SGS STC1000 Owner's Manual

FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.

OWNER’S MANUAL

STC1000
TOOL CHEST & CABINET

PAGE 3

PAGE 2

ASSEMBLY INSTRUCTIONS

1. REMOVE SIDE PANEL

Remove screws with a screwdriver.

2. REMOVE CHEST
Place cabinet on a level surface. Slowly
remove chest from the cabinet.

3. CASTER ASSEMBLY
If caster assembly is loose, using a screwdriver slightly spread apart the split bearing
on the shaft. If caster is tight, crimp split bearing with pliers. Make only small adjust­ments until caster fits.

WARNING

1. Lubricate the top and the bottom channels of the drawer slides at least twice a year.

2. Do not open more than one loaded drawer at a time.

3. The maximum loading capacity is 70kgs (154 lbs).

DRAWER SLIDERS

If it becomes necessary to remove drawers:

1. Pull drawer all the way out, then push back a fraction of an inch.

2. Insert a screwdriver into slot in the slide and push in on the stop until it clears
the lance. Repeat the procedure on the other slide and remove drawer.

3. To re-install drawer, pry stop far enough out to engage lances (3/16” to 1/4”)
and push drawer onto slide until stops engage lances.

WWW.SGS-ENGINEERING.COM