3
5
6
7
8
9
10
11
1
2
3
4
Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label. This product complies with all
binding CE labelling directives.
Familiarisation
1. Adjustment ring for coarse/fine grind
2. Housing
3. Power cord
4. Bean container lid
5. Collection container lid
6. Ground coffee outlet
7. Collection container
8. Operating button
9. Rating label
10. Grinding mechanism
11. Bean container
Important safety instructions
● Before the appliance is used, the main
body including the power cord as well as
any attachment fitted should be checked
thoroughly for any defects. Should the
appliance, for instance, have been
dropped onto a hard surface, it must no
longer be used: even invisible damage
may have adverse effects on the
operational safety of the appliance.
● Do not allow the appliance to touch hot
surfaces (e.g. oven-plates) or to come
into contact with any open heat sources.
● Always remove the plug from the wall
socket
- after use,
- in case of any malfunction, and also
- before opening the bean or collection
container, and also before removing
either from the housing,
- before cleaning the appliance.
● When removing the plug from the wall
socket, never pull on the power cord. Do
not let the power cord hang free.
● This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
● Children should be supervised to ensure
that they do not play with the appliance.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and not for commercial
applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Short-time operation
The appliance has been designed for shortterm operation only, i.e. it should not be
operated continuously for more than 90
seconds. Switch off the appliance afterwards
and allow the motor to cool down (30 Min.)
before switching it on again.
Operation
-
Remove the bean container lid and fill
the container with the desired quantity of
coffee beans (max. 60g) before replacing
the lid. The measure of 60g of coffee
beans is sufficient for about 10 cups of
brewed coffee.
-
The quality of the ground coffee can be
adjusted from fine to coarse by means of
the adjustment ring.
-
Make sure that the collection container
Coffee-Grinder
6
lid is properly fitted before attaching the
container itself to the main unit. The
container must be correctly fitted and
fully locked into place for the built-in
safety switch to operate.
-
Insert the plug into a suitable wall socket.
As soon as the operating button is
pressed, the grinding process begins.
Keep the button pressed until either:
- all beans in the container have been
ground, or
- until the desired quantity of ground
coffee has been produced (or the
“Max.”-marking in the collection
container has been reached),
- or until the appliance has been running
for the maximum operating time of 90
seconds.
-
After grinding, always remove the plug
from the wall socket before removing the
collection container or opening the bean
container lid.
● Note: to ensure optimum coffee flavour,
only the required quantity of beans
should be ground immediately prior to
brewing. Should another grinding cycle
become necessary, however, the
maximum operating time of 90 seconds
must not be exceeded.
General care and cleaning
● Before cleaning the appliance, always
remove the plug from the wall socket and
wait until the motor has come to a
complete standstill.
● To avoid the risk of electric shock, do not
clean the housing or the power cord with
water, and do not immerse them in
water. The housing may be wiped with a
slightly damp, lint-free cloth. Wipe
thoroughly dry afterwards.
-
The grinding mechanism may be opened
up for cleaning, and also in case of a
malfunction.
- Turn clockwise
to open the grinding mechanism
- Turn anti-clockwise
to close the grinding mechanism.
A small, soft brush is suitable for cleaning
the grinding mechanism and the outlet
opening.
-
The collection container and the lids may
be cleaned using hot water and a mild
detergent. Wipe thoroughly dry
afterwards. These parts are not dishwasher safe.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
to repair or replace any parts found to be
defective, providing the product is returned
to one of our authorised service centres. This
guarantee is only valid if the appliance has
been used in accordance with the
instructions, and provided that it has not
been modified, repaired or interfered with
by any unauthorised person, or damaged
through misuse.
This guarantee naturally does not cover
wear and tear, nor breakables such as glass
and ceramic items, bulbs etc. If the product
fails to operate and needs to be returned,
pack it carefully, enclosing your name and
address and the reason for return. If within
the guarantee period, please also provide the
guarantee card and proof of purchase.
7
Loading...