with an extension cord. Plug charger directly into an electrical outlet. Use charger only in a standard (120V., 60Hz) electrical outlet.

18. Do not use the cordless sweeper without dust container in place.

19. Store the cordless sweeper indoors. Store after use to prevent accidents.

20. Leaks from battery cells can occur under extreme conditions. If the liquid, which is 20-35% solution of potassium hydroxide, gets on the skin – wash immediately with soap and water or neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes and seek medical attention.

21. Use only on dry, indoor surfaces.

22. Do not use for any purpose ot her than described in this user’s guide.

23. Do not attempt to use the charger with any other product or attempt to charge this product with another charger. Use only charger model Kuantech

KA12D120015023U supplied with this appliance.

24. The appliance must be disconnected from the supply when removing the battery.

SAVE THESE INSTRUCTIONS

PARTS AND COMPONENTS

1. Handle Release

2. Upper Handle

3. Folding Pivot

4. No Touch Empty Button

5. Charging Light Indicator

6. On/Off Switch

7. Charging Adapter: Only Use Kuantech KA12D120015023U

8. Charging Jack

9. Transparent Brush Cover

10. Rotating Brush

11. Edging Tool

12. Gear Box

13. Sweeper Power Head

14. Dust Cup Container

15. Speed Indicator Lights

16. Speed Control

17. Dust Container Release Lever

12 11

* Illustrations may differ from actual product.

NOTE: The cordless sweeper is shipped with the batteries uncharged.

Charging of the unit for 20 hours prior to first use is required. Use replacement battery # XB1918 only.

FOR HOUSEHOLD USE ONLY

1 Rev. 09/08

OPERATING INSTRUCTIONS

Assembling Your Cordless Sweeper

Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing. (Pg. 2) This will help you in the assembly and operation of your cordless sweeper.

Note: The charging adapter will be shipped inside the packaging.

1. To assemble your sweeper, push the handle into the base. It will snap into place firmly. (Fig. 1)

Fig. 1 Fig. 2

2. To straighten the handle, simply lift the upper handle. The forward folding pivot will click into the straightened position as shown in Figure 2.

3. To fold the handle, press on the handle release button firmly while bending the handle forward. The forward folding pivot will click into the bent position as shown in Figure 3.

Charging Instructions

1. Connect the charger plug to the charging jack or hole on the side of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger

Kuantech KA12D120015023U. (Fig. 4)

Charging

Light

Indicator

Fig. 4

2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must be charged for a minimum 20 hours.

Important: After initial charging, your new cordless sweeper should not be left

connected to the charging adapter for a period in excess of 24 hours. A normal charge cycle is approximately 12 hours. The manufacturer recommends that when charging the cordless sweeper, the unit be allowed to charge for approximately 12 hours and then be disconnected from the charging adapter. The charging adapter should be unplugged from the wall receptacle and stored in a convenient place until next use.

3. When recharging the unit, the "On/Off" switch must be in the "OFF" position.

4. The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.

5. To recharge, repeat step #1 above. Charging times will vary depending upon the amount of usage between charging cycles.

Note: If, when you place the sweeper to recharge and the charging indicator light does

NOT illuminate, then press the On/Off button once to turn the sweeper off. The

charging indicator light should now light up.

Note: Peak performance may only be realized after the unit has been charged and

discharged two (2) or three (3) times.

Important: To maintain peak performance of your cordless sweeper, it is

recommended that the unit be fully discharged, then completely re-charged at least once a month.

Caution:

• Use only the adaptor supplied with the sweeper.

• Do not clean the sweeper while unit is charging.

• Do not attempt to remove the battery pack from the unit to charge it.

• Never attempt to throw the battery pack or unit into a fire or incinerate it.

• Do not attempt to remove or damage the battery casing.

Fig. 3

OPERATING INSTRUCTIONS

To Maximize The Life Of Your Ni-Cd Batteries

1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce the product’s battery life significantly.

2. Do not store the unit with the charging adaptor attached and plugged in.

3. Only recharge when the batteries are fully discharged (or as close to fully discharged as possible).

4. Do not store in areas of high temperature or humidity.

5. After three (3) months of storage, the product should be fully discharged and then recharged to maximize battery power.

6. Use only the charger supplied with the product. If other chargers are us ed, the batteries can fail causing damage to the battery, product or personal property.

7. Ni-Cd batteries have a long useful life but at some time they will need to be replaced. To purchase replacement batteries and parts call Customer service at 1 (800) 79-7398.

Note: If the product has never been used or has been stored for an extended period of

time without use – it will take several complete charge and discharge cycles to realize the full operational time of your product.

Battery Removal & Di sposal Note: If uncertain as to how to remove your battery pack, we suggest you take your

sweeper to a reputable small appliance service technician to have this service performed.

Follow the steps in “Removal of Battery Pack” when battery removal is required. This sweeper is equipped with Ni-Cd batteries and you need to dispos e of them properly.

When the batteries are no longer good for use, they must be removed from the sweeper for disposal. Do not remove the batteries for any reason other than disposal of them.

Call your nearest recycling center for information on the recycling and disposal of Ni-Cd batteries.

Warning: You must never use ordinary batteries for replacement as these may leak and

cause damage. Use only battery pack XB1918 provided for replacement.

Removal of Battery Pack

1. Press the dust cup release lever with your foot and remove it from the sweeper power head.

2. Turn unit over so that the base is facing upwards. Be careful not to turn the unit “ON”.

3. Push in locking tab and lift off battery compartment cover. (Fig. 5 & 6)

Battery Case Tab

Battery Pack

Compartment Cover

4. Carefully lift out the battery pack and disconnect the wire terminals by pulling apart the wire terminal connectors. Remove the battery pack from the unit. (Fig. 7)

Wire Terminal Connector

Fig. 7

5. Connect the wire terminal connector from the unit to the wire terminal connector of the new battery pack, and replace the battery pack into the unit. Replace the cover and press until it snaps in place.

6. Follow instructions for initial battery charging. Please call customer service at 1 (800) 798-7398 if there are any problems removing batteries.

Do NOT attempt to replace the batteries used in this product with any other type of battery.

Important: This appliance contains Ni-Cd batteries. The batteries m ust be

recycled or disposed of in accordance with local regulations. Please consult your Yellow Pages or local recycling center for more information.

How To Operate Your Cordless Sweeper

1. Before using, please ensure that the cord less sweeper has been initially

charged for 20 hours.

Your cordless sweeper will only operate properly when the batteries are fully charged. Your sweeper will operate for varying lengths of time on a full charge. This will depend upon the type of surface being cleaned. (Longer operating time on bare floors vs. carpets.)

2. Push the On/Off switch to operate the unit. To turn off, press switch again. (Fig. 8)

"On/Off“ switch

Fig. 8

Fig. 5

Fig. 6

+ 9 hidden pages