Shark EP730 User Manual

Cordless Hand Vac

7.2 V DC

Model EP730

USE AND CARE INSTRUCTIONS

For information or assistance:

USA: EURO-PRO Corporation Canada: EURO-PRO Corporation

178 West Service Rd. 4400 Bois Franc
Champlain, NY 12919 St. Laurent, QC H4S 1A7
Tel.: [phone] Tel.: [phone]

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic safety precautions should always be observed,
including the following

READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS HAND VACUUM.

WARNING: To reduce the risk of fire, electrical shock, or injury:

1. Do not charge this unit outdoors.

2. Do not use outdoors or on wet surfaces.

3. Do not allow to be used as a toy. Close attention is necessary when used by or near
children.

4. Use only as described in this manual. Use only manufacturer’s recommended
attachments.

5. Do not use with damaged cord or plug. Do not use cordless hand vacuum if it has
been dropped, damaged, left outdoors, or dropped in water. Return it to EURO-PRO
Corporation for examination, repair or adjustment.

6. Do not abuse the charger cord. Never carry the charger or base by the cord or yank to
disconnect from an outlet; instead grasp the plug and pull to disconnect.

7. Keep charger cord away from heated surfaces.

8. This product includes rechargeable nickel cadmium batteries. These batteries must be
recycled or disposed of properly. Do not incinerate batteries or expose to high
temperatures, as they may explode.

9. Do not handle plug or appliance with wet hands.

10. Do not put any object into openings. Do not use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce air flow.

11. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving
parts.

12. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot
ashes.

13. Do not attempt to change accessories while unit is running.

14. Use extra care when cleaning on stairs.

15. Do not use to pick up flammable or combustible liquids such as gasoline or use in
areas where they may be present.

16. Look on your hand vacuum and follow all label and marking instructions.

17. Do not use charger with an extension cord. Plug charger directly into an electrical
outlet. Use charger only in a standard (120V~, 60Hz) electrical outlet.

18. Do not use the hand vacuum cleaner without dust cup filter in place.

19. Store the cordless vacuum indoors. Put the cordless vacuum away after use to prevent
accidents.

20. Leaks from battery cells can occur under extreme conditions. If the liquid, which is 20­35% solution of potassium hydroxide, gets on the skin - wash immediately with soap
and water or neutralize with a mild acid such as lemon juice or vinegar. If the liquid
gets into the eyes, flush them immediately with clean water for a minimum of 10
minutes and seek medical attention.

21. Use only on dry, indoor surfaces.

22. Do not use for any purpose other than described in this user’s guide.

23. Do not attempt to use the charger with any other product nor attempt to charge this
product with another charger. Use only the charger model AS-123C3 supplied with

this appliance.

24. The battery pack must be removed from the appliance before it is disposed of.

25. The battery pack must be disposed of properly.

SAVE THESE INSTRUCTIONS

www.sharkvac.com

FOR HOUSEHOLD USE ONLY

Rev. 01/02E

Shark

Cordless Hand Vac

Model EP730

7.2 V DC

BEFORE USE

1. This cordless vacuum is powered by rechargeable nickle-cadmium batteries.
Before using the vacuum, charge the vacuum cleaner for a minimum of 16 hours.

NOTE: Ensure that the On/Off Switch (#11) is on the “Off” position before

charging.

2. The normal full charging time for this vacuum is 16-20 hours. The vacuum cleaner
will run for full operation time is it has been fully charged. Do this by running the
vacuum cleaner until it stops, then fully recharge the battery.

3. Store the vacuum cleaner on the charging base when not is use so that it is always
charged and ready to use.

CHARGING YOUR CORDLESS VACUUM

1. Place the charging base (#14) near an electrical power outlet and plug in.

2. Place the unit on the charging base (#14). The charging light indicator (#9) will
shine red to indicate that the vacuum cleaner is properly positioned on t=on the
charging base and that the unit is being charged.

NOTE: Ensure that the On/Off Switch (#11) is on the “Off” position before

charging.

3. Always return the unit to the charging base (#14) immedieately after use so that it
will be ready and fully charged for the next time.

NOTE: Peak performance may only be realized after the unit has been

charged and discharged two (2) or three (3) times.

1. Nozzle

2. Dust Cup Compartment

3. Dust Cup Filter

4. Ventilation Slots

5. Battery

6. Battery Compartment

7. Crevice Tool

8. Dust Cup Release Button

9. Charging Light Indicator

10. 180° Swivel Handle

11. On/Off Switch

12. Lower Housing

13. Charging Plug

14. Charging Base

NOTE: Cordless vacuum Model EP730 is shipped with the

batteries uncharged. Charging of the unit for 16-20
hours prior to first use is required.

1

IMPORTANT: To maintain peak performance of your cordless hand vacuum,

it is recommended that the unit be fully discharged, then
completely re-charged at least once a month.

ASSEMBLY

Note: Dust cup filter (#3) must always be used when operating the hand vacuum.

1. To open the dust cup compartment (#2), push the dust cup release button (#8) and
remove the dust cup compartment (#2).

Verify that the dust cup filter (#3) is inside, then re-attach the dust cup container

(#2) to the hand vacuum.

2. The crevice tool (#7) is located inside the swivel handle (#10). To attach the crevice
tool (#7) to the Hand Vacuum, remove from inside the handle and insert the large end
of the crevice tool into the nozzle (#1).

2

USING YOUR CORDLESS VACUUM BATTERY PACK REPLACEMENT

1. Remove the vacuum cleaner from the charging base (#14).

2. To start the unit, press the On/Off Switch to the On position.

3. To stop the vauum cleaner, press the On/Off Switch to the Off position.

4. The vacuum cleaner is equipped with a 180° Swivel Handle (#10) for convenient
operation.

5. A crevice tool (#7) is provided for cleaning narrow, hard to reach places. This tool is
conveniently stored inside the swivel handle.

IMPORTANT

When the vacuum cleaner is operating, the LED lights up which means

that the battery is low and the unit should be recharged.

CHANGING & CLEANING THE DUST CUP FILTER

To achieve the best performance, empty the dust cup container (# 2 ) and
clean the dust cup filter (# 3 ) after each use.

1. To open the dust cup compartment (#2), press down on the dust cup release
button (#8) and pull out the dust cup compartment (#2).

2. Pull out the dust cup filter (#3).

3. Empty the dust from the dust cup compartment (#2).

4. Rinse the dust cup filter (#3) in cold water, and then wait until it dries completely
before replacing it into the dust cup compartment (#2).

5. Replace the dust cup filter (#3) carefully into the dust cup compartment (#2).
NEVER operate vacuum cleaner without dust cup filter (#3) in place.

6. Attach the dust cup compartment (#2) to the cordless vacuum.

NOTE: It is recommended that the dust cup filter be changed every

three (3) months to ensure peak performance of the unit.

NOTE: If uncertain as to how to change your battery pack,

we suggest you take your vacuum to a reputable
small appliance service technician to have this
service performed.

This vacuum cleaner is equipped with Ni-Cd batteries and you need to dispose of
them properly. When the batteries are no longer good for use, they must be
removed from the vacuum cleaner for disposal. Do not remove the batteries for any
reason other than disposal of them.

The battery pack of your EP730 is replaceable, however care should be taken
when doing so. Follow these steps when replacement is required:

1. Open the battery compartment (#6), by removing the single, Phillips head
screw located at the rear of the unit. NEVER open battery compartment (#6)
except to change the battery when required.

2. Remove battery compartment cover. Set aside battery compartment cover
and screw.

3. Lift out old battery pack and set aside.

4. Carefully detach the two (2) electrical connectors from the battery pack by
pulling straight away from the battery.

5. Re-connect terminals by pushing lead wires onto battery tabs and insert new
battery pack in battery compartment and.

6. Tuck wiring inside battery compartment so that the wiring does not interfere
with the battery compartment cover when it is replaced.

7. Re-install the battery compartment cover ensuring that the locating tabs
engage the body of the unit.

8. Replace the battery compartment cover screw.

CAUTION

• Use only with the battery pack supplied with the unit.

• Do not attempt to remove the battery pack from the unit to charge it.

• Never attempt to throw the battery pack or unit into a fire or incinerate it.

• Do not attempt to remove or damage the battery casing.

• Battery must be recycled or disposed of properly at the end of it's
service life.

WARNING:NEVER use ordinary batteries for replacement, as these

may leak and damage your vacuum cleaner.

CAUTION: The suction hole must be open, free of any obstructions

at all times. Otherwise, the motor will overheat and could
become damaged.

3

CAUTION: NEVER use the unit without the battery compartment cover

in place.

BATTERY DISPOSAL

This vacuum cleaner contains a nickel-cadmium (Ni-Cd) batteries and must
be disposed of properly. Call your nearest recycling center for information on
the recycling and disposal of nickel-cadmium (Ni-Cd) batteries

4

TROUBLESHOOTING GUIDE

TO ORDER REPLACEMENT DUST CUP FILTERS

OR REPLACEMENT BATTERY PACKS

for Model EP730

PROBLEM POSSIBLE REASON POSSIBLE SOLUTION

1. Charge unit.

2. Check fuse or breaker.
Replace fuse/reset

breaker.

3. Call 514-842-8691

1. Empty dust cup container
– (see page 3).

2. Remove dust cup filter
and check for object(s) in
air duct and remove.
Clean or replace dust cup
filter. (see page 3).

3. Charge unit.

1. Empty dust cup container.

2. Review dust cup filter
installation instructions.
(see page 3)

3. Replace dust cup filter.
(see page 3)

HAND VACUUM WILL
NOT OPERATE

HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK

DUST ESCAPING
FROM HAND
VACUUM

1. Batteries discharged.

2. No power in electrical
outlet supplying
transformer.

3. Unit needs servicing.

1. Dust cup container is full.

2. Dust cup filter needs
cleaning.

3. Unit needs recharging.

1. Dust cup container is full.

2. Dust cup filter is not
installed correctly.

3. Puncture/hole in dust cup
filter.

To order, send check, money order or credit card authorization to:

USA: EURO-PRO Corporation Canada: EURO-PRO Corporation

178 West Service Rd. 4400 Bois Franc
Champlain, NY 12919 St. Laurent, QC H4S 1A7

For Customer Service or information, call:

In U.S.: 800-798-7398 In Canada: 800-361-4639

514-842-8691

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

Visit our website at: www.sharkvac.com

Please Note:

The Dust Cup Filter is washable. It should, however, be
replaced every three months to ensure peak performance
of your vacuum.

Important:

Make sure that Dust Cup Filter is completely dry before re­installing back in the hand vacuum.

5

Printed in China

6

Model EP730

ONE (1) YEAR LIMITED WARRANTY

EURO-PRO CORPORATION warrants this product to be free from defects in material and
workmanship for a period of one (1) year from the date of the original purchase, when utilized for
normal household use, subject to the following conditions, exclusions and exceptions.

If your appliance fails to operate properly while in use under normal household conditions within
the warranty period, return the complete appliance and accessories, freight prepaid to

In US: EURO-PRO Corporation, 178 West Service Rd., Champlain, N.Y. 12919
In Canada: EURO-PRO Corporation, 4400 Bois Franc, St. Laurent, QC, H4S 1A7

If the appliance is found by EURO-PRO to be defective in material or workmanship, EURO-PRO
will repair or replace it free of charge. Proof of purchase date and $ 9.95 to cover the cost of return
shipping and handling must be included. *

Non-durable parts including, without limitation, dust cup filters, filters, brushes and electrical parts
which normally require replacement are specifically excluded from warranty.

The liability of EURO-PRO Corporation is limited solely to the cost of the repair or replacement of
the unit at our option. This warranty does not cover normal wear of parts and does not apply to
any unit that has been tampered with or used for commercial purposes. This limited warranty does
not cover damage caused by misuse, abuse, negligent handling or damage due to faulty
packaging or mishandling in transit. This warranty does not cover damage or defects caused by
or resulting from damages from shipping or repairs, service or alterations to the product or any of
its parts, which have been performed by a repair person not authorized by EURO-PRO

This warranty is extended to the original purchaser of the unit and excludes all other legal and/or
conventional warranties. The responsibility of EURO-PRO Corporation if any, is limited to the
specific obligations expressly assumed by it under the terms of the limited warranty. In no event is
EURO-PRO Corporation liable for incidental or consequential damages of any nature whatsoever.
Some states do not permit the exclusion or limitation of incidental or consequential damages, so
the above may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.

*Important: Carefully pack item to avoid damage in shipping. Be sure to include proof of
purchase date and to attach tag to item before packing with your name, complete address
and phone number with a note giving purchase information, model number and what you
believe is the problem with item. We recommend you insure the package (as damage in
shipping is not covered by your warranty). Mark the outside of your package “ATTENTION
CUSTOMER SERVICE”.

.

yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy

yy

OWNERSHIP REGISTRATION CARD

Please fill out and mail the product registration card within ten (10) days of purchase in order to
validate the foregoing Limited Warranty. The registration will enable us to contact you in the
unlikely event of a product safety notification. By returning this card you acknowledge to have read
and understood the instructions for use, and warnings set forth in the accompanying instructions

RETURN TO EURO-PRO CORPORATION, 178 WEST SERVICE RD., CHAMPLAIN, N.Y. 12919
IN CANADA: 4400 BOIS FRANC, ST. LAURENT, QUEBEC, H4S 1A7

EP730

______________________________________________________________________

Appliance model

______________________________________________________________________

Date purchased Name of store

______________________________________________________________________

Owner’s name

______________________________________________________________________

Address City Prov./State Postal code/Zip Code

7

.