Shark ION F80 Cord-Free MultiFLEX UF280 Series, ION F80 Cord-Free MultiFLEX IF280 Series Owner's Manual
TM/MC
ION
Cord-Free MultiFLEX
Sans Cordon, MultiFLEX
Sin Cable, MultiFLEX
Série/Serie
F80
TM
MC
MC
IF280/UF280
Series
OWNER'S GUIDE
GUIDE D’UTILISATION
MANUAL DEL PROPIETARIO
IMPORTANT SAFETY INSTRUCTIONS
FOR HOUSEHOLD USE ONLY • PLEASE READ CAREFULLY BEFORE USE
If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. DO NOT force into outlet or try to modify to fit.
WARNING
To reduce the risk of fire, electric shock, injury, or property damage:
THE DUOCLEAN® FLOOR NOZZLE, WAND,
AND HANDVAC CONTAIN ELECTRICAL
CONNECTIONS:
1. This vacuum consists of a motorized nozzle,
wand, and handvac. These components contain
electrical connections, electrical wiring, and
QUICK
moving parts that potentially present risk to
the us er.
2. Before each use, carefully inspect all parts for
START
any damage. If a part is damaged, discontinue
use.
GUIDE
3. Use only identical replacement parts.
4. This vacuum contains no serviceable parts.
5. Use only as described in this manual.
DO NOT use the vacuum for any purpose other
than those described in this manual.
6. With the exception of filters, DO NOT
expose any parts of the vacuum to water
or other liquids.
GENERAL USE
7. This vacuum is not intended for use by anyone
with reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have been
given supervision or instruction concerning
use of the appliance by a person responsible
for their safety. Children should be supervised
to ensure that they do not play with the
vacuum.
8. Always turn o the vacuum before connecting
or disconnecting any current carrying hoses,
motorized nozzles, chargers, batteries, or other
electrical or mechanical parts.
9. DO NOT handle plug or vacuum with
wet hands.
10. DO NOT use without dust cup, filters, and
brushrolls in place.
11. Only use Shark® branded filters and
accessories. Failure to do so will void
the warranty.
12. DO NOT put any objects into nozzle or
accessory openings. DO NOT use with any
opening blocked; keep free of dust, lint, hair,
and anything that may reduce airflow.
13. DO NOT use if nozzle or accessory airflow
is restricted. If the air paths or the motorized
floor nozzle become blocked, turn the vacuum
o and remove the battery. Remove all
obstructions before you reinsert the battery
and turn on the unit again.
14. Keep nozzle and all vacuum openings away
from hair, face, fingers, uncovered feet, or
loose clothing.
15. DO NOT use if vacuum is not working as
it should, or has been dropped, damaged,
left outdoors, or dropped into water.
16. Use extra care when cleaning on stairs.
17. DO NOT leave the vacuum unattended while
powered on.
18. When powered on, keep the vacuum moving
over the carpet surface at all times to avoid
damaging the carpet fibers.
19. DO NOT place vacuum on unstable surfaces
such as chairs or tables.
20. DO NOT use to pick up:
a) Liquids
b) Large objects
c) Hard or sharp objects (glass, nails, screws,
or coins)
d) Large quantities of dust (including drywall,
fireplace ash, or embers).
DO NOT use as an attachment to power
tools for dust collection.
e) Smoking or burning objects (hot coals,
cigarette butts, or matches)
f) Flammable or combustible materials (lighter
fluid, gasoline, or kerosene)
g) Toxic materials (chlorine bleach, ammonia,
or drain cleaner)
21. DO NOT use in the following areas:
a) Poorly lit areas
b) Wet or damp surfaces
c) Outdoor areas
d) Spaces that are enclosed and may contain
explosive or toxic fumes or vapors (lighter
fluid, gasoline, kerosene, paint, paint
thinners, mothproofing substances, or
flammable dust)
22. Turn o the vacuum before inserting or
removing the battery, as well as before
plugging in or unplugging the charger.
23. Turn o the vacuum and remove the battery
before any adjustment, cleaning, maintenance
or troubleshooting.
24. During cleaning or routine maintenance, DO
NOT cut anything other than hair, fibers, or
string wrapped around the brushroll.
25. Allow all filters to air-dry completely before
replacing in the vacuum to prevent liquid from
being drawn into electric parts.
26. DO NOT modify or attempt to repair the
vacuum or the battery yourself, except as
indicated in this manual. DO NOT use the
battery or vacuum if it has been modified
or damaged.
BAT TERY PACK
27. The battery is the power source for the
vacuum. Carefully read and follow all charging
instructions.
28. To prevent unintentional starting, ensure the
vacuum is powered o before picking up
or carrying the vacuum. DO NOT carry the
appliance with your finger on the power switch.
®
29. Use only Shark
or YLS0483A-T2880802. Use of incorrect
charger may create a risk of fire when used
with ION Power Pack Battery XBAT200.
30. Keep the battery away from all metal objects
such as paper clips, coins, keys, nails, or
screws. Shorting the battery terminals
increases the risk of fire or burns.
31. Under abusive conditions, liquid may be
ejected from the battery. Avoid contact with
this liquid, as it may cause irritation or burns.
If contact occurs, flush with water. If liquid
contacts eyes, seek medical help.
32. Battery should not be stored at temperatures
below 37.4°F (3°C) or above 104°F (40°C) to
maintain long-term battery life.
33. DO NOT charge battery at temperatures
below 50°F (10°C) or above 104°F (40°C).
34. Store the appliance indoors. DO NOT use
or store it below 37.4°F (3°C). Ensure the
appliance is at room temperature before
operating.
35. DO NOT expose the battery to fire or
temperatures above 265°F (130°C) as it may
cause explosion.
chargers YLS0243A-T288080
SAVE THESE INSTRUCTIONS
sharkclean.comsharkclean.com
3
(Click)
ASSEMBLY
YOUR ION POWER PACK BATTERY
Your ION Power Pack Battery does not come fully charged. Prior to first use, charge completely. During first
use, discharge fully to condition your ION Power Pack Battery. Failure to do so may cause LED indications to
work incorrectly.
RECYCLING THE ION POWER PACK BATTERY
When your ION Power Pack Battery needs to be replaced, dispose of it or recycle it in accordance with local
ordinances or regulations. In some areas, it is illegal to place spent lithium-ion batteries in the trash or in a
municipal solid waste stream. Return spent power packs to an authorized recycling center or to retailer for
recycling. Contact your local recycling center for information on where to drop o the spentpower pack.
RUNTIMES PER FULLY-CHARGED BATTERY
MODE AND SETTINGS ION POWER ION BOOST
HANDVAC ONLY Up to 40 Minutes Up to 12 Minutes
BARE FLOOR (Wand/Nozzle Connected) Up to 32 Minutes Up to 11 Minutes
CARPET (Wand/Nozzle Connected) Up to 26 Minutes Up to 10 Minutes
NOTE: See enclosed Quick Start Guide for number of ION Power Pack batteries included with your vacuum.
LED BATTERY POWER AND CHARGING INDICATORS
2
(Click)
1
(Click)
1. Insert wand into floor nozzle.
2. Insert handheld vacuum into wand.
3. Insert battery into handheld vacuum.
For proper operation, ensure all components are firmly connected.
NOTE: A complete charge takes approximately 3.5 hours. The ION Power Pack, like all lithium-ion products, will naturally
decrease in capacity over time from the 100% capacity of a new battery.
sharkclean.com sharkclean.com
Charging
Low
Charge
Nearly
Full
NOTE: Full charge takes approximately 3.5 hours.
Mid
Charge
Full
Charge
In Use
Full
Charge
Nearly
Empty
Mid
Charge
No
Charge
Low
Charge
CHARGING THE ION POWER PACK BATTERY
ION
SMART RESPONSE™ TECHNOLOGY
USING THE ION POWER PACK CHARGER
OR
OUT OF THE VACUUMIN THE VACUUM
USING THE ION POWER PACK CHARGING DOCK
Surface Settings Power Button Suction Settings
CARPET
For carpets.
FLOOR
For bare floors and
small area rugs.
21
ION POWER
For everyday cleaning.
ION BOOST
1-minute boost of increased
Press for a timed
suction for high-trac
areas and heavy messes.
To use ION BOOST
mode for longer
than 1-minute, you
can re-press the
ION BOOST
button when the
1-minute period ends.
You can end
ION BOOST
mode prior to
the 1-minute
by pressing the
ION BOOST button.
Press and
hold ION BOOST
for manual control
of the mode for as
long as you need it.
Connect ION Power Pack Battery Charger to the
Charging Dock by inserting the charger plug into
the port. Turn plug clockwise to lock.
NOTE: Not all units come with the charging dock. See enclosed Quick Start Guide for your configuration.
Place battery onto dock, then connect charger to
wall outlet.
PLEASE NOTE: Use of ION BOOST Mode will drain your ION Power Pack faster.
NOTE: Select Carpet setting for stuck-on dirt and debris.
NOTE: For deep cleaning pe r ASTM F 608 (embed ded dir t in carpets) please selec t CARPET and ION BOOST settings.
sharkclean.comsharkclean.com
VERSATILE CLEANING
USING THE MULTIFLEXTM WAND
FLOOR MULTIFLEX REACHABOVE FLOOR MULTIFLEX STORAGE
Wand
Release
(Click)
Press the Power button, then choose your Surface
setting and your Suction setting. Place your foot
gently on the floor nozzle and tilt the handle back.
For low furniture, take advantage of the MultiFlex™
wand. See next page.
NOTE: Brushrolls will only engage when the handle is
tilted back.
Press the Wand Release button to disconnect
the handheld vacuum. Attach accessory, then press
the power button.
Stand the vacuum upright. Step on the Floor Nozzle
Release pedal and pull the wand up to disconnect it
from the floor nozzle. Attach accessory, then press
the power button.
Press the MultiFLEX Wand button to position the
wand to a lower angle for ease of use under low
furniture.
Press the MultiFLEX Wand button and hold it
down while folding the handheld vacuum forward.
Use the handle to carry the vacuum.
(Click)
To take the vacuum out of storage mode,
press the MultiFlex
up the handheld vacuum.
TM
Wand button while lifting
NOTE: All accessories are compatible with both the
handvac and the wand.
sharkclean.comsharkclean.com
MAINTAINING YOUR VACUUM
MAINTAINING YOUR VACUUM
EMPTYING THE DUSTCUP
Wand
Release
Disconnect the hand vacuum from the wand.
2
CLEANING THE FILTERS
To clean filters, rinse with water only to prevent damage from cleaning chemicals. Allow all filters to air-dry
completely for at least 24 hours before replacing them in the vacuum to prevent liquid from being drawn
1
into electricparts.
IMPORTANT: DO NOT use soap when cleaning the filters.
FILTER COVER
FILTER
PRE-MOTOR
FILTER
FRAME
POST-MOTOR
FILTER
PRE-MOTOR FILTER POST-MOTOR FILTER
Remove cover and frame. Slide filter o frame.
Rinse with water. Air-dry completely for at least
24 hours before reinserting. Tap o loose dirt
between washes as needed.
Remove cover and filter. Rinse filter with water.
Air-dry completely for at least 24 hours before
reinserting. Tap o loose dirt between washes
as needed.
FILTER
COVER
Press the dust cup Empty button.
NOTE: To order filters and other parts, visit sharkaccessories.com.
sharkclean.comsharkclean.com
MAINTAINING YOUR VACUUM
MAINTAINING YOUR VACUUM
ACCESSING BRUSHROLLS CLEANING BRUSHROLLS
Open the brushroll garage by sliding back the release
buttons. To close, insert the tabs on the lid into the
slots on the nozzle, then press down both sides.
BRUSHROLL
Run scissors along the guide on the brushroll
to remove any string, hair, or debris.
CHECKING FOR BLOCKAGES
Turn o vacuum and remove battery.
Remove the handheld vacuum from the wand
and check all intake openings to the dust cup.
Turn o vacuum and remove battery.
Remove the hand vacuum and floor nozzle from the wand
and check the wand for blockages.
To close the garage door lid, insert the tabs on the
lid into the slots on the nozzle, then press down on
both sides of the lid until it clicks securely into place.
NOTE: If the headlights are flashing, the brushroll
garage lid is not clicked securely into place on both
sides . The lights will flash and the brushrolls will not
spin until both sid es of the lid are securely clicked
into place.
SOFT ROLLER
Pull out roller by the tab. Remove any string, carpet
fibers, or hair, and remove debris from the roller
housing.
water. Air-dry completely for at least 24 hours
before reinserting
Reinsert roller by sliding it into the front of the
floor nozzle until it clicks into place.
Wash the roller as needed, using only
.
Turn o vacuum and remove battery.
Remove the floor nozzle from the wand. Tilt neck of floor
nozzle back to straighten the airway to remove blockages.
sharkclean.comsharkclean.com
Loading...