SGS TJ3, TJ3X Owner's Manual

FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.

OWNER’S MANUAL

TJ3 HEAVY DUTY
TROLLEY JACK

PAGE 2

OPERATION

The owner is responsible for maintaining all decals and warning labels
and maintaining the unit in good working order. Safety information
should be emphasised and understood prior to usage. This jack shall
be inspected as per the instruction manual before each use.

It is the owner’s/operators’ responsibility to study all warnings, operat­ing and maintenance instructions contained on the product label and
within this instruction manual to ensure proper operation of this jack.
The owner/operator shall retain these product instructions for future
reference.

This jack shall be maintained in accordance with the product instruc­tions. No alterations shall be made to this jack.

INSPECTION

Before each use a visual inspection shall be made for abnormal
conditions such as cracked welds, damaged, bent, worn, loose or
missing parts.

This jack should be inspected immediately if it is believed to have been
subjected to an abnormal load or shock. Owner/operators should be
aware that repair of this jack requires specialised equipment and
knowledge.

SPECIFICATION

MAX CAPACITY 3 TONNE

RETRACTED HEIGHT 145MM

FULLY EXTENDED 520MM

WWW.SGS-ENGINEERING.COM

PAGE 3

RAISING A VEHICLE

1. Make sure the jack and vehicle are on a hard level surface.

2. Always set the vehicle handbrake and chock the wheels.

3. Consult the vehicle owner’s manual to ascertain the location of
jacking points and position the jack beneath the lift point.

4. Turn the handle clockwise to the closed position.

5. To raise the vehicle pump the handle up and down.

6. Place jack stands beneath the vehicle at locations recommended
by the vehicle manufacturer. Do not work under the vehicle
without the use of jack stands. Jacks are not designed to maintain
heavy loads for long periods of time. Do not attempt to place jack
stands simultaneously under both ends of a vehicle or along one
side of a vehicle.

7. Turn the handle slowly counter clockwise to lower the vehicle onto
the jack stands.

LOWERING A VEHICLE

1. Turn the handle clockwise to close the release valve.

2. Pump the handle to lift the vehicle off the jack stands.

3. Remove the jack stands. Do not get under the vehicle while the
vehicle is being lowered.

4. Turn the handle slowly counter clockwise to lower the vehicle onto
the ground.