SFA Sanicom FF03-P95 User Manual

1. Description

Sanicom is a lifting pump for wastewater used in commercial applications (restaurants, hairdressing salons, the catering industry etc.). The unit
operates automatically, has a high performance level, and is safe and reliable, provided all the rules for installation and maintenance in this
notice are strictly followed. Especially those indicated by:

Failure to comply with this instruction could endanger the safety of persons

Indication that a risk of electrical origin exists

Electrical installation must be carried out by a professional electrician.

“Attention” Failure to comply with this instruction could endanger the safe functioning of the apparatus.

2. List of Accessories included

25 x 40

A B C D

E F G H

I

x2

x1 x2 x2

x1

x1 x2 x2

x1

Hose clip

Hose clip

Inlet Cover

Hose clip Screw

Plug

Elbow

Hose clip

Flexible inlet connector

For any additional information, please contact our customer service department.

32 x 50 50 x 70

40 x 60

Please also see “10 golden rules” for correct Saniflo installation on www.saniflo.co.uk

3. Dimensions and overall measurements

4. How it works

The Sanicom contains 1 pump. The tank is equipped with a sensor tube which controls the automatic activation of the motor when waste enters
the unit. As soon as the waste enters the tank, the pump starts.

5. Performance Curve & Height and Length of the discharge pipe

Flow Rate - litre/min

Vertical Height - Metres

0 10 20 30 40 50 60 70 80 90 100 110 120 130 140

12
11
10

9
8
7
6
5
4
3
2
1
0

max 10m

3

7

4m

3m

2m

1m

5m

6m

7m

1%

Max 8m

max 20m

max 30m

max 40m

max 50m

max 60m

max 70m

max 80m

420mm

330mm

490mm

ø 60

230mm

6. Technical Data & Application

7. Installation

FITTING

The Sanicom can be fixed to the floor, preventing it from
turning or moving.

1. Warning: The space in which the Sanicom is installed
must be large enough to leave at least 600mm around
the unit for easy maintenance. This space must be
well lit, ventilated, and must never be immersed in
water and must be protected from frost.

2. Isolation valves should be fitted to the inlet pipework
and discharge pipework to isolate the unit in case of
the need for service.

Application Commercial sink, washing machine,

dishwasher or shower* or bath*

Type FF03-P95

Maximum vertical pumping height 8m

Voltage 220 – 240 V

Frequency 50 Hz

Maximum power consumption 750 W

Maximum current consumption 3.3 A

Electrical class I

Protection index IP44

Max temp with intermittent functioning 80°

Net weight 10 kg

* In the case of bath or shower tray, make sure the waste traps are raised 15cm above floor level.

CAUTION: 1. All applications other than those described in this notice are prohibited.

2. Do not exceed an incoming flow rate greater than 80% of the flow rate stated on the design curve in any of the apparatus.

8. Connection to side inlets

Use the flexible inlet connector (A) for side inlet
connections. Using a metalwork saw, saw off the desired
inlet point, remove any burrs and then fix the flexible
inlet connector with the hose clip (D).

We recommend the installation of a grease trap for
installations with a high grease inflow.

Connection to the inlet can be made using a 40mm or
50mm pipe. To make a 50mm connection, cut off the
end of sleeve (A) beforehand.

H

H

G

G

I

C

A

D