SGS STC10T, STC10B Owner's Manual

FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.

OWNER’S MANUAL

STC10T - 9 DRAWER CHEST
STC10B - ROLLER CABINET

WARNING

1. DO NOT stand on this product. You may fall which may cause personal injury.

2. WEAR SAFETY GLASSES AND GLOVES when cutting the banding material. The bands may

snap and cause personal injury.

3. Stacked products should be bolted together. The products could become unstable and tip,

which may cause personal injury or product damage.

4. WEAR SAFETY GLASSES when removing or repositioning the slides.

5. When the cover is opened, be sure the cover stop is in the locked position.

6. BE CAREFUL when closing the cover. Remove hands before the cover closes completely.

7. BE CAREFUL when opening more than one drawer. The product may become unstable and

tip, which may cause personal injury or product damage.

8. DO NOT mount this product on a truck bed or any other moving object.

9. DO NOT step in the drawers. You may fall and cause personal injury.

10. Appropriately secure this product before moving it with a forklift.

11. Close the cover and lock the drawers and doors before moving this product. The drawers or

doors could come open and make the product unstable and tip, which may cause personal

injury or product damage.

12. DO NOT alter this product in any manner. For example, do not weld external Iock bars or

attach electrical equipment. This may cause product damage or personal injury.

13. Remove the work surface, if provided, from the cart before mounting the chest. Failure to do

so may cause the chest to slide off, which may cause personal injury or product damage.

14. WEAR SAFETY GLASSES AND BE CAREFUL when moving the cover rods. The rod could

spring out of the hole and cause personal injury.

15. When locking this product, close the drawers before the cover for Iock bars to work properly.

16. Spread the weight evenly in the tote trays. If the weight is not spread evenly, the contents

could shift and fall out, which may cause personal injury and/or damage to the contents or

tote tray.

REMOVING DRAWERS

1. Ball bearing slides have black retaining clips. To remove the drawer the retaining clips need

to be released by pushing lever up (right hand side of slide) and down (left hand side of

slide) simultaneously, and pulling drawer out. To re-install drawers, simply place drawer onto

slides and push in fully.

FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.