SES imagotag APG2 USB1 A User Manual

Document Title Goes Here

1.

2.

3.

Test setup and specification for certification tests

Description

This page describes the quick-start with a per-defined test setup and how-to run tests with this setup.

FCC: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void
the authority to operate the equipment.

IC: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée
aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout brouillage
radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.

Pr-requisites

Network cable
Local machine (laptop/PC)

Ethernet interface
Administration rights (to change the network settings)
JAVA Runtime Environment ( ), Version 8 or higherJRE

Test setup components

Core appliance 32GB - ID 52675 - 05CAB002303-I200000720
ESL Dongle - ID 50400
AP-2010 - ID TBA
USB pen drive incl. " " softwareControl Center

Initial test setup preparation

Prepare local machine

Change your Ethernet adapter settings
Control Panel - Network Connections
Right click on the desired Ethernet interface and select " "Properties

Page 1

Document Title Goes Here

a.

4.

5.
a.
b.

c.

1.
a.

Select " " and click " "Internet Protocol Version 4 (TCP/IPv4) Properties
Use the following IP address and subnet mask

IP address: 192.168.1.30
Subnet mask: 255.255.255.0

Prepare core appliance, ESL dongle and/or AP-2010

Unpack components

Unpack core appliance, power supply and ESL dongle.

Page 2

1.

b.

2.
a.
b.
c.

Connect components

Network cable Ethernet port " " & Ethernet port of your laptop or PC1
Power jack Power socket " "DC+12V
ESL Dongle USB port " "1

Document Title Goes Here

Page 3

Document Title Goes Here

d.

3.

4.
a.

b.
c.

Power core appliance Power switch " "ON
Copy the following folder from the USB pen drive to your local computer: " "Control_Center

Example local directory: " "C:\ses-imagotag\

Make sure that JAVA is installed on your local machine. (e.g.: Open a windows command prompt and execute "java

" command)-version

Page 4