Servend CEV Installation Manual

11 Part No. 5030476
Revision 0

Carbonator Tank Purge Tube Routing Instructions for CEV Series Units

Routing Instructions

1. During installation of unit the carbonator

tank purge tube (A) must be properly routed
to a drain. Once the splash panel has been
removed from unit remove twist tie (B) that
holds carbonator tank purge tube (See Figure

1).

2. Route carbonator tank purge tube (A) down

front of unit and behind drain pan (See
Figure 2). Be sure not to collapse or kink
carbonator tank purge tube during routing

Figure 1

from unit to drain.

3. The carbonator tank purge tube (A) can be

routed down through the counter top that unit
has been installed on or out the rear of unit.
Then install carbonator tank purge tube to a
drain (See Figure 3). Follow all local and
national plumbing codes when routing
carbonator tank purge tube to the drain.

Purge tube is connected to

Figure 2

the pressure relief valve on
carbonator tank and must
be routed to a drain

Figure 3