SGS STCC450 Owner's Manual
STCC450
TOOL CART
OWNER’S MANUAL
FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.
WARNING
OPERATING INSTRUCTIONS
1. Open Lid to unlock Drawers, then fill Cart evenly, from bottom to top.
Do not exceed weight capacities.
Read and understand instructions before use.
2. Close Lid to lock all Drawers, then lock Lid with Key.
3. Unlock Swivel Casters.
Always wear eye/face and hand protection.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If any part becomes
damaged, have the problem corrected before use.
1. DO NOT SIT, STAND OR CLIMB ON THIS ITEM.
2. This product is not a toy nor a toy chest. Do not allow children to play
with or near this item.
3. Do not exceed weight capacities, evenly distributed from bottom up.
Be aware of dynamic loading! Sudden load movement may briefly create excess load causing product failure.
4. Do not open more than one Drawer at once. Lid must be open for
Drawers to be unlocked.
5. Close Lid to lock all Drawers, then lock Lid with Key before moving.
4. Roll Cart to a flat, level, hard and smooth surface capable of safely
supporting a fully loaded Cart. Do not roll Cart over concrete seams or
other rough/uneven surfaces.
5. Lock Swivel Casters.
Drawer Size Weight Capacity
Top Compartment 685mm x 395mm x 50mm 90kg
Top Drawer (x2) 310mm x 370mm x 50mm 13kg each
Middle Drawer 680mm x 370mm x 70mm 22 kg
Bottom Drawer 660mm x 370mm x 100mm 32 kg
Bottom Shelf 770mm x 405mm x 75mm 90kg
Total Combined Weight Capacity
260kg
(Evenly distributed from bottom up.)
6. Use only on a flat, level, hard and smooth surface capable of safely
supporting a fully loaded Cart. Do not roll Cart over concrete seams or
other rough/uneven surfaces
WWW.SGS-ENGINEERING.COM
PAGE 2
PAGE 3
Loading...